Question about AC Cars & Trucks

1 Answer

Model 44132 works fine until time to change from ac to heat. Tried reprogramming.

Posted by on

  • Amanda chaffin Dec 06, 2016

    Heat and air worked fine previous.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • AC Master
  • 14,585 Answers

What were the codes? If you can reprogram it, it will have codes.

Posted on Dec 06, 2016

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 811 Answers

SOURCE: We have a 1999 Chrysler 300 M we have good ac

check valve at and before fire wall penetration should be in line with heater hose 

Posted on Oct 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Ac problems


vent flap shutting off?

Jan 14, 2018 | Cars & Trucks

1 Answer

Trying to reprogram thermostat


check the makers website for manuals

Jan 13, 2018 | Cars & Trucks

1 Answer

2007 equinox blows only hot air when vehicle is very hot.


It may actually be possible that the damper is sticking due to heat based deformity until air flow of any type purges the excessive heat.

That could be due to a manufacturing defect or worn hinge points.

You may get a better feel for how the dampers are working by calibrating the HVAC control;

1. With ignition ON and engine not running, press AC and Recirc 3 times in under 2 seconds
2. Verify AC and Recirc LEDs flash, wait 15 seconds for the re-calibration to complete, you may hear the damper doors cycling while calibration occurs. If audible movement is heard, listen that no dragging occurs during that movement
3. Once calibration is complete, press the AC and Recirc buttons to see the LEDs change
4. If LEDs don't change after their buttons are pressed, take the vehicle to the local dealer for electrical diagnosis
5. If dragging of the damper doors is heard, that may be the root of the possible sticking in hot weather.
Have the dealer or other competent mechanic check those dampers

Jul 09, 2017 | 2007 Chevrolet Equinox LT1

2 Answers

2005 yukon denali, a/c worked fine until battery died


Get the climate control computer relaced or reprogrammed. There is a good chance that when your vehicle was jump started it fried the climate system.

Jul 05, 2009 | 2004 GMC Sierra

2 Answers

Key fob won't unlock or lock car VW Golf 2000


You probably caused a short circuit when you changed the light. Change fuse #14. Next time, don't turn the lights on until you are finished changing the lights.

Mar 25, 2009 | 2000 Volkswagen GTI

1 Answer

AC/Heat Fan runs continuously and Rear end roaring noise


Sounds like the wheel bearing on the right rear hub may be defective, that would cause the noise if the tires are ok. As far as the fan goes not sure this isn't working as designed.

May 02, 2017 | 2005 Nissan Altima

4 Answers

Heater/ac not working properly


Easy fix. The vacuum hose has come loose. Happens all the time. The hose is about 1/2" in diameter and can be found under the hood, in the middle of the engine compartment, on the drivers side. Just take a tie wrap and tighten it down over the plastic inlet.

Jan 05, 2009 | 2004 Jeep Grand Cherokee

1 Answer

98 escort 2lt. will not start.


Disconnect your battery's negative cable. reconecct then try again. This happened to me on an older model. Hope it works for you. if it starts , keep doing this until the computer box reprograms itself. hope it helps.

Oct 25, 2008 | 1998 Ford Escort

1 Answer

Ac problems (over heating)


Did you tried to change the gas? i had same problems but it was the gas, change it.

Jun 17, 2008 | 1992 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top AC Experts

gbob59

Level 3 Expert

2992 Answers

old marine
old marine

Level 3 Expert

2144 Answers

randymanfive

Level 3 Expert

450 Answers

Are you an AC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...