Question about 2004 Chevrolet Colorado

1 Answer

No turn signal click

Im pretty happy about this. it was too loud anyway

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 850 Answers

The relay is the fault

Posted on Jul 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 Chevy impala makes loud whining noise when I step on gas pedal what could it be?.Also signal lights stop working changed fuse still not working what could it be?


Loud whining noise , transmission fluid pump going bad , maybe ! Take it an have it diagnosed instead of someone guessing on here . Without hearing , that's all anyone on here can do . Same with the signal lamps , there are a lot of thing's that could cause the turn signals not to work . The switch , flasher , wiring etc... Are you prepaired to replace all those parts to fix it . Do yourself a favor an take it to a qualified repair shop . Because if you have to ask on here it's pretty evident you have no clue about cars . Changing fuse's isn't the way to do it , using a volt meter an test for B+ voltage on both sides of the fuse is the right way .

Feb 22, 2017 | Cars & Trucks

1 Answer

I have a 94 grand marquis with a power lock issue.


Sounds like signal loss at the master switch.

Jan 09, 2014 | Cars & Trucks

1 Answer

2006 pontiac torrent turn signal stays on


One directional lamp will be on & the
other end of the car on same side has
a burnt bulb

Dec 22, 2012 | 2007 Pontiac Torrent AWD

2 Answers

Turn signals blink slow


Hi Anonymous, call, take a ride or trailer your bike over to your local dealers service/parts department, I'm sure they will be happy to take your Harley Davidson for a test ride if necessary/possible and offer professional advice and assistance concerning your issue. Good luck have a nice day.

Nov 29, 2012 | Cars & Trucks

2 Answers

Turn signal keep clicking randomly 03 malibu


To diagnose: Does the clicking resume to normal when the turn signal or hazrds on? Then:
Multi function switch is damaged.(seems to be common) This unit consists of the two control arms(turn signals and wiper control) on either side of the steering column. It is easily replaced. Cost, app. 200 from GM or 160 aftermarket. GM product is TRW assembled in Mexico. Aftermarket is made in Taiwan. Firstly:

Disconnect battery.

There are 3 #20 Torx screws under the steering column shroud. Remove them and carefully separate shroud and remove. It takes a bit to worm the shroud around the column tilt lever. I didn't check but you may not even have to remove the lower section.

There is 1 #20 torx screw on top holding the MFS in place. It also has 2 guide pins on the bottom. Remove the screw and disconnect the 3 electrical pin connectors. Now remove and replace with new unit. I did notice the steel pin that operates the horn(it pushes in and out and sits against a rotating plate in front of the steering wheel) was a bit rough so I smoothed it out with a small file. Now put everything back in place.

Anyway, that should take care of the clicking. It worked for me.
rough so I smoothed it out with a small file. Now put everything back in place. Anyway, that should take care of the clicking. It worked for me.

Jun 27, 2009 | 2003 Chevrolet Malibu

2 Answers

Need loud signal flasher for 2008 Toyota RAV4


the module can be replaced by a chime or a truck blinker switch from a diesel truck shop and you may here it, however the other guy is right and has a couple good ideals. JC whitnet has one
here is the web page. and this is for the
RAV 4 http://www.jcwhitney.com/autoparts/Search?catalogId=10101&storeId=10101&sku=loud+turn+signal+flasher
g_13364g_th_1.gif;pv2b80a320e50f7422 CEC INDUSTRIES MUSICAL AND VERY LOUD TURN SIGNAL FLASHERS
Hear your turn signal over road noise and music! Select "Love Me Tender" which plays at standard volume, or our signal flasher louder than a standard flasher.
Review this product

Jun 26, 2009 | 1999 Toyota RAV4

1 Answer

Turn signal relay keeps clicking on and off


Replace the hazard warning light switch. Pretty common problem on GM vehicles

Jul 20, 2017 | 1998 Chevrolet Blazer

1 Answer

Car starts followed by loud bump then dies


If the coil pack was bad, there would be no spark and it probably wouldn't start at all. Plugs and plug wires would be where I would start.

May 24, 2009 | 2000 Mitsubishi Galant

2 Answers

97 honda accord turn signal problem


Flasher unit is bad. Replace flasher

Dec 28, 2008 | 1997 Honda Accord

Not finding what you are looking for?
2004 Chevrolet Colorado Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...