Question about 2010 Dodge Charger

Open Question

I have a 2010 dodge charger and need to know where's my camshaft Position Sensor Located

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Diagram of where a camshaft sensor is on a dodge stratus 2.4L 4 cylinder

2003 model
not confirmed
crank angle sensor might be near the stater motor on the block



Jul 07, 2016 | Dodge Cars & Trucks

1 Answer

Where is camshaft sensor located on 2010 dodge journey?

here is a link that will show you a diagram for the 2010 Dodge Journey 4Cyl.

I hope this helps

Apr 26, 2015 | 2010 Dodge Journey

1 Answer

PO017 code on a dodge journey 2009

P0017 Dodge - Crankshaft-Camshaft Timing Misalignment Bank 1 Sensor 2Possible causes - Engine oil dirty
- Incorrect engine viscosity
- Crankshaft position sensor circuit is open or shorted
- Camshaft position sensor circuit is open or shorted
- Faulty crankshaft position sensor
- Faulty camshaft position sensor
- Timing gear misalign

Nov 13, 2013 | 2010 Dodge Journey SE

1 Answer

Where is the camshaft position sensor on a 1998 Dodge Dakota 5.2L

The camshaft position sensor is located on the distributor for all engines designed for the 1998 Dodge Dakota. Accessing the sensor requires removing the distributor cap and the distributor rotor. The camshaft sensor pigtail comes through the front of the distributor and connects to the engine wiring harness above the intake manifold.

Oct 03, 2012 | Cars & Trucks

1 Answer

Location for camshaft/crankshaft sensor 9-volt supply circuit for a 1992 dodge dynasty 3.3L

The camshaft Position Sensor (CPS) is located on the timing gear cover.

The Crankshaft Position Sensor is located on the transmission bellhousing.

michael_cass_451.jpgHope this was some help to you?

Jul 25, 2011 | 1992 Dodge Dynasty

1 Answer

Where is the camshaft position sensor located in my 06 dodge magnum? And is there anything special i may need to know in order to replace it myself?

The camshaft position sensor, it is on the passenger side in the front on the engine block, it will have a grey connector attached.

To replace:

Disconnect the negative battery cable.
Remove 10mm bolt and remove camshaft sensor.
Unplug sensor, apply dielectric grease to new sensor and plug in, apply a small amount of grease to o-ring, replace into block and tighten bolt.
Reconnect battery cable....that's it, your done.

Thank you for useing FixYa, please take time to rate me.

Jun 29, 2011 | Dodge Magnum Cars & Trucks

4 Answers

Where is the camshaft position sensor located on a 2004 dodge stratus 4 cyl 2.4L engine

the camshaft sensor is mounted on the camshaft housing located on the end of the cylinder head.

Jul 08, 2009 | 2004 Dodge Stratus

Not finding what you are looking for?
2010 Dodge Charger Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides