Question about 2005 Chrysler Pacifica

Open Question

Where is the purge valve solenoid located on a 2005 Chrysler Pacifica?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
turo1000
  • 18 Answers

SOURCE: program instruction garage door opener in 2005 chrysler pacifica

if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.

Posted on May 18, 2009

Ad
  • 1 Answer

SOURCE: location of pcm on 2005 pacifica?

I have a 2004 Pacifica and mine is on the drivers side front, underneath between the bumper and the wheel splash guard. You will need to remove the splash guard ti access the PCM. Not very hard at all. Replacement time for a handy DIYer: about 1/2 hour. Good luck!!

Posted on Jun 05, 2010

jturcotte
  • 8836 Answers

SOURCE: where can I find a

3.5L engine?

8fe7d61.gifd8f14c0.gifac805da.gif

Posted on Oct 01, 2010

leedavidian
  • 1420 Answers

SOURCE: where is the oil sending unit located on a 2005

Welcome to FIxYa.com



Right above the oil filterleedavidian_4.jpg



Thank you for using FixYa.com

Regards, Lee Davidian

Posted on Nov 18, 2010

SOURCE: 2005 Chrysler Pacifica Washer Pump

The washer pump is located in the bottom of your windsheild washer reservoir. You will have to remove the wheel well cover to access it and check the plug in harness to make sure it is connected. Place a voltmeter on the to leads of the harness and have an assistant push the windshield washer button with ignition on. There you will see if your getting volts to the end of the harness. If you do, then the pump is bad. Replace it while you have access to it.

Posted on Jan 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the Transmission Control Module located on the 2005 Chrysler Pacifica


Typcially, is these mini-vans it is on the rightside (interior) wing panel, the ECU is on the leftside wing panel. If you start at the torque converter solenoid and trace the wiring loom it leads straight to the TCM.

Aug 03, 2017 | 2005 Chrysler Pacifica

1 Answer

How do I change egr valve on a 2005 chrysler pacifica ?


If car does not stay runnin or stalls wen slowin down is egr effects. It may be the gasket wher it connects to engine. Sonetimes u can blow out carbon in the valve itself. Seek a shopmanual at local library

Jul 27, 2015 | 2005 Chrysler Pacifica

1 Answer

Where is the bleeding valve located for the cooling system on a 2005 Chrysler Pacifica.


There isn't one I checked Alldata and it just says to keep overflow tank full and two or three cooldowns will remove all air pockets

Jun 06, 2015 | 2005 Chrysler Pacifica

1 Answer

Where is the evap vent solenoid fuse located on 2005 nissan altima


It doesn't have a "fuse" specific to the purge valve solenoid. What he is telling you is that you need to have this circuit troubleshot. Either the PCM the wiring going to the purge valve solenoid, or the purge valve solenoid itself is malfunctioning.

This requires a scanner, a digital volt ohm meter and some knowledge of when the purge valve actuates and under what conditions.

The car must be running and operating at cruising speed before the PCM sends a command to the purge valve to operate. Some scanners have the ability to send a request to the PCM to actuate the purge valve, but that scanner is usually a dealer's or equivalent.

May 08, 2015 | 2005 Nissan Altima

1 Answer

How to put wires in egr solenoid


WOW THIS TOOK A LOT OF TIME TO FIND if image isn't below you can find it at autozont library

Oct 19, 2014 | 2005 Chrysler Pacifica

1 Answer

Need to know where to find the canister purge valve


For the location of canister purge valve,check the following help links mentioned below:--
Click the link :---

Location for EVAP Purge Valve Solenoid?

http://schematicsdiagram.blogspot.in/2012/06/2002-nissandatsun-pathfinder-location.html


------------------

How to disconnect the hose form the Evap Canister?

http://schematicsdiagram.blogspot.com/2011/12/how-to-disconnect-hose-form-evap.html

-------------

2004 Chrysler PT Cruiser: Location of EVAP Purge Solenoid Valve?

http://schematicsdiagram.blogspot.in/2012/06/2004chrysler-pt-cruiser-location-of.html

-----------
These will help.
Thanks.

Jan 08, 2013 | Cars & Trucks

1 Answer

2005 pacifica slow fuel fill, How do I fix it?


That is a result of a failed EVAP System Valve,
that prevents the air escaping as you fill the fuel tank

May be called a Solenoid Vent Valve

Easy find & fix with the right tools at your
repair shop

You could, if you find the correct part, chance
replacing yourself

Use the internet to research the code you got

Sep 23, 2011 | 2005 Chrysler Pacifica

1 Answer

2004 Chrysler Sebring with engine error code 441, what does that indicate?


evap emissions control system incorrect purge flow --the most common chrysler fix for this code is replace leak detection pump /ldp but have it checked first-- other areas are evap lines /canister-- purge solenoid-- vacuum switch

Oct 21, 2009 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

467 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...