Question about 2001 Chevrolet Impala

Open Question

My 2001 chevy impala's horn does not work while steering wheel is upright but works when I turn the steering wheel and I hear something loose inside the steering wheel!how do I fix this?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 337 Answers

SOURCE: changing key ignition need to remove old one and fix ignition rod

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f60e

Posted on Dec 01, 2008

  • 12 Answers

SOURCE: how to fix a power steering leak for a chevy

Is the leak coming from a hose or from the pump itself...If its a hose, most likely the factory crimp clamps gave way...Pry them off and replace with a hose clamp...If it's the pump itself, then the diaphragm is most likely warn out, and the pump itself will need to be replaced...You should be able to tell easily where its leaking by turning on the vehicle, make sure the unit is full of fluid, and have someone turn the steering hard right or left and the pressure will cause the fluid to leak or stream out of the problem area...As a note if its a fairly strong leak/stream the over-the-counter stop leak products will not work...tg

Posted on Mar 11, 2010

  • 2841 Answers

SOURCE: 2001 chevrolet impala hard to turn steering wheel

This is a common problem with the 2001 Impala. The intermediate shaft in the steering needs to be lubricated or replaced. There is also a recall on some Impala's. http://www-odi.nhtsa.dot.gov/recalls/results.cfm I suggest you take it to a trusted Chevy dealer and have this repaired.

Posted on Jul 15, 2010

Zeevert
  • 373 Answers

SOURCE: My windshield wipers on my 2001 Chevy Impala stop

This is a very common problem on the Impalas. I had to fix my 2002 Impala. Both wipers will point straight up.
There is a tab that may be bent near the wiper motor shaft.
Open the hood.
You need to remove the driver's side wiper arm. You need to pop-off the round black cover and there's a nut underneath.
Then remove the plastic cover between the windshield and the engine compartment.
See the pictures below, Look for a bent TAB. it's really tough, but bend it back with pliers and/or big screwdriver. The "catch" needs to stop on the tab to park the wipers correctly.
If the tab is OK, look for a missing or broken spring. For that, you'll need to get the replacement part from the dealer. May be: park mechanism, part #12494832
zeevert_22.jpg
zeevert_23.jpg
zeevert_24.jpg
I did a full write-up at this website: www.naioa.com
http://www.naioa.com/v2/modules.php?name=Forums&file=viewtopic&t=26086
You may have to register for free, and look under the "knowledge Based" section in the Forum.

Posted on Jan 02, 2011

  • 1243 Answers

SOURCE: 2007 chevy impala LT, horn and cruise control not

most likely the clockspring or ribbon assembly inside the steering wheel has a broken spot in it. if you try to do it yourself be careful with the airbag system

Posted on Jul 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2012 Chevy Impala that I recently bought from a dealership does not have a working. It doesn't work if I press my horn button on my steering wheel or the panic button on my key fob. Any ideas? Thank...


if you bought it with any warranty go back to the dealer you bought it from. if you push on the horn pad and you hear a click noise then the chances are the horn itself is bad. a horn must work to pass a safety. it could also be a BCM problem.

Mar 11, 2015 | Cars & Trucks

2 Answers

Horn won't work


Check the horn fuse!

May 10, 2014 | 2004 Chevrolet Impala

1 Answer

I have a 1987 Chevy 20 Conquest ss, Who ever put the horn in messed up so now that when i turn the steering wheel to a certain angle my horn goes off... How can i just disconnect it with out pulling the...


Pull off the horn button in the center of the steering wheel. It sounds like the wire to the horn button is loose and grounding out inside the steering wheel. Might just need reattached and everything will work as it should. Whatever the problem is, it is in the steering column.

Sep 05, 2011 | Chevrolet G20 Cars & Trucks

1 Answer

My horn doesnt work and my steering wheel is loose down on the inside of the steering calum. could the steering wheel be the problem for the horn not working?


it may well be the problem, you will need to remove the steering wheel to find why is has come loose, it might be a bearing that has collapsed & needs to be replaced or something may have broken......hope this helps......cheers.

Sep 05, 2011 | Ford Crown Victoria Cars & Trucks

1 Answer

2007 chevy impala LT, horn and cruise control not working. Cruise control is not working, the light does not come on at all. The horn works with the remote starter but not when pushing on the steering...


most likely the clockspring or ribbon assembly inside the steering wheel has a broken spot in it. if you try to do it yourself be careful with the airbag system

Jul 14, 2011 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

1986 chevy c10 truck. pulled steering wheel to


THE horn piece should turn with the wheel lock plate. if it does not then something is not installed properly

Apr 12, 2010 | 1986 Chevrolet Chevy

1 Answer

I have a 1966 chevy impala and recently installed a billet specialties steering wheel. I am tring to get the horn to work. I tested it and the horn itself does work and i know i need a GM horn wire. My...


most the time on the billet steering wheels you have to put a push button horn. if you ran a wire through column it would spin wire and eventually break it..

Apr 21, 2009 | Chevrolet Impala Cars & Trucks

1 Answer

When turning my horn goes off


it sound like the wire to your horn is loose or has come off your description ends does your horn work regularly?

Feb 05, 2009 | 2002 Honda Accord

1 Answer

1995 Prizm Horn Problem


keep the steering wheel in one spot, do not rotate,  check horn by pressing pad in different areas.  If it is intermittent then horn pad is concern.  If it works well trying slowly turning steering wheel while pressing horn pad if there is a point in turning the wheel where horn becomes inop, then the common fault is the horn contact ring inside of the steering column

Dec 17, 2008 | 2001 Chevrolet Prizm

Not finding what you are looking for?
2001 Chevrolet Impala Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...