Question about 2005 Nissan Frontier

Open Question

05 nissan frontier 4.0 locate oil pressure sender

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dennymulford
  • 1055 Answers

SOURCE: oil pressure needle at H

sounds like an oil pressure sening unit un plug it whilf its running and see if the gauge goes too zero,if not then the prob is the gauge, the sending unit is only about 15.00 at auto zone and easy too put in

Posted on Jan 28, 2009

Ad
  • 5 Answers

SOURCE: Nissan 2007 Frontier tire pressure monitoring system

check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well


Hope that helped

Nissan tech +6 years

Posted on May 06, 2009

  • 484 Answers

SOURCE: 2006 Nissan frontier 4 cylinder belt diagram + tensioner pulley

They are under the hood or on the front crossmember.

Regards,
matt

Posted on Sep 14, 2009

leedavidian
  • 1420 Answers

SOURCE: where is the oil pressure

Welcome to FixYa.com Thank you for Using FixYa.com Kind Regards, Lee Your FixYa Expert and Master Technician leedavidian_180.png

Posted on Feb 11, 2011

david_wil419
  • 1 Answer

SOURCE: Nissan 2007 Frontier tire pressure monitoring system

There should be a way to reset any car alarm. If the problem persist the alarm will come back on. Most alarms probably have more to do with the sensor system than actual problems. Of course that means you have to pay the dealer to "fix" a problem you don't have. Exasperating! They should pass a law that allows a car owner to reset his alarm system.

Posted on Feb 15, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Having a few issues with my 2006 Nissan Frontier. First, The oil pressure gauge is acting screwy. While driving long distances it has started to flucate and when at idle it often drops down? Next, have a...


had these same indications on a v8 range rover from new. Turned out to be a rotating main bearing shell opening the oil hole to the crank (low pressure) then closing off the hole ( high pressure). I would be having a mechanical oil gauge fitted ( service mechanic ) to eliminate any bearing fault. I would also be replacing the oil pressure sender unit. as a precaution

Jan 13, 2013 | Cars & Trucks

1 Answer

Transmission fluid dipstick?


Go to this LINK to see location, the truck is a 05 but the location is the same on your truck.

Jun 27, 2012 | 1998 Nissan Frontier

1 Answer

Oil leak appears to be oil sending unit where is it located


Replace faulty oil pressure sender.
Oil pressure sender is usually on the engine block, screwed into a fitting accessing the motor oil distribution gallery.

Jan 22, 2010 | 1996 Nissan Maxima

1 Answer

Where is the oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter


Removal & Installation
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Jan 12, 2010 | 2000 Jeep Grand Cherokee

2 Answers

What is eng oil capacity for a nissan frontier 4 banger 2000 model


Including filter; the oil capacity for a 2WD, 2000, Nissan, Frontier, 4cyl (Ka24de) is 3-3/4 quarts. Straight out of the Haynes manual.

Nov 28, 2009 | 2000 Nissan Frontier

1 Answer

Where is the oil sending unit switch located on a 2003 4.0L jeep grand cherokee?



Removal & Installation

  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
7f7455b.jpg
To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Oct 08, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Nissan 2007 Frontier tire pressure monitoring system


check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well


Hope that helped

Nissan tech +6 years

Apr 05, 2009 | 2007 Nissan Frontier SE Crew Cab

Not finding what you are looking for?
2005 Nissan Frontier Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...