Question about 2004 Chevrolet Chevrolet Tahoe Z71

Open Question

I have a 2004 Tahoe Z71. The service 4wd message is on. I replaced the selector switch but it's still on. The 4 Ed works fine in low and high but still got message.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Will not shift into 4wd low but will shift into 4wd high

Thanks for your response johnnyc85.... I did some searching on the internet and found it. When you need to go into 4wd low, just turn your knob to the 4wd low position and when it starts to blink just put the truck into drive or reverse and move about 1mph it will lock right it. It takes about 5 seconds to engage.

Posted on Jul 02, 2008

  • 1 Answer

SOURCE: 03 Chevy Tahoe Z71 - 4wd not functioning

my son has one and his did that and it was a fuse he put a new one in and it is working good now

Posted on Jan 22, 2009

  • 2 Answers

SOURCE: 2004 f250 won't shift into 4wd low range.

I'm pretty sure the truck has to be at a complete stop with the transmission in neutral before it will accept your low range input selection. Unlike 4wd high.

Posted on Jan 28, 2009

  • 121 Answers

SOURCE: 4 wheel drive selector switch lights go off and

new doesn't mean good, scan the computer for codes and use that code trouble tree.may have wires chewed into and touching from rodents check wires very closely on top of trans. not normal for the dash switch to short out either. may need to replace the contol module and reprogram hope this helps.

Posted on Dec 06, 2009

  • 1 Answer

SOURCE: 2004 Chevy tahoe Z71 is

Try beginning with your car off. Start your car and put it in neutral with your foot on the brake. Then press any button besides 4-LO and 4-HI. This should take it out of 4-LO

Posted on Nov 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4 wheel will not work. the selector switch will show it is in but front tires will not engage No messages on control center


Search Results

    4WD Transfer Case Position Sensor/Selector ... - RepairPal

    repairpal.com > Problems > Chevrolet > Tahoe
    Service 4WD Message May be Displayed on Chevrolet Tahoe. The 4WD transfer .... I had a similar problem with 4 wheel drive selector switch. When I select 4 ...

    4WD Transfer Case Position Sensor/Selector ... - RepairPal

    repairpal.com > Problems > Chevrolet > Suburban 1500
    Service 4WD Message May be Displayed on Chevrolet Suburban 1500 ... When in 4 wheel , it will not in engage sometimes and message comes on to service 4 wheeldrive. ... I replaced the 4wd transfer switch in 2007 and now again it is not working, this would be the ... 2008 Chevrolet Suburban 1500- 4WD156,000Visitor.

    Chevrolet Tahoe Repair: Problems, Cost and Maintenance

    repairpal.com > Cars > Chevrolet
    Having problems with your Chevrolet Tahoe? Learn about common Chevrolet Tahoe problems, recalls and typical maintenance and repair costs. ... ABS Front WheelSpeed Sensors May Fail. Chevrolet Tahoe ... 2008 Chevrolet Tahoe.

Jan 21, 2016 | 2008 Chevrolet Tahoe LTZ

1 Answer

2004 Tahoe stuck in auto 4wd and service 4wd light is on


switch on dash can cause this but the transfer case control module is the culprit most times.try disconnecting battery this will should reset the TCM.see what happens.worst case senereo is bad transfer case

Dec 10, 2013 | 2004 Chevrolet Tahoe

1 Answer

My 99 Chevrolet silverado 4wd not working.ive replaced the dash switch and still nothing .when I turn the key the 4wd switch lights stay on for a split second then goes off. What else should I try?


I have run into to this problem many times on these trucks, i have seen your problem and also where the 4wd high light wont work but 4wd low and 2wd work fine and the 4 wheel drive works fine. on your truck i will bet its the transfer case selector motor.
the motor is what turns the lights on when in the selected mode which goes through the 4wheel module under the dash, this sounds like a bad selector motor and that where i would start. this motor is located on the transfer case, it bolts to the rear of it.here is a picture of it to help you locate it. good day.4_14_2012_12_37_13_pm.jpg

Apr 14, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

I have a 2004 GMC Envoy XL and the high range 4x4 mode will not engage. The AWD system works just fine as well as the 4x4 mode in low gear. What is causing this?


Is the Service 4WD light coming on? Do the light on the 4x4 selector switch indicate the proper selection and are on steady after a few seconds? If there is no Service 4WD light on and the selector switch light are correct, the only place for the problem to be is the Transfer Case. Has the Transfer Case fluid been changed at 50K mile intervals? This is very important.

Feb 01, 2011 | 2004 GMC Envoy

2 Answers

2004 Chevy tahoe Z71 is stuck in 4wd low. When I press 2high it just flashes and stays in 4wd low. How do I get it out of 4wd low?


Try beginning with your car off. Start your car and put it in neutral with your foot on the brake. Then press any button besides 4-LO and 4-HI. This should take it out of 4-LO

Oct 31, 2010 | Chevrolet Tahoe Cars & Trucks

1 Answer

Default 2003 chevy surburban I have an issue with my 4wd selector switch. Each time you start the vehicle it doesn't remember the last setting. It can be in 2 hi, 2 low, auto, 4 high, or 4 low. Seems...


I have the same problem. I have had it in the shop on numerous occasions and they couldn't find the problem. Yesterday it stopped working altogether. I'm stuck in 2WD and there is a snow storm arriving tonight.

Jul 20, 2010 | 2007 Chevrolet Tahoe

2 Answers

I have a 1998 Chevy Tahoe with the service 4wd light on and cannot switch out of 4wd, can it still be driven and what could be the problem?


if its electric shift. its probly the shifter motor. start vehicle open the door listen 4 the shifter motor. 2 see if you can hear it trying 2 shift. if not thats what it is if you can hear it tryng 2 shift it mite be vacume lines

Feb 13, 2010 | 1998 Chevrolet Tahoe

1 Answer

4 wheel drive selector switch lights go off and when they come back on the tahoe is in 4 low 2004 Chevy Tahoe Z-71 Sometimes the switch will show to be in Neutral. We have already replaced selector switch!


new doesn't mean good, scan the computer for codes and use that code trouble tree.may have wires chewed into and touching from rodents check wires very closely on top of trans. not normal for the dash switch to short out either. may need to replace the contol module and reprogram hope this helps.

Dec 06, 2009 | 2004 Chevrolet Tahoe

1 Answer

03 Chevy Tahoe Z71 - 4wd not functioning


my son has one and his did that and it was a fuse he put a new one in and it is working good now

Jan 14, 2009 | 1999 Chevrolet Blazer

Not finding what you are looking for?
2004 Chevrolet Chevrolet Tahoe Z71 Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...