Question about Cars & Trucks

Open Question

Need to know colour wiring on uno 1100 coil pack to dist

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ignition module wires to coil pack

found a good repair manual and followed the wiring diagram ~~~ Thank You / Jeff

Posted on Aug 31, 2008

  • 4 Answers

SOURCE: 95 Geo metro will not crank no fire

take your timing cover off have a friend look to see if the belt is moving while you crank the engine i would say that the belt is broken

Posted on Dec 16, 2008

  • 11 Answers

SOURCE: spark plug wires have no spark. No power going to the coil/ dist.

check ur components u probably burnt coil out

Posted on Jul 17, 2009

Richie_asg1
  • 1036 Answers

SOURCE: engine quit driving down road, no fire to plug

Fault with distributor. Replace rotating contactor and cap at the same time, or if it is electronic, replace the unit.

Posted on Feb 16, 2010

airjer995
  • 5332 Answers

SOURCE: I need to know the

Do you have a code for a misfire?

If a crank sensor goes bad the vehicle will typically not start at all.

If you have spark to all the cylinders than the next step is to either check compression or check the injectors. Usually the injectors will stick when this happens they will ohm out fine but will not spray fuel. To check them you will need either a high end scan tool or and injector tester and an fuel pressure gauge. The tester is connected to the injectors one at a time using the bulk connector near the alternator. The injector is then triggered by the tester as you watch for a drop in fuel pressure. Whichever injector does not drop fuel pressure when triggered is the bad injector.

airjer995_11.jpg

Posted on Nov 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 1992 fiat uno pacer -1400 carbarator looses sparks from coil it come and goes after some time it comes back plz help me thanx z


replace the coil or coil packs
if no better plugs and leads and distributor cap if it has one

26233949-ynvug1pb1td0jsjajemyimen-1-0.jpg

Jul 08, 2016 | Fiat Cars & Trucks

1 Answer

Can i replace my uno 1100 dist module with a volkswagen golf one and please the coulers of the wires


No their different ,one is a magnet marelli and the other a bosch ,just fit a marigold glove over the dist,cut the ends off the fingers and push the leads through tie the fingers up and the other end around the dist body and you can drive through a rive with no problem

Dec 29, 2014 | Volkswagen Cars & Trucks

2 Answers

Where is the dist. on 1996 2.3 ford engine ?


Maybe it doesn't have one. If it does you can follow the heavy spark plug wire back to it from any plug. If there r no heavy wires it doesn't have a distributor. The distribution is via the computer.

Jul 08, 2014 | 1996 Ford Ranger SuperCab

1 Answer

Where do wires go from coil pack to distributor cap and where else 1990 chevytruck 350


coil HT lead to centre contact on dist cap ,the remaining HT leads go to the spark plugs you will need the firing order to get them on the correct plug follow this link may have to research site for your year vehicle
1967 1972 Chevrolet Spark Plug Wiring Diagrams

Apr 04, 2014 | Cars & Trucks

1 Answer

Why is my tiburon not getting no spark


There could be a few reasons it doesn't. It may be your spark plugs/coils, wires, distributor, coil pack, cam sensor, dist. cap, even the PCM. You need to test each part to make sure. That would be the only way to actually know. You would need to check the wires and pins. Anyone could cause it.

Mar 05, 2011 | 2003 Hyundai Tiburon

1 Answer

I have a 1997 toyota t100 coil pack fried replaced that fried a brand new one help?


Replace the distributor, it is shorting the coil and also make sure the wiring to dist is not melted or fused to another wire, this problem is due to a bad control unit inside dist, replace it as a whole and this should solve your problem.

Oct 16, 2010 | 1997 Toyota T100

1 Answer

Not getting fire to plug wires. I have replaced coil pack, module, dist pickup,and cap. I have tested and have fire to dist but nothing coming out. This is an 86 2.8 comanche 4x4 w/ 4 barrel Holley carb...


You have spark on the coil wire but not coming from the cap. You replaced the cap right. Did you replace the rotor too. Sometimes the rotor burn in the center and the spark goes right thru it in to the distributor shaft.

Aug 11, 2010 | 1986 Jeep Comanche

1 Answer

99 tahoe 350. misfire #3. new cpi unit, plugs,


coil packs? or dist engine? check coil packs for cracks and leakage on distributor egines check for side to side play in the dist shaft if any play then change it!

Jan 17, 2010 | 1999 Chevrolet Tahoe

1 Answer

Tachometer wont work on a '66 mustang.


iam pretty sure u need a resitor a 300 ohm in between on the wire from the coil. keep in mind some dist have a tack wire some have not all

Feb 15, 2009 | 1997 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...