Question about 2002 Kia Sedona
If there is a housing held with three nuts ,that is where it will be if not there it will be in the top hose end engine side.
Posted on Dec 12, 2016
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: kia sedona 2002 error code P0118
P0118- (ETC) Engine Coolant Tempature sending unit, high input. Your ETC is either faulty or has a poor wiring problem. Thank you for using fixya.com
Posted on Oct 22, 2008
No it not at that housing, Its under the car kinda. If you remove the heat sheild for the exhaust manifold you will be able to see the top of the housing. It connects to the bottom of the water pump housing then to a metal pipe that goes under the oil pan to the lower radiator hose. You will be able to remove the two 8mm headed bolts from the top, then unbolt the stud that holding the metal pipe under the oil pan and then you can get to the t-stat. Lots of work in tight spaces but it is possible to do with out pulling the exhaust manifold or the water pump housing!
Posted on Oct 26, 2009
It is mounted on the tail end of the transmission. It has two wires coming out of it typically.
Posted on Nov 14, 2009
Testimonial: "thank you for help full"
The thermostat is under the alternator.
If you have a memory saver to keep radio & PCM settings, install it now.
Remove negative battery cable from battery. Remove positive cable from alternator and disconnect harness plug from alternator.
Remove accessory belt noting how it is installed for later reinstallation.
Remove engine lifting hook in front of alternator.
Remove (3) bolts holding alternator on.
Drain coolant from radiator (may want to start this as first step as it takes a while). Loosen pressure cap to aid in system draindown.
Remove radiator hose from thermostat housing.
Remove two bolts from housing and remove from engine.
Reinstall is reverse keeping in mind the following:
Cleanliness counts where thermostat housing seals to engine.
Thermostat spring should point into engine.
If the thermostat has a bleed port, it should go to the 12 o'clock position (up).
Posted on Jan 14, 2010
Tips for a great answer:
Mar 18, 2017 | 2005 Kia Sedona
Dec 07, 2016 | Kia Cars & Trucks
Jan 27, 2015 | 2005 Kia Sedona
Sep 17, 2014 | 2002 Kia Sedona
Sep 16, 2012 | Cars & Trucks
Aug 08, 2010 | 2002 Kia Sedona
Jun 07, 2010 | 2002 Kia Sedona
Feb 25, 2010 | 2006 Kia Sedona
52 people viewed this question
Usually answered in minutes!