Question about Audi TT

Open Question

Where is the engine number located on mk1 audi tt

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Audi TT fuse box

It is in the end of the dash board. open the drivers door so you can see the end of the dash and ease the semi circle shaped cover off. There is a fuse pulling tool in there too ;o

Posted on Mar 09, 2009

Ad
  • 102 Answers

SOURCE: engine number location for 2002 audi a4

is it a 1.8 turbo or 2.8 V6 or 2.7 biturbo V6 ? on most models what you will be looking for is a 3 letter code like ATQ or APW and is normally on a sticker on the timing belt cover, it is also stamped into the engine on a ledge up high. if no luck there check the owners manual, around the 3rd page there will be a sticker that was put in the book during predelivery inspection this sticker is about 3 inches by 3 inches and filled with id codes for almost everything. If the pdi wasn't done right another copy of the same sticker will be under or next to the spare tire in the spare tire well.

Posted on Mar 24, 2009

Mechanic65
  • 142 Answers

SOURCE: when I start my 97 audi tt from cold and leave it

Sounds like you have an alternator going bad. not producing enough voltage unless the engine RPMs are higher than Idle.

Posted on Oct 09, 2009

Testimonial: "Thanks for your help, i will look into it. cheers"

TDISLine
  • 1874 Answers

SOURCE: on the Audi TT Mk1 3.2 which is cylinder1

See picture below:

41f185f.jpg

Posted on Mar 17, 2010

  • 1 Answer

SOURCE: Audi TT Mk1 will not start.

Hi, did you sort the problem with your tt? I have exactly the same issue, apx engine, will not start, ecu not readable by vagcom or snapon scantool? Any advice gratefully recieved. Craig.

Posted on Apr 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where i can find Audi TT 2002 starter relay? what name it is and where it is located? thx, Henri


hi starter relay of Audi TT 2002 its located under the carpet where the passenger beside driver all the relay is there

Apr 15, 2017 | Audi Cars & Trucks

Tip

Positioning tailpipes


twisting the centre section on the Milltek exhaust system for the Mk1 Audi TT 1.8T quattro effects the positioning of the tailpipes.

on May 19, 2008 | 2005 Audi TT

1 Answer

Changed batteries in both key fobs and now need fob recoded, how do i do that. audi tt roadster mk1 2002 convertable 18t quattro


Naaah...

Pretty sure you are looking under the wrong rock...

A BATTERY CHANGE should not cause a FOB to fail ..

I'd suggest you take it to the dealer to get it read
for what-ever-else is going on
(wrong CAR perhaps?)

Carnac the Magnificent

Feb 10, 2017 | Audi Cars & Trucks

1 Answer

Where is the location of engine number on an audi tt 2000/2001


Remove engine cover. Front passenger side of engine (left side if you stand in front of the car). 3 letter engine code engraved in the cylinder had.

26389551-gf5p05ipujtt2yk2sdoweh1o-4-0.jpg

26389551-gf5p05ipujtt2yk2sdoweh1o-4-2.jpg

Dec 07, 2016 | 2000 Audi TT

1 Answer

Mk1 Roof goes down but not up


I would try a new relay anyway sometimes they will route the circuit through different points of the relay. I also would check the up/down switch itself to make sure it is working on both sides I had the same problem on a window switch for a car I was working on. Just because one side of the switch works doesn't mean the other side does. If the relay and switch are both good then I would switch the wires on the up/down switch to see if it functions then you are basically checking the continuity of the switch again but this time you will be able to tell if the switch is able to handle the amperage also required to operate the motor. You can read 12 volts

Mar 27, 2014 | 2003 Audi TT

1 Answer

Where is the temperature sensor located on a Audi TT 3,2 2004


hi i need wiring for audi tt 2005 oil presser sensor ,plz help me

Mar 14, 2012 | Audi TT Cars & Trucks

1 Answer

How to fit camshaft chain tensioner to audi tt


The 2002 Audi TT 1.8 liters engine timing belt set up:

af7091b.png


The 2000 Audi TT 1.8 liters engine rear chain & tensioner set up:

69fe549.png

Oct 04, 2011 | 2002 Audi TT

2 Answers

I need the cam timing set up for a 2000 Audi TT turbo 1.8 engine. In particular, the rear chain & tensioner set-up


The 2000 Audi TT 1.8 liters engine timing belt set up:


af7091b.png The 2000 Audi TT 1.8 liters engine rear chain & tensioner set up:

69fe549.png

Feb 07, 2010 | 2000 Audi TT

1 Answer

Audi TT Mk1 will not start.


Hi, did you sort the problem with your tt? I have exactly the same issue, apx engine, will not start, ecu not readable by vagcom or snapon scantool? Any advice gratefully recieved. Craig.

Jan 10, 2010 | 2000 Audi TT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...