Question about 1999 Saab 9-5

1 Answer

Check engine light on 1999 Saab 9-5 Turbo

I have replaced the fuel pump, the ignition coils, the plugs, the crank sensor, the battery, the gas cap.....and the check engine light hasn't gone off....any suggestions? If I disconnect the battery will it go away when I re-connect it? UGH - this car costs WAY too much to maintain.
Thanks for any help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 850 Answers

Typical computerised car!
im going back to the good old ways!
Now back to yours lol
get it scanned & reset
Cheers rob.

Posted on Jul 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

No spark ferom coil


Probable Causes: Fuel Pump (P0230 to P0233) PCM (P0600 to P0606) Crank Sensor (P0355 to P0399) Fuel Pressure (P0190 to P0194) Chances are the Check Engine Light is not on, but you may find any of the following codes: P0230 to P0233 Fuel Pump codes P0600 to P0606 PCM related codes P0335 to P0339 Crank Sensor codes P0190 to P0194 Fuel Pressure Sensor codes No spark due to a bad crank position sensor, a faulty ignition module or PCM, a problem in the ignition circuit (ignition switch, antitheft system, wiring, etc.), a faulty park/neutral safety switch, a bad ignition coil (only on engines with a single coil ignition), or wet plugs or plug wires (did it rain last night, did you just wash the engine?) A less common cause is a worn starter that draws so many amps while cranking the engine that there's not enough juice left to adequately power the ignition system and fuel injectors. Contributing factors might be a weak battery and/or loose or corroded battery cables. No fuel because of a dead fuel pump, bad fuel pump relay, blown fuel pump fuse, plugged fuel filter or line, or failed PCM injector driver circuit or injector power supply relay. Or, the fuel tank might be empty (don't believe what the gauge is telling you), or the fuel tank might contain contaminated fuel (water or too much alcohol) or the wrong type of fuel (whoops, somebody put in diesel instead of gasoline). No compression because the timing belt or chain is broken, the timing belt or chain is loose and jumped out of time, or the overhead camshaft has snapped.

Dec 20, 2013 | 2000 Hyundai Sonata

2 Answers

It turns but it wont start,it has gas and power


Pull off the coil ignition cable at the distributor and check for spark coming out of coil when cranking engine over. Use a heavy rag or glove to hold the wire 1/4 inch from a metal ground. Should see a strong blue spark when cranking to verify ignition is good. If no spark, check for battery voltage to coil on the coil primary. If you have current to the coil, suspect a bad coil, ignition module, crank position sensor, or cam position sensor, or pcm. The coil, ignition module, and sensors can be tested before replacing.

Jan 29, 2013 | Cars & Trucks

1 Answer

Gets gas gets spark but don't start. new fuel


1. does it turn over? if so, strong, or weak? 2. did you replace the fuel filter? 3. coil packs, or distributor (pack(s) can be tested) if distributed check cap and rotor, replace coil, but first check starter relay - 4. Check all ignition fuses, starter fuse - (along with relay{above}) 5. Check all connections from battery - positive, negative etc.
Please let me know if you need further assistance.
carsandcomps,
Guru, Premium Expert @ Fixya.com

May 26, 2011 | 1997 Dodge Dakota

1 Answer

Replaced bad fuel pump, installed new relay and fuel filter, engine turns over but is not firing on..... positive the fuel pump is pumping gas and checked to see if gas was going thru fuel filter. Tried...


Hi, Ok you have confirmed that it's not a fuel problem. You need to check for spark. Pull the coil wire off of the coil(secondary lead-looks like a spark plug wire) Have some one crank it over and listen for a popping sound. IF yes, spark is at the coil, that means all ignition sensors are working. Next check for spark at ends of wires after cap. IF no replace cap and rotor. IF yes remove a couple spark plugs and check for fouling(wet, fuel etc...) IF yes replace or clean plugs and retest for starting. IF no spark is present at coil you need to scan computer and watch for rpm signal. IF no rpm signal, replace crankshaft sensor with OEM delco part. BIGGEST problem with these engines is Cap and Rotor burn out.

May 23, 2011 | 2002 Chevrolet Blazer

2 Answers

Toyota previa stalled (died suddenly) while being driven it feels like there's a hiccup in the engine no matter how hard i press the accelerator it won't accelerate!


Ika, has it started back? If not, it may be a timing belt/chain broke. If it cranks, it may be a fuel pump, filter, pinched gas lines, or bad fuel injectors. It may be a problem in the ignitions. Spark plugs,coils, wires, distributor, coil pack, dist.cap, If it is not cranking, check ignition fuse. Check battery, wires, and whole charging system. If it is just dying on you and it starts back, it may be a map sensor, idle sensor or throttle sensor possibly. Need a little more info please.

Mar 07, 2011 | 1993 Toyota Previa

1 Answer

I HAVE A2000 ASTRO VAN IT QUIT WHILE DRIVING. I TRIED TO START BACK BUT BATTERY WENT DEAD, SO I GOT A BOOST, IT WOULD CRANK BUT NOT START. I GOT BATTERY TESTED IT WAS NOT HOLDING ENOUGH CRANKING AMPS SO I...


The fuel pump pressure shoud be 55-61 psi . Check for spark by removing a ignition wire at a spark plug and put a spark plug in wire and hold to engine ground and crank engine , if no spark then remove coil wire at cap and repeat.If still no spark then coil , module,,crank sensor or pickup may be the problem.
Check fuel pump pressure first and if available check for codes for possible crank sensor.

Feb 13, 2011 | 2000 Chevrolet Astro

1 Answer

Wont start


is the your car engine cranking when you try to start, first check spark plugs ignition coils, remove one ignition coil and spark plug fix the spark plug in to the ignition coil then connect ignition coil to wiring and keep spark plug body touching on ground of engine head mettle parts, ask some one to crank engine then you can see is the plug sparking or not, do the same way to all the coils and plug otherwise you have to buy a ignition spark tester, is the all the coils and spark plugs are OK then check the fuel pump, it's sitting in under rear seat, before that do one thing disconnect oxygen (O2) sensor wiring and crank engine, the thing is if your oxygen sensor completely dead fuel pump will stop working, if engine start after disconnect O2 sensor, replace new O2 sensor, otherwise need to check fuel pump relay fuse and fuel pump. is this information helped you? please vote me and give a comment.

Oct 15, 2010 | 1998 BMW M3

2 Answers

Wont start turns over but no start


1 Inspect Battery Battery Discharged or Faulty. 2 Inspect Battery Cable Corroded, Broken, Shorted or Poorly Connected Battery Cable. 3 Inspect Fuel Filter Clogged or Dirty Fuel Filter. 3 Inspect Distributor Cap Distributor Cap Cracked or Burned. 5 Inspect Coil - Ignition Faulty Ignition Coil. 6 Inspect Wireset Worn, Damaged or Faulty Spark Plug Wire(s). 7 Inspect Spark Plug Incorrectly Gapped or Fouled Spark Plug(s). 8 Inspect Starter Starter Motor Faulty. 9 Inspect Fuel Pump Low Fuel Pressure. 10 Inspect Solenoid Switch Faulty Starter Solenoid Switch. 11 Inspect Relay - Fuel Pumpat Faulty Fuel Pump Relay. 12 Inspect Fuel Injector Pressure Regulator Faulty Fuel Injector Pressure Regulator. 13 Inspect Ignition Switch Improperly Connected or Faulty Ignition Switch. 14 Inspect Starter Drive Faulty Starter Drive. 15 Inspect Fuel Injector Dirty or Worn Fuel Injectors. 16 Inspect Fuel Pump Strainer Clogged or Dirty Fuel Pump Strainerat. 17 Inspect Engine Control Computer Incorrect Operating Information Being Delivered and Sent From The EEC. 18 Inspect Fuel Tank Fuel Tank Empty. 19 Inspect Carburetor Carburetor Flooded or Faulty Choke. 20 Inspect Distributor Worn, Loose, or Incorrectly Installed Distributor.

Jul 02, 2009 | 1997 Ford F250 SuperCab

1 Answer

Galant Special Edition 1994 Motor does not start


this maybe caused by no fuel or faulty fuel pump, ignition coil, wire and plug crank position sensor. first check for spark by removing on spark plug wire and put a spark plug in the spark plug wire boot, donot touch the plug only the boot have someone crank the car over. if you see spark, that part of the ignition is good. if not, check the coil resistance if should 40 to 80 ohm with a volt meter pf not replace. if ok, but no spark check the igniton control madule make sure the coil and module are receiving current. if not check the fuse that feels them. if it is ok, check distributor cap and rotor. if rotor and cap are fine, check for fuel at either the fuel filter, the fuel return line or removing some spark plug and see if they are wet. if there is no fuel check the fuel pump and the fuse and relay that control the pump. if there is fuel with high pressure but there is no spark, check the crank sensor for signal with a volt meter while cranking the vehicle

Jan 02, 2009 | 1993 Mitsubishi Galant

1 Answer

My s10 will turn over, but wont squirt gas through injecter


Does it crank? Do you have any codes? Check engine light? Do you have spark? No spark check coil, and connections, also it would be nice to know what year it is. Get codes read. No crank check battery and starter. No codes or lights check crank position sensor, make sure your pcm is good after replacing your ignition mod you could have blown it if you did do it right. (engine computer) Check cam sensor if applies. Crank and cam could prevent it from starting and I know one I think cam controls pcm's fuel delivery on gm's

Dec 30, 2008 | 1986 Chevrolet S-10 Blazer

Not finding what you are looking for?
1999 Saab 9-5 Logo

518 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...