Question about Chevrolet Cars & Trucks

Open Question

Fuel pump in the tank. Z 24 carburetor, 1994. NOT GETTING POWER TO PUMP, cleaned plugs and earth places. The park lights are off now, still no power. Assist with location of fuel pump relay please?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 979 Answers

SOURCE: 1996 CADILLAC DEVILLE, NO POWER TO FUEL PUMP

Check for a burned fusible link under the hood. If you have power at the fuel pump relay, you could have a bad ignition switch or bad oil pressure switch...accordianman

Posted on Dec 15, 2008

jmeyer847
  • 185 Answers

SOURCE: need location of fuel pump relay

This relay will be in the Power Distribution Center under the hood in the engine bay. Thanks for using fixya!

Sincerely,

jC

Posted on Jan 08, 2009

  • 2 Answers

SOURCE: on a 1991 geo tracker trying to find location of fuel pump relay

The computer controlls the power to the pump.Rplace the computer and all should be well. They r on e-bay for around 100 dollars.Good luck

Posted on Apr 06, 2009

localwonder
  • 6784 Answers

SOURCE: location of fuel pump relay (1990 hyundai sonata)

The fuse box is located low on the left side of the dashboard behind a cover, or at the left side kick panel, behind a cover.

Relay Box -is located under the left side of the dash as well.


3a53806.jpg

Posted on May 07, 2009

  • 30 Answers

SOURCE: 1994 toyota fuel pump relay

Fuel pump relay is in the engine compartment left side fuse block

Posted on Jul 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 JAGUAR WILL NOT START FUEL PUMP NEW WILL NOT KICK IN NOR WILL THE COIL FIRE COIL IS GETTING POWER AND FUEL PUMP ALSO LAST TIME IT WAS A RELAY TO THE BRAIN


Similar problem on my 1994 Sovereign; found earth post next to left hand fuse box corroded; (large grommet in inner wing just above fusebox is prone to leaking so sealed with mastic)cleaned and fitted additonal earth to new point on body, now runs fine.

Aug 23, 2013 | 1994 Jaguar XJ6

2 Answers

1994 honda civic will not start. New spark plugs and new fuel filter. The car will turn but not start. I have replaced clutch safety switch as well. lots of good gas on the tank. main relay and fuel...


REPLACE DISTRIBUTOR CAP AND ROTOR.AND PLUGS WIRES.IF GETTING NO SPARK TO PLUGS.CHECK SEE IF IGNITION COIL GETTING POWER.IF NOT CHECK IGNITION FUSE.IF POWER GOING TO COIL.FAULT EITHER COIL IS OPEN OR FAULT IN THE IGNITION MODULE IN THE DISTRIBUTOR.

Aug 23, 2011 | 1994 Honda Civic

1 Answer

Iam getting no voltage tto my fuel pump,front tank doesn't work,I changed the ignition switch,still no luck. the continuos power to my fuel pump reads 6.5 volts. From what I can tell my electrical sytem...


Poor earth connection most likely causing hifgh resistance voltage drop.

Could also be a faulty pump. Run a separate power supply to it and recheck.

Mar 10, 2010 | 1997 Ford F250 SuperCab

2 Answers

Power to fuel pump relay


Wade sorry to hear your woes, when I have this kind of trouble I virtually start from the beginning. What I would do in your case, is go directly to the fuel pump test the connections on the pump, they may have deteriorated, I wwould discard the existing wires and feed 2 new ones, {one to earth and one to power} Find out if your ignition supplies earth or power when you turn the key before creating a nearby ground. Run the new wire to the relay, this way you eliminate any possible breakdown from the relay to the pump. If this fails it was a small expense. Be sure that the pump is producing the right pressure when it gets hot the seals may not offer the poundage it needs to continue. A pressure test can be done at a mechanic shop with the right tool.
In summary, power from ignition to fuse, to relay, to pump. Finally, this does sound like an earth problem. Battery earth to body and another to engine should be existing too. Good luck, hope this helps.

Nov 19, 2009 | 1995 Buick Park Avenue

3 Answers

1979 chevy step van 350 new fuel pump rebuilt carburetor wont sta


remove the fuel line from the carb, put it into a bottle, crank the engine, If the bottle has fuel in it the fuel pump is working properly, if not, check the filter, and the fuel lines to the tank!!!

Nov 02, 2009 | 1979 Chevrolet C/K 3500

1 Answer

Can you access the fuel pump without removing tank? Im not getting fuel to the carb. I checked the lines to the fuel filter to carb and from fuel filter to the tank and seems clear. The only thing I can...


If you have a carburetor, you have a mechanical fuel pump on the engine. If you have a throttle body injection your pump is in the tank and the tank needs to be removed to get at it. Before dropping tank make sure the pump is getting power and a good ground.

Oct 01, 2009 | 1988 Chevrolet Suburban

1 Answer

Where/ how do i locate the power wire for the fuel pump on my 1996 holden rodeo? i've been told there will be some wires for the guage and some for the pump which lead into tank. Is there a way of...


if my memory is right there is a connector near chassis rail that comes from on top of fuel tank, 2 wire connector this is for pump you can check for power on wires from turning ignition to on position it should power up fuel pump for approx. 5 seconds then stop. will have continuous power while cranking (black with blue trace) other wire is black(earth) this is separate from tank sender unit. are you getting power at fuse check with test light if no power relay is not working.

Jun 24, 2009 | 1990 Isuzu Pickup

2 Answers

Not getting any fuel to thottle body


1st i would like to ask, is your car a carburetor type engine or an electronic fuel injected. if you have a carburetor and assuming your fuel pump is working properly, you may have a clog carburetor. just clean it and better replace your carburetor gasket and repair kit. this job is not a DIY, let an expert do it for you. if you have an electronic fuel injection, its more complicated situation coz EFI system are controlled by an ECM electronic control module. have your vehicle service by an autorize auto repair shop tha uses a scan tool or diagnostic tool to find fix the problem.

Jun 14, 2009 | 1995 Pontiac Grand Am

1 Answer

Change fuel pump on 1994 buick park avenue


Drain all gas as much as possible for weight reasons, Unhook fuel lines, unhook electrical connections, and ground connections, filler tube, and straps, then tank will drop out. Remove retaining ring on sending unit remove unit from tank taking note how it comes out because its got to go back in the same way it came out, chg. pump on sending unit there is one electrical plug, reinstall unit in tank with retaining ring, assemble in reverse order.

Feb 14, 2009 | 1994 Buick Park Avenue

2 Answers

Discovery land rover will not fire.


try taking the air cleaner assembly off you might not be getting enough air to engine
if this is the case then the throttle body needs to be maintenanced

heres another suggestion it just hasnt sucked gas to the engine to crank over sometimes they help

go out buy an electric fuel pump
find the fuel inlet source to engine hook up electric fuel pump
attach only ground to something in engine compartment
then get a can so that when gas comes out it has something to go into
tap the electric fuel pump power lead to the positive of battery let run till gas comes out make sure not to spark your working with gas
once gas becomes present detach electric fuel pump all the way set aside
hook gas line back to port and then start vehicle this should start

also with fuel filters there are 3 on a vehicle
one in engine compartment
one on chassis back by the tank
and one in the tank called the sending unit this has a filter in the tank this one could be clogged
make sure these filters are in the right position with gas flow flowing in right direction

Jun 05, 2008 | 1994 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...