Question about Cars & Trucks

1 Answer

Immodium How fast , side effects - Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 8,302 Answers

Posted on Dec 06, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

Side effects of blood thinners

The blood thinners like Xarelto has many side effects, you should be aware of this, consult with a reputed doctor who is specialized in this field. The xarelto can have serious side effects like Headaches, back pain, uncontrolled bleeding and Stevens-Johnson Syndrome etc.

Aug 18, 2014 | Cars & Trucks

2 Answers

Rpm gage drops fast when I let off the gas pedal

did you mean too fast ,as all cars do that.
moving or parked.???????????
hot engine or cold , or both.
well there are many factors governing that. moving
A/t tranny or stick....???
up hill or down hills.
loads in the car. trailers.
A/T fails to down shift?
M/T you didnt down shift.
both cars the engine stalled as you shifted?
bad ISC, it is used for deceleration called the dash pot effect
as you cut the throttle the ECU opens the ISC to stop on the fly
neck snapping effects, (software that replaced and old part on a CARB)

how low did idle go?
in shop we see all this and 10x more, in seconds.
on line forever. we blind here.

Apr 02, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Rear turn signal rapid flash

Rapid flashing is generally down to a bulb being out on the side it effects, due to the resistance being altered, does the side repeater and the front flasher flash fast as well? Try changing all bulbs on that side

Dec 30, 2013 | 2008 Hummer H3

1 Answer

Effect of wrong timing

cam, well that depends on DIRECTION

retarded would cause, lower compression and power.

advanced can be more power fast but not slow.

really that is what VVT does, runs one way for slow, and other for fast.

why do you ask.


yours is?

why not check compression,

if the belt slipped, most go to RETARD.

can moves fast and cam says, i dont wont to and it slips,

the crank over runs the cam. so very easy, with belt.

it retards and compression can fall from 150+PSI to 80,

and engine acts like 1Liter , pip squeak engine.

Jul 13, 2013 | 2003 Honda Stream

1 Answer

Driver side brake light issue

Consider the posibility that the replacement lamp is being installed backwards. It can be done and the resulting effect on performance will be as you describe

Feb 12, 2013 | Cars & Trucks

1 Answer

I have a 2002 PT Cruiser. On a cold start it starts on fast idle which is excessively fast. It is actually unsafe to put the car in drive. It will stay on fast idle for 5 minutes before dropping, but then...

code p 1193 refers to inlet air temp sensor problem --circuit high
a faulty ambient air temperature sensor or barometric pressure sensor will cause this effect as the idle control in the ECM is not getting correct temperature readings to set idle speed

Jun 23, 2017 | 2002 Chrysler PT Cruiser

1 Answer

I have a 08 f350 that I put led tail lights in,now the signal blinks fast like there is a bulb out?Do I need a heavier flasher?

Just the opposite. The reason the lights are faster is there is less load with an LED than with a standard bulb. Consult the manufactuer of the LED bulb for a resistor of proper size for each side.

A heavier flasher would be worse because the added lights of a trailer slow down the standard flasher. Your adding the LED had the effect of reducing the bulb draw so it acts like a lamp is out.

Oct 11, 2009 | 2008 Ford F-350

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides