Question about 2000 Honda Passport

1 Answer

2000 honda passport it just dyed and is not getting gas

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 2,942 Answers

Hello John Casey,

Free wiring diagrams
and technical service bulletins (TSB)
for popular USA market vehicles... can be found on the
BBB Industries site (below, registration required).

Hope this helps (fuel pumps do just quit).

BBB Industries Premium Alternators Starters Power Steering Products

Posted on Dec 10, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: where is throttle position sensor located on 2000 honda passport

Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.

Posted on Jan 10, 2009

  • 3 Answers

SOURCE: 2000 Honda Passport wont start.

I ended up finding a repair shop here in Cleveland. The problem ended up being a short in the electrical system. My fuse kept blowing. That's why it wouldn't restart. If you decide to take your vehicle to a repair shop, have them check out the electrical system. My problem was found under the drivers side fender. Some of the wires were corroded. Good luck!

Posted on Feb 18, 2009

honeymokey
  • 3113 Answers

SOURCE: Vacuum Leak on a 2000 Honda passport

Replace upper intake gaskets. They are made of metal and plastic. A common problem. Do not remove the very top plenum cover gasket.

Posted on May 10, 2009

  • 218 Answers

SOURCE: diagram for serpitine belt honda passport 2000

There should be a diagram on the front rail ..where you hood latches....unless someone has removed it...if it has been removed ..i'll try to find the diagram for it...i hope this helps...Keith

Posted on Jun 28, 2009

gladys_neal
  • 334 Answers

SOURCE: evaporative emissions leak for 2000 honda Passport

if small leak indicated it is most likely a gas cap

Posted on Nov 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 honda passport with pinging (gas knock


check the intake manifold gaskets for a vacuum leak.

Jun 13, 2012 | 2000 Honda Passport

1 Answer

I need serpentine belt diagram for 2000 honda passport


08f9562.jpg



This is a picture i drew in paint , for the 2001 honda passport belt wrap with a 3.2Liter V6, hope you can use it for the 2000 model.

Sep 01, 2010 | 2000 Honda Passport

1 Answer

Evaporative emissions leak for 2000 honda Passport


if small leak indicated it is most likely a gas cap

Nov 10, 2009 | 1999 Honda Passport

1 Answer

Gas tank


just rip it off and then have a look ,does a proper mechanic have a workshop manual for every car in his head??

Sep 08, 2009 | 2000 Honda Passport

1 Answer

2000 HOnda Passport with rough idle, how do I identigy a vacuum leak or any other problem which might cause a rough idle


you can use propane to find a vacuum leak take a bottle and put a rubber hose on it so you can direct it in specific spots and just let a little gas flow if you find a vacuum leak it will bring the RPM of the motor up slightly do not light the torch just let the gas come out

Apr 24, 2009 | 2000 Honda Passport

1 Answer

Rear axle is bent


Go-To Car-Part.com
http://www.car-part.com/
Type the year (2000), and make (Honda Passport).
Search for Axle Assy Rear
Ignore 4x4 and focus at 4x2.
You must know the ratio - teeth (41/10 teeth, GT5) or (43/10 teeth, S7C)
(3.2L, 6 cyl, disc), 4x2 (drum brakes), 4.10 ratio (41/10 teeth, GT5)
(3.2L, 6 cyl, disc), 4x2 (drum brakes), 4.30 ratio (43/10 teeth, S7C)
1999 - 2002 Isuzu Rodeo - Honda Passport.
You can get an USED one for $600 plus shipping.
Good Luck.

Jan 04, 2009 | 2000 Honda Passport

1 Answer

1994 HONDA PASSPORT 2.4 CRANKS, RUNS 5 SECONDS, THEN DIES


I have a 2000 Honda Passport. Once mine stalled, it would not restart. Sounded as if out of gas. I thought fuel pump. Took it to service station. They found a short in the electrical system. The fuse kept popping. They replaced blown fuse in coil and module. The tested misc wiring in main harness. They found and repaired bad wires in main harness for module and coils in left front inner fender.

Dec 29, 2008 | 2000 Honda Passport

1 Answer

2000 Honda Passport noise


check passenger side tire for any interference.

Nov 13, 2008 | 2000 Honda Passport

Not finding what you are looking for?
2000 Honda Passport Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...