Question about Plymouth Cars & Trucks
The Fuel Filter is located under vehicle, passenger side, below seating area, passenger side of fuel tank, mounted on chassis in fuel line
Posted on Dec 06, 2016
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Right under the master brake cylinder, its really hard to replace it. It has 2 screws, one bolt on top and the bottom one needs to be screwed off under the car
Posted on Oct 03, 2008
first.... open the hood... yes the hood.... look on the firewall... you will see two rubber hoses going into it... that is where the heater core is located... generally it's on the passenger side but sometimes ..... in my dad's van for one it's mounted in the center... dodge's better idea i guess. while you are under the hood .. examine the hose connectors.... if they are hose clamps easy... if they are special connectors you will have to visit autozone or canadian tire or auto parts store to borrow the tool.... usually have to leave a deposit....
now... climb under the dash on the passenger side and look up... if there are sheilds to remove them... you will need to do that... i often remove the glove box to give me even better access and to see better what i'm doing.
the duct work is often held together by screws or clips. make sure you remove all the ones necessary ... front and back... it's usually a split shell so you only need to lower the one half......... pull the duct work carefull away from the heater core ... look for bolts hold it on ... usually again on the outside by the firewall... before take the bolts out use the tool to remove the hoses. you did drain some antifreeze first right ? .... it's tough to get all the water out so before you pull old core out either be fast about it so you don't spill antifreeze into the car... or tilt it up to drain some fluid out on the outside first.
remove the old core... install the new one... bolt it on... reinstall the duct work.... clean up... reinstall the hoses... refill the rad and leave the cap off when you start it up to add more fluid....
almost done... pinch the hoses gently when the motor is warm to move the air out of the system.... after you install the rad cap... take it for a drive.... when you get back wait till the rad is cool again and take off the cap... fill the rad up again... repeat that a few times to compensate for air bleeding out of the new core...
P.S. i did a heater core on a 69 dart i used to own.... basic car no options... took me fifteen minutes lol
Posted on Dec 17, 2008
The fuel filter is located under the car, in front and in a little, from the L/H rear wheel.
Undo the 2 nut connections, and fixing clamp, and its off.
Remember no smoking !
Good luck !
A FixYa rating would be nice... Thanks !
Posted on Feb 10, 2009
Tips for a great answer:
Apr 17, 2013 | Cars & Trucks
Jun 02, 2012 | 1994 Plymouth Sundance
Dec 05, 2010 | 1990 Plymouth Sundance
Nov 14, 2010 | 1991 Plymouth Sundance
Jan 29, 2010 | 1990 Plymouth Sundance
Mar 25, 2009 | 1990 Plymouth Sundance
Aug 18, 2008 | 1990 Plymouth Sundance
24 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: