Question about Holden Cars & Trucks

Open Question

I have a 1995 Holden sports frontera 4x4 I cannot get my reverse lights to work I have changed the bulbs and fuses can you help please

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: No backup lights. Bulbs are all fine, fuses also.

Hi and welcome to FixYa,

Additionally check the reverse switch and its wiring/connectors. The reverse switch is located at the transmission. This is also part of the neutral start switch assembly. This page would give you additional insight.

Good luck and Thank you for using FixYa.

Pls be informed that due to my current rank and rating, even a Helpful wouldbe detrimental to my status. Should this solution not address yourconcern, it would be appreciated if you could just not rate it at all. Cheers.

Posted on Dec 28, 2008

Ad
chuck943
  • 783 Answers

SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Posted on Apr 02, 2009

co7196
  • 3433 Answers

SOURCE: Brake lights not working

Like for like on the bulbs
chk your brale light switch at pedal arm...... good luck

Posted on May 28, 2009

GasparMacari
  • 166 Answers

SOURCE: Vauxhall/Opel frontera indicators not working

thats a relay thats is not working propperly, must be replaced to fix the problem, just go to your dealiship and ask for a turn indicator relay for your model and ask your part sales man to show you where is located, if not...just follow that click...
have fun

Posted on Aug 21, 2009

  • 1986 Answers

SOURCE: 1997 De Ville Reverse lights do not work

On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Keeps on blowing the fuse on the air con and when that happens the controls in the car for the heater/ac don't work


unplug the wire to the compressor clutch and see if the fuse blows
if not replace the clutch [ack behind the pulley
if it still blows it could be in the ac relay

May 20, 2017 | Holden Cars & Trucks

1 Answer

I want to change the dash board light bulb in my cars but cant find out how to do it or whas bulbs to buy


the bulbs are led and are built into the dash gauge cluster, non replaceable i believe, best bet call dealer and ask for bulbs

Jun 08, 2012 | Cars & Trucks

1 Answer

I have a 95 jeep loredo . reverse light is not working , I checked the bulbs and fuses and they all good, I also change the neutral switch, still han no reverse light, any suggestion?


The neutral switch is so that you can't start your vehicle in a gear (drive, reverse, ect.) your looking to replace the backup lamp switch. Not sure where its located on your jeep but that sounds like the problem. Happy hunting!

Dec 17, 2011 | 1995 Jeep Grand Cherokee

1 Answer

My reverse lights dont work checked fuses and bulbs all good


did you test for power to the bulbs, possibly a bad ground connection for the bulbs, or the selector lever is broken reverse sensor is usually on the trans

Apr 04, 2010 | 2004 Chevrolet Silverado 2500HD

2 Answers

Reverse lights do not work, checked all fuses and the bulbs


Hi sorry to hear you're having problems

Most likely you have lost the connection at the transmission. Please when you do your next oil change just ask the technician to check and be sure the wires are on and tight at the reverse light switch.

Best of it please let me know if this helps.

Gary

Mar 21, 2010 | 1995 Toyota Camry

1 Answer

2003 silverado 1500 p/u my reverse lights are not


2004 silverado 2500hd 4x4 reverse lights not working checked fuse and bulbs what else could it be ?

Mar 19, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

How to fix reverse lights on a 2002 1500 4x4 dodge v8 tried bulbs and fuses wat next...?


There should be a switch on the trans that may have a bad connection or has gone bad. I am guessing your trans (like most) is an automatic.
I see yours is a 4x4. If you have been working on the rig or been out off road, then you may have clipped or bumped a connection.

I'm not sure on this year but it may be a part of the Neutral Safety Switch.

Hope this helps...

Sep 30, 2009 | 1995 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Holden Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you a Holden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...