Question about Cars & Trucks

1 Answer

07 sentra front end vibrates when accelerating above 50 mph but not when coasting at any speed.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 44,448 Answers

Indicates worn cv joints
have the front drive shafts checked by an accredited specialist shop
check for suspension rubbers worn and putting the alignment out under load /acceleration

Posted on Dec 07, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the drive cycle for a 2003 Nissan Sentra SE?


Take extra caution while performing dirve cycles on public roadways. Drive cycles can be difficult to follow under normal driving conditions. Begin by: - Start the engine. Idle the engine in drive for two and a half minutes with the A/C and rear defroster on. - Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle. - Hold at a steady speed of 55 mph for three minutes. - Decelerate (coast down) to 20 mph without braking or depressing the clutch. - Accelerate back to 55 to 60 mph at ¾ throttle. - Hold at a steady speed of 55 to 60 mph for five minutes. - Decelerate (coast down) to a stop without braking. If all other emissions systems are functioning properly, completing the drive cycle above will set the "readiness flags" required to pass the smog check. It will not hurt to perform the drive cycle 2 or 3 times before the smog test.

Oct 06, 2016 | 2003 Nissan Sentra

1 Answer

Driving between 35-50 mile ph truck will start vibrating


There are many stages of vibration. The most common is in the steering and USUALLY a steering dampner will correct this. However, your description is not real defined and until the technician actually experiences it, it cannot be properly diagnosed

Aug 24, 2017 | Chevrolet Blazer Cars & Trucks

1 Answer

2004 accord front end shack under exceleration


try getting motor mounts checked or struts or wheel bearings , start with mounts.

Apr 17, 2013 | 2004 Honda Accord Sedan

2 Answers

Rear end vibrates in 2005 dodge grand caravan


I'd have to check your suspension. You think the tires are ok? Did you try rotating the tires to see if it made any difference?

Dec 25, 2011 | 2005 Dodge Caravan

1 Answer

From a stand still if you accelerate hard vehicle starts vibra


Well, kind of short on description, issues typical in this complaint are misfiring and U joints.

To emininate the engine, does the vibration happen on power braking, without the vehicle moving?

May 24, 2010 | 2000 Chevrolet Blazer

1 Answer

Front End shaking


Most likely with this problem is the front tires. The tires maybe " out of balance " or " out of round " causing the vibration at certain speeds.

Oct 06, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Vibration after 50 mph, and when accelerateing after 50 mph, worse when you accelerate, very little when coasting. but only after 50 mph


Welcome to fixya the best thing to do is check the rims for imperfections and slight bents that causes the vibrations at that speed go to www.collisionrepairadvice.com to get a wheel repair company to look at.

Jul 16, 2009 | 2000 Mitsubishi Galant

3 Answers

Shakes side2side under acceleration at 38-48 mpn only


Talked to Buick/GMC mechanic at the dealership claiming everyone was giving me different answers/things to replace. He said undoubtedly it was cv joint/half shaft. Changed driver's side, that fixed it. Another give away was it wasn't as bad when car was cold, but got worse as it drove a few minutes, i.e. everything got hot, expanded and therefore was looser.

The main clue was it wasn't RPM specific, bearings were okay and I didn't feel it in steering wheel so much as the whole car in a given RPM range despite gear (not the engine or front end of tranny, i.e. torque converter. Rotating tires had no effect.

Aug 04, 2008 | 2000 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...