Question about Nissan Cars & Trucks

1 Answer

1996 nissan 1400 champ shakes the engine on idling and cuts off.secondly its not accelarating and making some sqicking noise in the engine.

I replace a fan which was broken and new engine mountains

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 1,335 Answers

Have you checked for any vacuum leaks ? Have you done a complete and proper tune up ? Any codes in ECM or an engine light on ?

Posted on Dec 07, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan 1400 champ shakes the engine and cuts off on idling.when driving its making some sqicking noise and not accelarating


is it running the stock engine
or is something else in the engine bay

if still carby -- old school
check float and vacuum
timing and points gap

squeaking noise
water pump
drive belt loose or an alternator bearing
if manual gearbox
clutch throw out bearing

26389082-f1p2i1ur51egwcadgrrn13x0-3-0.jpg

26389082-f1p2i1ur51egwcadgrrn13x0-3-1.jpg

Dec 07, 2016 | Nissan Cars & Trucks

1 Answer

I have a nissan 1400 champ and is leaking oil on the front part of the manual 5 speed gearbox and the rear part of the gearbox. I have replaced the crankshaft oil seal but i still have oil leaking on


There are seals on the front and rear of the transmission. If the clutch wasn't covered in engine oil, then replacing the crankshaft seal wasn't necessary. Reseal the transmission.

Sep 29, 2014 | Nissan Cars & Trucks

1 Answer

I drive a Nissan 1400 bakkie (not a champ) i drives good and then starts jerking and wants to die as soon i i give petrol it sounds like its smothering


hi, personally ..i love that bakkie. Ok you changed points condensor, petrol filter! please check.. When it cuts out 1. if the ignition coil is not hot, if so thats your problem.2. also on the carb... over the needle and seat there is a tiny filter... somtimes gets blocked. 3. also check when it stolls if the fuel pump is not hot or pull the outlet fuel from the pump
and crank the engine... note if fuel comes out sufficiently.

May 21, 2014 | 2006 Nissan 1400 Bakkie

1 Answer

My nissan 1400 champ 2006 model cuts on fuel as I travel even if left in the sun for a long time. How can I overcome this problem.


have you replaced the fuel cap recently with a non vented type? Could create a vacumme in tank

Nov 17, 2012 | Nissan Cars & Trucks

1 Answer

96 chevy cavalier idles rough black smoke from exaust and spark plug are very black


I had same issue with my 98', after replacing plugs,wires,map sensor,searched time and time again for vac leaks,both o2 sensors etc.the negative terminal wire from battery to engine was slightly loose at the engine.I pulled that end off and cleaned and tightened and ran like a champ immediatley! Only reason i found that problem was accidental,when i was shaking some wires around it arched at that spot.

Aug 25, 2012 | 1996 Chevrolet Cavalier

1 Answer

1999 nissan frontier is idling rough the truck shakes but shaking stops when the air is turned on. changed oil, spark plugs, spark plug wires and distributor cap.


This can be your Idle control valve, when you turn the air on it puts the engine under load and your computer will increase the idle automatically to prevent the engine from cutting out.
When you are standing still and the car is shaking, by touching the accelerator very softly does the shaking stop? If so check the idle control valve.
I hope this will help.
Regards
Sam

May 13, 2009 | 1999 Nissan Frontier

2 Answers

Engine Shaking.


they changed the timing belt? if so they put it wrong, its probably off a tooth. take it back and make them recheck their work

Apr 20, 2009 | 2002 Honda Accord

2 Answers

1997 Nissan Hardbody has rough idle/surges/stalls


ok i have the same truck my timing was off 3 teeth but mine wouldn't kick out of high idle is y mine was surging but know with timing right no vacuum leaks i cant get it below 1400 but when a vacuum turns on it almost kills my engine any thoughts i know i got a vacuum line mixed up idk were though

Mar 13, 2009 | 1997 Nissan Pickup

1 Answer

1993 altima


check fuel pressure. check distributor, leaks oil internally onto the signal plate, could cause rough running and stalling. check intake gasket. spray carb claener at the injectors and listen for engine noise change. if it changes, than intake gasket is gone. very common problem. has the car been tuned up??has the base idle ever been adjusted?? checked?? if so, than check items above.

Jul 17, 2008 | 1993 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...