Question about 1993 Nissan Altima

Open Question

1993 altima heat or air wont blow. I changed the resistor but no change. what is the problem?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SUL827
  • 93 Answers

SOURCE: water pump on my 1993 nissan altima

No, they are in separate areas.

Posted on Sep 16, 2008

roybob
  • 3 Answers

SOURCE: 2002 nissan altima

One of your vacuum hoses might have a hole or cut and this will not allow the door for the Fan to open. Check all your vacuum hoses at the engine.

Posted on Oct 22, 2008

  • 599 Answers

SOURCE: 1993 nissan altima engine problems

how many miles on engine?
..stop, get quotes for rebuilt complete ../and complete low mileage used motor to compare before spending any more money

Posted on Nov 07, 2008

tommyboinow
  • 324 Answers

SOURCE: NO HEAT IN 2002 ALTIMA

you may need ot do a cooling system flush, go buy a bottle of radiator flush, put it in the radiator when it is cold, run the car for about 15 mins, and go up to the car wash and take the upper rad hose off, and use the power washer to push all of the gunk and anti-freeze through the system. do it until it runs clean.... let the car run for 2 mins with the hose off after flushing and buy straight antifreeze, not 50/50. add it to the radiator, you should have heat.....

If this does not work, then your control unit in your dash may be bad....

Posted on Nov 26, 2008

onyeredson
  • 404 Answers

SOURCE: Nissan Altima no cool air blowing or hot air blowing

Hi!
It appears we have an Air lock scenario and you will need to perform a system Bleed.
Park the vehicle on level ground, when cold remove coolant filler cap, start engine and leave to idle, turn heater on full and blower to max. When engine reaches operating temperature watch and listen near coolant filler, keep clear as gurgling and hopefully a boil over should occur. Top up with very warm coolant and wait as it may do it again.
Check for heat inside vehicle if warm replace coolant cap but keep an eye on temperature gauge as the ~Air lock may have moved on from heater matrix/core so proceedure needs to be carried out again from COLD.

Please press the Blue button to appraise my FREE Efforts, Thank You!
Paul 'W' U.K

Posted on Feb 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fan speed wont change speeds on heat or cold cycles


Sounds like the Blower Motor Resistor. The range from 10 to 75 dollars depending on what kind of vehicle. Pretty easy to change.
Blower Motor Resistor Repair Heater Fan Speed Control Chevy Blazer GMC...

Nov 09, 2014 | Cars & Trucks

1 Answer

No heat in the car


Change back to the correct t-stat, the main air door thermistor that goes from hot to cold is stuck or going bad or some cases the dash temp control is going out.

Dec 02, 2013 | 2005 Nissan Altima

1 Answer

Heater doesnt blow heat and sometimes works but only on high setting


This depends on what type of heat it is and what you are heating. If it is your car's heating then you have to wait for the car to warm up before hot air blows out.---------------------------------------------------------------------------------------
digiprog 3

Jan 10, 2013 | 2005 Pontiac G6

3 Answers

97 Nissan Altima AC/heater fan only works on highest setting


Sounds like the blower resistor module needs to be replaced. Could also be the switch.

Nov 06, 2009 | 1999 Nissan Altima

1 Answer

Cooling system in my 1993 Ford Explorer over heats


change the water pump and check for a blockage in the waterjacket

Mar 09, 2009 | 1993 Ford Explorer Limited

2 Answers

Heat wont blow through heater or defroster vents


Had the same problem. believe it or not i changed the gas cap and got heat all around. something about pressure.

Dec 05, 2008 | 1993 Chevrolet Corsica

1 Answer

2002 Nissan Altima - Heat doesn't get hot and doors get stuck


Did the switch break because it was stuck? If so, then yes, they will have to change actuators and doors. Does the fan work on all speed setting? If so then you do not need a blower resistor. The resistor pack only controls the current flow to change speeds of the fan.

Dec 05, 2008 | 2002 Dodge Dakota Club Cab

3 Answers

Heating Problem w/2000 Plymouth Breeze.


Sounds exactly like what my mom's car was doing as for the blower only working on high. It was the resistor... I assumed it was the climate controls and replaced them but it didn't change anything then i thought that i must be the blower motor and replaced that too but it turned out to be the resistor which is under the dash on the passenger side of the car.

Nov 10, 2008 | 2000 Plymouth Breeze

1 Answer

1993 nissan altima engine problems


how many miles on engine?
..stop, get quotes for rebuilt complete ../and complete low mileage used motor to compare before spending any more money

Nov 07, 2008 | 2002 Nissan Altima

Not finding what you are looking for?
1993 Nissan Altima Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...