Question about 2000 Buick Century

Open Question

Any vidoes on how to rppace this switch for a 2000 buick century 3.1

Posted by on

  • 1 more comment 
  • larry russell
    larry russell Dec 08, 2016

    Replace* or any instructions

  • yadayada
    yadayada Dec 08, 2016

    What switch do you want to know about? Is that the ignition starter switch?

  • larry russell
    larry russell Dec 08, 2016

    Starter switch the pic is on the post

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jeffk14
  • 16 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

TRY THIS. Good luck!

Posted on Nov 22, 2008

Papa Chan
  • 56 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Posted on Jan 04, 2009

  • 191 Answers

SOURCE: odometer light out on buick century not working

Sadly no, there is no fuse or bulb to replace. You either have to send the instrument cluster out for repair or replace it with a new unit from the dealer. You could also obtain a serviceable one from a salvage yard. Most shops should be able to replace the instrument cluster or advise who can repair it.

Posted on May 08, 2009

  • 468 Answers

SOURCE: 2000 Buick Century gas gauge reads full all the time

You're either looking at a short in the wire that goes to the fuel sender, or a bad fuel sender. If it was just a broken wire, it would read empty instead. The fuel sender is a permanent part of the fuel pump, so that has to be replaced as a unit.

Posted on Oct 20, 2009

  • 634 Answers

SOURCE: How do I replace the dimmer switch on a 2000 Buick

there are star or Philips screws on under column and you remove these to open column shell and parts and schematics can be found at http://www.rockauto.com/

Posted on Oct 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buick century 2000 3.1 ..changed the key cylinder and the switch now the security light staying on causing to car to not crank what can the be?


you have changed the immobilizer program with the new switch
you need to have the key and switch reprogrammed to get the immobilizer to operate

Dec 17, 2016 | 2000 Buick Century

1 Answer

Changing the cabin filter on 2001 Buick Regal


The filter is the same in the Buick Century, so please watch the vido of the Centure to understand how to replace the Regal filter. Cabin Filter Replacement Buick Century 1997 2005 2004 Buick Century Custom...

Oct 02, 2016 | 2001 Buick Regal

2 Answers

How much should it cost to change the spark plugs, wires and air filter on 2000 Buick Century?


Quality wires, iridium plugs and air filter , close to $100 for parts. You doing it yourself will save a lot on labor . 3800 V6 ?

Jan 29, 2016 | 2000 Buick Century

1 Answer

2000 buick century no reverse lights


Check the following:-
the fuse
the wires on the switch on the transmission
the switch, remove the wires and touch them together (with the ignition on), if the lights come on the switch is faulty and needs to be replaced.

Mar 04, 2011 | 2000 Buick Century

1 Answer

2000 Buick Century. Blower quit working for


I had the same problem. It turned out to be the ignition switch. i have no idea how that is connected to the fan but... it worked, got me my fan speeds back, although it is not working again...

Jul 16, 2010 | 2000 Buick Century

1 Answer

Daytime running lights off


there is usually a sensor on the dash probaly in the defrost vent

Apr 13, 2010 | 2000 Buick Century

1 Answer

How do I replace the dimmer switch on a 2000 Buick


there are star or Philips screws on under column and you remove these to open column shell and parts and schematics can be found at http://www.rockauto.com/

Oct 30, 2009 | 2000 Buick Century

2 Answers

Traction is off on my 2000 buick century custom?


should be left side of dash marked ATC maybe??? or traction???

Oct 17, 2009 | 2000 Buick Century

1 Answer

2000 buick century the wipers land wrong


i'm guessing that your question is more or less the same for your question about the wipers staying in the out wipe position when you turn them off?

i guess click HERE for the solution (although i'm sure you already know) :)

Sep 26, 2009 | 2000 Buick Century

Not finding what you are looking for?
2000 Buick Century Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...