Question about Toyota Cars & Trucks

Open Question

Hello i have a question about the air flow meter if i cant find one the matches the same as original what type can i substitute from other modle cars or from toyota pls help

Posted by on

  • Joe Lioi
    Joe Lioi Dec 08, 2016

    sorry forgot to mention its a 1996 Toyota Landcrusier 80 series 4.5 PETROL TYPE

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 93 TOYOTA HILUX ( 22RE ) STARTS THEN STALLS AFTER 1-2 MINUTES

Try cleaning the throttle body.Check the air-gap for the pick-up coil inside the distributor assembly(use a brass feeler gauge)
Check valve clearances if needed(possible tight intake valve adj.)
Check base timing(follow instr. via under hood label)
Hope this helps.

Posted on Mar 17, 2009

Ad
junmag
  • 175 Answers

SOURCE: ONLY WORKS WHEN THE AIR FLOW METER IS DISCONNECTED

If you have check engine light, it could be Accelerator position sensor 1, apc 2, tps1, tps,2. If you dont have MIL could be Air flow meter. Also there is actually 3 small filters in the gdi pump not 2.

Posted on May 21, 2009

mrhappyface
  • 205 Answers

SOURCE: air flow meter

air flow meters are expensive i would first replace the coolant temperature sensor

Posted on May 29, 2009

  • 1 Answer

SOURCE: loss of power on megan 1.9 dti 1999

had similar problem easier to replace air mass meter and filter approx £45

Posted on Jul 24, 2009

  • 249 Answers

SOURCE: car FM freq. range chnge for toyota car audio

its because its an import, buy a conversion plate for your dash and a new radio

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Using a meter how do I adjust air flow on 1988 300 ce mercedes


You are not actually adjusting the air flow, just the fuel distributor's response to air flow. This video walks you through how to do that: Duty cycle measurement on Mercedes W124 diagnostic socket faulty control...

Dec 03, 2014 | 1988 Mercedes-Benz 300

1 Answer

I have a 2003 nissan almera can i use an air flow meter from a 2005 model


Well, in a word, maybe!
I am writing too you from the U.S.A., and it appears wee do not import that model here.
Therefore, I could not look up that part.
However, I did look up the air flow meter for American imports, and I found "it looks like you might be able to."
We use "e-bay motors" for used parts.
If you will type that in, check the "Nissan air flow meters" there, and see what you think.
Be blessed.

Feb 22, 2013 | Cars & Trucks

1 Answer

Mass air flow sencer


this is located between the air flow meter and the inlet throttle body and measures the air intake of the engine in order to match it with the correct fuelling

Nov 20, 2012 | 1993 Toyota Pickup

1 Answer

I am having problems with my c200 automatic 1998 model , the acceleration is rather on the too slow side and this was after i took it for the general servicing, i noticed on my DIY attempt that i...


possibly faulty air flow meter, start engine remove wire socket from air flow meter, is it better than before replace air flow meter, is this information helped you?

Sep 17, 2010 | 1998 Mercedes-Benz C-Class

1 Answer

Air flow meter


First of all, I am not convinced the air mass sensor is defective. I am not experienced with that particular car, but with Bosch injection in general, and I believe you should be reading ohms in a dead system, not volts in a live system. I believe the resistance should vary with air flow, or there should be pulses with movement of a flap.

But yes, if the one you have used to work, then it is probably fine. Getting a newer one is likely to be backward compatible, as long as the harness is the same. It is only getting an older one that is risky.

Jul 22, 2010 | 1999 Mercedes-Benz E-Class

1 Answer

Mercedes Benz C-class 180C, the car stops engine each time I break, I have removed the switch connection to the air flow meter and this stops, what is the implication of removing the switch and driving car...


don't drive the car without air flow meter connected because the air flow meter signal very impotent for fuel mixture in combustion chamber, in your car faulty air flow meter replace air flow meter, is this information helped you?

Mar 24, 2010 | 1998 Mercedes-Benz C-Class

2 Answers

Idle and Power Where is the fuel filter?


Fuel filter is inside the gas tank and its built into the fuel pump housing. You need to remove the back seat and get into the tank via access hole under the seat. Than you need to "split" the fuel pump assembly open and get the filter out. Reverse procedure to assemble. Those filters are rated for 105k miles. My 00 Maxima has 167K on it and it runs just fine with the original. As far as the air flow meter , its a pretty common part that fails and that's why 00 Max air flow meter costs only $100 and all others $500 or more. If you replace an air flow meter, make sure that you use a "NISSAN" air filter or YOU WILL BE replacing the air flow meter AGAIN. Also with the new air flow meter the cars ECM/Computer needs to be reprogrammed. As far as plenum gaskets leaking?? unless someone had it apart and didnt put it back together the right way, its "VERY UNLIKELY" for those gaskets to be bad. Totally bullet proof.

Mar 03, 2009 | 2000 Nissan Maxima

1 Answer

2003 chevy silverado runs rich with black smut in tail pipes!


You have upset the air flow meter You need to replace the air box lid.the flow of air past the airflow meter must be comsistant and surge free.the factory match the flow of air to the afm and they are like siamese twins,they are a matched pair.If you return the air box and rest of air intake to factory parts your problem will go away.Im sure these problems began to appear when you started changing parts and cutting holes.Good luck

Oct 17, 2008 | 1999 Chevrolet Silverado 1500

1 Answer

Q45 airflow meter wiring.


That's not going to work. You can't install a air flow meter into a Pulsar from a Q45. Totally different animals. Air flow meters are car specific. I don't think its gonna work, but good luck with that.

Sep 28, 2008 | 1998 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...