Question about Nissan Navara
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
When engine wiring gets wet it won't start. I had an old Mustang that I had to remove the distributor cap and dry it with a hair dryer every time it rained real hard. I am thinking it will start after enough time has gone by-I had a car get flooded twice, and first time it took 3 weeks before it would start.
Posted on Aug 28, 2008
SOURCE: my nissan navara D22
Hi james, you might have air in your injection system. ussually this air pocket could be corrected by bleeding the system; or, your fuel filter is clogged. First the filter, if your fuel filter is directly attached to a hand pump, and your filter has a sendimentary bleed port at its bottom, drain this first. Then, after its drained, close the drain plug. Next is to look for the fuel return bolt on the injection pump(usually it has a "out" word etched on it) and usually uses a 17mm hexagonal head. Loosen the bolt and slowly remove it. Take care, and watch orientation of the two copper washers that are used for gasket. You might also find a filter screen attached to the bolt on some injection pumps. Anyways, if there is no filter screen, re-screw in the bolt(remember the copper washers) but do not tighten it just let it loose for a while. Now for the sweaty part, using the hand pump, pump the fuel in until the return bolt spits out fuel. You will see bubbles on the first few pumps but do not stop until it bellows out pure and clear fuel w/o bubbles. If you attained the goal, stop pumping and screw the bolt shut. Wipe-off excess fuel from the injection pump. Try starting the engine. when the engine turns over let it warm up for a while the with, again, with your no. 17mm open wrench, try loosening the injector feedline one at a time(while the engine is running).Watch out for squirting fuel, your engine might rattle a little but it will be fine, just let the fuel flow a few seconds then re-tighten the nut. Do this on all 4 injectors. Let the engine run a few minutes then shut it down. Let it completely cool down then re-start it. Also try checking glow plug(or heater plug) condition. If one glow plug is busted replace all 4 at the same time with the same brand. this would help to keep the engine attain a 1-click engine run.
Hope this helps.
Posted on Sep 29, 2009
are you sure the correct amount of oil is in it? if over full the engine is trying to drag the crank shaft through the oil
Posted on Nov 28, 2009
SOURCE: nissan navara timing chain marks
I have a Nissan Nivara With the Z24 motor Fitting a new timing chain sprokets guides and adjuster Where does the camshaft numbers 1 2 and3 go
Posted on May 03, 2011
Tips for a great answer:
Jan 08, 2017 | 2000 Nissan Frontier
Jan 13, 2016 | Nissan Cars & Trucks
Aug 31, 2015 | 2005 Nissan Pickup Navara
Feb 19, 2010 | 2006 Nissan Pathfinder
Nov 27, 2009 | 2003 Nissan Se R
May 09, 2009 | 1997 Nissan Pickup
Aug 28, 2008 | 2006 Nissan Titan
11 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: