Question about Ford Cars & Trucks

Open Question

How to remove the blower motor on a 2011 ford fiesta I am haveing trouble removeing

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1995 Ford Explorer power window motor removal

You have to drill a hole in the sheet metal after you pull off the door panel. There is a dimple where the hole should be drilled. Make sure the hole you drill is big enough to fit the socket. I don't know why ford deigned it like this.

Posted on Oct 16, 2008

Ad
latoss101
  • 47 Answers

SOURCE: window wont wind up on ford fiesta

in the door handle you will see some plastic caps
remove these you will then find some phillips screwsremove them the handle will com off
same with the window winder handle
then check for other screws then pull door card off. but gently bottem out & top up

Posted on Jan 03, 2009

  • 6 Answers

SOURCE: ford fiesta 1999 rear wheel bearings

yes it is one big nut, however it looks like 4 individual nuts due to the fact that they are a thinly stacked layer or thin nuts held together by what you called the tab washer............only way to replace is to get a new one from ford........

Posted on Sep 19, 2009

Testimonial: "Thank-you for that, I have ordered a new one from the ford dealers. I just wonder why the 4 nuts were fitted in the first place? thank you"

  • 447 Answers

SOURCE: If I need to replace the blower motor for my 2001

If you are removing the main blower motor at the passenger side of the cabin then you don't have to remove the dash. It's behind the lower dash trim panel and takes about an hour and a half to two hours to do. Not to bad a job but you will need to be a bit flexible to see under there.

Posted on Jun 08, 2010

Testimonial: "Very helpful, thank you!"

ZJLimited
  • 17970 Answers

SOURCE: Replacing blower motor 2001 Chrysler Voyager.

Check this procedure to removal & installing Blower Motor...

  1. Disconnect and isolate the negative battery cable.
  2. Remove the right quarter trim panel as follows:
    1. Remove first rear seat. Remove the second rear seat, if equipped.
    2. Remove the sliding door sill plate.
    3. Remove the quarter trim bolster.
    4. Remove the upper C-pillar trim and D-pillar trim panel.
    5. Remove the first and second rear seat belt anchors.
    6. Remove the screws securing the quarter trim to quarter panel from the bolster area.
    7. Remove the screws securing the rear edge of the quarter trim to the support bracket.
    8. Carefully disengage the hidden clips securing the front of the quarter trim to the quarter panel just rearward of the sliding door opening.

      zjlimited_93.jpg

      Fig. Removing the trim panel to access the rear blower motor (click for zoom)

    9. Disconnect the wiring harness connector from the accessory power outlet, if equipped.
    10. On long wheelbase wagons only, remove the quarter trim from the quarter panel and pull second rear seat belt through access hole.
    11. Pull first rear seat belt through the access hole.
    12. Remove the quarter trim panel from the vehicle.
  3. Remove the 5 screws mounting the A/C-heater blower motor housing to the rear HVAC unit (one mounting screw located on evaporator cover).
  4. Twist the blower motor out of scroll housing.
  5. Disconnect the blower motor wiring connector.
  6. Remove the blower motor from vehicle.

    zjlimited_94.jpg

    Fig. The rear blower motor is held in place by four screws

To install:
  1. Install the blower motor unit into the vehicle.
  2. Reconnect the blower motor wiring connector.
  3. Secure the blower motor into scroll housing.
  4. Install and tighten the 5 screws mounting the A/C-heater blower motor housing to the rear HVAC unit (one mounting screw located on evaporator cover).
  5. Install the right quarter trim panel as follows:
    1. Install the quarter trim panel in position in the vehicle.
    2. Insert and pull the first rear seat belt through the access hole in quarter trim panel.
    3. On long wheelbase wagons only, insert and pull the second rear seat belt through access hole in quarter trim panel.
    4. Reconnect the wiring harness connector to the accessory power outlet, if equipped.
    5. Engage the hidden clips to secure the front of quarter trim to quarter panel rearward of sliding door opening.
    6. Install the retaining screws that secure the rear edge of quarter trim to support bracket.
    7. Install the retaining screws that secure the quarter trim to the quarter panel in bolster area.
    8. Install the second rear seat belt anchor (if equipped), and the first rear seat belt anchor.
    9. Install the D-pillar trim panel and upper C-pillar trim.
    10. Install the quarter trim bolster.
    11. Install the sliding door sill plate.
    12. Install the second rear seat, if equipped, and install the first rear seat.
  6. Reconnect the negative battery cable. Check blower motor operation.

Keep us updated.

Posted on Nov 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wheres the bolower resistor motor 2011 ford fiesta


hi the resistor is on the casing of the blower motor housing you need to take out the glove box to get access to it usually held in with two hex screws hope this helps

Jun 29, 2014 | 2011 Ford Fiesta

1 Answer

2011 ford fiesta diesel. I removed the radio fuse from my car and although the radio switches on it won't go past the initial start up screen and doesn't ask for the radio code. Please can you...


Find the person who bought this car new, take that person and the car to a Ford dealer. They will fix it for free, it is under warranty. Now that you know you have no business monkeying around with anything except the ignition key, the pedals, and the steering wheel, stay away from other things on the car.

Jun 20, 2011 | 2011 Ford Fiesta

1 Answer

How to change a headlight bulb on a mk6 ford fiesta


remove headlight ,think you have to remove the bumper for this

Dec 30, 2010 | 2011 Ford Fiesta

1 Answer

My 2002 ford courier heater wont blow hot air the blower is fine but no heat oil an wayer levels are fine good engine just no heat anyone help please and thanks


Hello. This is a common problem on fiesta's and KA's so I presume it could be the same on the courier. There is a valve which 2 pipes goes in and 2 come out behind. The vave is stuck shut! They are right next to each other and about 1 inch wide. If you look at the bulkhead you will see these 2 pipes and they lead into the valve inbetween the wipers. Two clips hold the pipe on and two other clips behind the valve. These will have to be removed and the valve taken off. You will loose a small amount of water when removing the pipes. Just make sure the engine is cold so you don't scold yourself. The valve is quite cheap approx £30 and will take about 30 mins to do

Dec 13, 2010 | 2011 Ford Fiesta

1 Answer

Ford fiesta rear shock absorber removal! do i need spring compressors to take the strutt off the car, or is the whole unit removable to be worked on undercover?


No, you don't need to compress the spring, a jack under the axle will allow easier lining up of the bottom bolt, without extending the shock absorber.

Dec 12, 2010 | 2011 Ford Fiesta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...