Question about Cars & Trucks

Open Question

Have a 50lt.LED set from last year. plugged it in today & it does not workchecked the fuses ,they appear OK Code on box MTP---LED DEL 33515

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater fan will not run all fuses & relays ok. discounted power plug reconnected works ok left over night will not run,


Fan motor bearings gummed up or bad. When you disconnected power plug may have bumped fan enough to jar in into working. Probably must replace motor.

Feb 15, 2015 | 2002 Mercury Sable

1 Answer

What is the power source for the auto dimming mirror with compass and temp?


appear means zero.
fuse that look bad are, fuse that look good can in fact be bad
so all techs, know that and use a voltmeter that never lies.
keyon, both sides fuse are 12v, if one side is 0v its bad fuse.
can i presume you looked in all up to 3 fuse boxes, ?
the operators guide, at least shows them all, l did read your book?
in the glove box it is.
http://www.helminc.com/helm/Result.asp?Style=helm&Mfg=TMS&Make=TOY&Model=SIEN&Year=2001&Category=&Keyword=&Module=&selected_media=
that is how you do that; if not wanting to do that, then you must spend money, called the FSM , alldata.com
alldata, shows the schematic and every single load on all fuses in car. solving this riddle.,
in under 5min i can measure every fuse in car.
no books, nada, just a $10 walfart meter. (or better)

Oct 19, 2014 | 2001 Toyota Sienna

1 Answer

Code p1860 on a 2001 Deville? How do I fix it?


thats a trans fault check trans fuse under hood fuse box 10 amp fuse if ok you have a bad shift solenoid or wireing harness check all wires and plugs

Sep 26, 2013 | 2001 Cadillac DeVille

2 Answers

What is problem if previa wont start but turns over


You need spark to the plugs, fuel to the injectors, and normal compression. One of the three is missing.

Jan 30, 2013 | 1991 Toyota Previa

2 Answers

My CRX roof wont go up and down with the switch on the dash, yet the boot lid goes up with the key, cheecked fuses ok, cheecked plug and control box fault LED flashed seven times and then later on flashed...


7 blinks (roof lock switch,not operated by user)
9 blinks (rear window switch not operated by user)
These codes mean user has not undone roof locks or rear window is not fully closed
Providing that is not your problem,reset roof control unit
Turn ignition off
In under bonnet fuse box remove fuse 32 7.5 amp for 20 seconds
Refit fuse and check roof operation
This clears codes and resets roof

Apr 11, 2010 | Honda del Sol Cars & Trucks

1 Answer

1997 Isuzu rodeo radio and interior lights problem


I had the same problem today and checked all the fuses that I thought might be related to the ignition or radio. All of them looked fine, so I finally went through and checked all of the fuses. The culprit ended up being the 10 amp fuse in the interior fuse box. The owner's manual lists this one as the "Room" fuse, which I guess might translate to "cabin." In any case, everything is working fine after I replaced the blown 10 amp fuse with the spare from the fuse box.

Mar 14, 2009 | 1997 Isuzu Rodeo

1 Answer

Wire color scheme for alternator plug.


ok ric , now the tensioner , notice a 15mm bolt head on the tensioner pulley , put a wrench on that 15mm head and turn clockwise , that will unload the tensioner , install your belt according to the belt wrap picture under the hood , release tensioner , and you should be good to go . however ,,,,,
last thing , there are like 5 fuses involved in this circuit , 1.) a 120 amp fuse in the fuse block , left side of engine compartment , 2.) a 60 amp fuse in the same place as #1 , 3.) a 7.5 amp fuse in the relay box - left side of engine compartment , 4.) a 7.5 amp in the left side of dash fuse panel , and 5.) another 7.5 amp fuse in the same panel as #4 . sure is a very well protected circuit ..

good job

J5

Jan 18, 2009 | 1992 Lexus Sc 300

1 Answer

No SPARK, checked voltages at ICU and impedence at coil. Both were ok, so based on manual, replaced ICU. Still no spark. fuses in main fuse box and under hood checked ok as well.


I had the same problem last week. The coil will still check good but will fail under a load. Remove it from the distributor and you will see a burn mark on it.
This means it was bad and must be replaced.
I hope this work for you.

Jul 30, 2008 | 1994 Honda Civic Del Sol

3 Answers

2006 GMC Sierra 2500HD 4WD trailer light connection fuse blown?


It is in the fuse box under the hood on the drivers side

Jun 27, 2008 | 2006 GMC Sierra 2500HD 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...