Question about Cars & Trucks
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: turning signals dont blink
Problem is the Turn Signal "FLASHER" unit, 1.Turn on Emergency FLASHERS 2. Go under Dash while they are on Listen -for Clicking sound then feel for it 3. Should Be a Silver Round Unit About as Big IN ROUND as Half dollar coin 4. ok now Look Around for the SAME EXACT Thing Clipped onto Something Under dash At Driver side Usually Between Steering wheel and Center HUMP in Floor, 5. once you find it Take OUT the first One you Found Emergency FLASHER) and 6. Put it In Place of Turn Signal Flasher, 7. Turn off Emergency Flashers- Turn Key in "ON" Position but don't start then Try Turn Signals. Yaaaa !!!! they work ?? LoL hopefully this Does the trick, if they work Buy new one and Replace Always Use NEW For TURN Signals as they are used Much More than Emergency Flashers. Hope this is Good Instructions For you and Helps you Solve The Problem, Please DONT Forget to RATE ME Thank you Rejakwilson@aol.com
Posted on Jan 18, 2009
change the brake light switch ,or rewire the whole lot to europeon standard where its all seperate.Stupid american idea where the brake light is used as the indicator as well.Had a few like this to import and had to rewire the whole rear back lights as their is some fancy brake light switch on these cars with a whole lot of wires .i just cut the whole bunch and rewired the lot as our regulations do not permit this type of concoction.best of british with it though as although its not difficult to do its amazing how many so called mechanics run when they more than two wires
Posted on Feb 19, 2009
SOURCE: right blinker does not blink
With the vehicle In Park and the ignition on, swith the R/S signal on. Now , gwt out of the car and walk to back of car and inspect the R?R signal light . OK ? Now, do the same to the R?F signal light. One of them are not going to working correctly. Replace the defective bulb, or socket
Posted on Mar 28, 2009
I have a 2000 ford focus no brake lights. with the brake lights the transmission would not go into drive .replaced the brake light switch checked fuse replaced turn signal switch with no results then i moved onto the wiper switch and replaced it as much to my supp rise it fixed the problems
Posted on Aug 06, 2009
normally when that happens its one of two things,, one of the bulbs has gone bad and the filament has arched over the other filament , so check the bulbs with a tester not just by eye , and if thats all ok, check the flasher unit itself, which I doubt in this case since its just one side is the problem clean the base of each bulb so you know they h ave a good ground
Posted on Jul 03, 2011
Tips for a great answer:
Dec 07, 2016 | Cars & Trucks
May 16, 2013 | 1999 Buick LeSabre Custom
Jun 03, 2017 | 2002 Chevrolet Express
Sep 10, 2011 | 1999 Pontiac Firebird
Feb 25, 2010 | 1996 Isuzu Rodeo
May 19, 2009 | 2003 Pontiac Montana
Mar 28, 2009 | 1989 Oldsmobile Delta 88
16 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: