Question about Subaru Cars & Trucks

Open Question

Please give me the subaru vivio 1996 model the gasket head tighting specifications

Posted by on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 77932 Answers

SOURCE: please give me gasket head tighting torque for subaru vivio 1994 model

Posted on Dec 08, 2016


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1996 subaru legacy outback has started overheating it comes up to temp and stays there for 6-7 miles and then goes up like a rocket. this started when i started using the heat. if I turn off the fan...

i had the same problem with my 1996 subaru legacy grand wagon,which is identical to had a cracked head,the gasket was fine.not cheap to get done but id get it done now before more serious damage is done.

Dec 04, 2010 | 1996 Subaru Legacy

1 Answer

I blew a head gasket because it overheated ,why did it overheat in the first place,is there an issue with the head gasket after 70'000 miles,should this be listed as a normal maintenance issue?

No, head gaskets are meant to last as long as the car. Overheat will warp the head and allow the gasket to fail. Overheat can be caused by a lot of things. We usually start with the thermostat, but it depends on the exact symptoms.

Please see my tip at . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

I can give you more specific steps if you tell me about what happened when it overheated and if the coolant was low, etc.

Oct 19, 2010 | 2005 Honda Civic

1 Answer

Im replacing the head gasket what is the tourq and sequence for instillation

A torque specification is how tight you must make the bolt by using a torque wrench which measures the tightness you apply to the bolt, ensure you are using new head bolts, a reliable torque wrench, clean the threads of the cylinder head (with tap) where head bolts screw into and when installing bolts ensure they are properly lubricated. And the sequence is the order in which you tighten each bolt.

Jun 19, 2010 | 1996 Acura TL Series

2 Answers

Have changed head gasket etc. as thought was that but on start up to flush engine water was pouring straight out sum. nothing looked wrong in head gasket or intake gasket areas.

where is the watter coming out from? did you follow torque sequence / did you have head resurfaced? check block / did you find any thing wrong with the old head gasket? please give more info, so we can give you better assistance , Thank you for using Fixya.

Apr 10, 2010 | 1988 Subaru Justy

1 Answer


I am not specifically familiar with the Subaru but from what you state it clearly sounds like a Head Gasket Failure!
Have you noticed any Steam coming out of the Tailpipe? If so, then you obviously have a Head Gasket Failure. This is very common on vehicles with Aluminum Cylinder Heads and Cast Iron Blocks. The difference in expansion causes a Scrubbing Action on the head Gasket(s) and ultimately after many Heat-Cool cycles the gasket fails. Typically a vehicle 6 years of age will have somewhat over 100K Miles and has seen many Heat-Cool cycles.

Check with your Subaru Dealer to see if there have been any recalls for this problem.

I would strongly suggest taking it to an ASE Certified Mechanic to have it properly diagnosed.

Dec 07, 2009 | 2003 Subaru Baja

1 Answer

Necesito un subaru vivio del 98 -2008

esta paginas para preguntas de reparation de coches,no es para buscas de coches de venta

Nov 12, 2008 | Subaru Baja Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides