Question about 2003 Dodge Ram Pickup 2500
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is my understanding that the fuel lft pump has been replaced( updated) and is now gone back to the old way and is re installed in the tank.
I have had to put 3 lift pumps in since new, little did I know but Cummins tells me that the lift pump delivers minimal pressure and shortens the life of your injector pump.
So if that is true perhaps it is best to eliminate the lift pump and go with the new in tank pump. I plan on doing it the next time I have a problem.
Posted on Nov 20, 2008
Check the fuel pressure at the filter. Odds are the lift pump, located below the filter, is toast. Continual cranking of the motor with a bad LP wil cause the injector pump to heat up and burn out. Replace the LP and fuel filter. Bleed the system by cracking the inlet to the injector pump and bumping the enigine over so the LP will run. Once you have fuel at the injector pump, crack injectors 1,3,and 4. Crank the motor for no more 6 or 7 seconds at a time until it turns over. Give the pump time to cool for a couple of mintues between cranks. This process is easier with two people, one to crank and the other to watch for fuel and tighten the injectors once it starts. If the injector pump is fried at this point from cranking with no fuel, the motor should idle, but will stumble all over itself when the throttle is applied.
Posted on Jan 31, 2009
SOURCE: 99 ram diesel wont start
Did you check to see if there is power to the glow plugs if not then that may be the problem and if there is power when you cycle the key not to start but for the plugs to warm up you may have a bad glow plugs.
Posted on Apr 22, 2009
Diesel engines fire on compression alone (usually 400psi).The Truck may have air trapped in the fuel system.When you perform any fuel system repair on a diesel it is going to take alot of cranking to get the air out. You can take the breather loose and shoot a VERY small amount of starter fluid in the intake and it should start. Do not use starting fluid much as it can damage the engine. Good Luck.
Posted on May 06, 2009
you'll notice on your valve cover gasket there is two connectors.. the one up front is your 1-3 the one in the rear is your 4-6... you can remove your valve cover and check the connections from the injector connectors to the
connectors on the valve cover.. check for an open.. however you could also have a fault internally in 1 of your injectors in that bank as well.. hope this info helped..
Posted on Feb 03, 2010
Tips for a great answer:
Dec 07, 2016 | Dodge Cars & Trucks
Jul 30, 2011 | 2000 Dodge Ram 3500
Dec 05, 2009 | 2005 Dodge Ram 2500 Truck
Jun 01, 2009 | 1986 Dodge Ram 50
May 06, 2009 | 1999 Dodge Ram
May 05, 2009 | 1999 Dodge Ram
Jan 04, 2009 | 2004 Dodge Ram 2500
Aug 30, 2008 | 2007 Dodge Ram 3500 Quad Cab Laramie
Aug 10, 2008 | 2001 Dodge Ram 2500 Truck
Oct 26, 2016 | 2003 Dodge Ram Pickup 2500
18 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: