Question about Cars & Trucks

1 Answer

When low feul light is on engine wontstart why is gauge doing this

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,061 Answers

I wonder what that light means? Maybe I'm out of fuel?

Posted on Dec 07, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2001chevytracker wontstart, turns over but on start attempt backfires

Check engine light on , what codes ? Map sensor , mass air flow sensor .

Mar 22, 2017 | Cars & Trucks

1 Answer

Feul gauges not working

Check the gauge fuse under the dash

Aug 18, 2012 | 1986 Mazda 626 Coupe

1 Answer

Shakes while in overdrive but i dont think its in trannsmission what else could it be?

Most likely is an engine miss.This is something I see all the time. It is usually caused by a breakdown in the ignition system and or a lean feul condition.You notice it more in overdrive because of the low rpms and engine load.If it is a gas engine you most likely have a bad coil or even a clogged feul filter.If it is diesel engine could be feul injector or feul pressure problem.

Feb 28, 2011 | 2001 Ford Excursion

1 Answer

My 1.6 gl, the feul gauge light stays on

The Low Fuel Light should only start to operate when there is less than 1 Gallon / 4.5 Litres in the fuel tank. For the light to be on continuously would indicate a chafes wire in the woring loom contacting the body. Check around the area where the fuel guage is located in the top of the fuel tank. Access to it is though a removable inspection panel in the floor of the rear of the vehicle under the rear seat.

Oct 15, 2010 | 1991 Toyota Corolla

3 Answers

1997 ford f-150 starts then backfires thru intake and then shuts off.

most likely the feul pump. test the feul pressure with a gauge. look of ther little metal feul line on the intale manifold. tst pressure. have freind listen at the rear of the truck for the pump prime. key on only. then start the truck, friend should hear pump running. could also need a timming chain but pump is more tlikely

Dec 27, 2009 | Ford F-150 Cars & Trucks

1 Answer

Feul light stays on, and feul gauge dont work

check to see if the ground wire on tank is grounded could also bod luck inside the tank does not work goe a simple fuse or the float

Jun 05, 2009 | 1983 Lincoln Town Car

1 Answer

Feul gauge not working pontiac montana

This is a common problem and its the sending unit in the tank.They use this same fuel pump assembly in almost all the silverado pick ups and the grand prix.You can find these things on ebay for about 67.00 delivered to the door.Its called the fuel pump module.The sending units float gauge is one of the most common problem gm has and there is some silent recalls on this.So if you want to do some investigating you may find that or call gm and ask them for the recall.I hope this helps you>Thanks for your time and have a great day....

Mar 31, 2009 | 2000 Pontiac Montana

1 Answer

Car starts and drives tidy then stops dead and wontstart if you

check engine light on??? OBD 2 scan if so and retreve code to repair don't gue$$ ,sounds 1 of 10 possible problems

Dec 17, 2008 | 2003 Hyundai Accent

1 Answer

Feul pump replacement on 97 polo

Hi, I don't think you can, but it would be worth checking the connections to the gauge in case they are dirty or corroded.
Hope this helps, D

Jul 09, 2008 | 1994 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides