Question about Cars & Trucks

Open Question

My service 4x4 service light came on and i have no 4 wheel drive. I changed oil in transmision drove 20 miles turned a corner and truck lost movement.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jonbrown725
  • 73 Answers

SOURCE: 2000 F350 Super Duty Will not go into 4 wheel drive

I have recently had this problem with a customer. It seems the 4x4 low will only engage in neutral with the brake applied. And also check fuse. Then select drive and you will feel it lock in. Don't "goose" the fuel when attempting this.

Posted on Jan 14, 2009

Ad
  • 30 Answers

SOURCE: 02 Ford Explorer XLT 4x4 High light flashes and

I had same problem on my 2002 explorer. Its either the computer module, or the electric solenoid on the transfer case. In my case it was both. The computer module I had done twice in 14 months.

Posted on Jul 04, 2009

  • 580 Answers

SOURCE: 2005 Grand Cherokee Limited Service 4 Wheel Drive Light On

Have the 4wd serviced

Posted on Jul 19, 2009

JayShelton
  • 3 Answers

SOURCE: My 99 GMC Jimmy has the service 4X4 light on and

I own a Jimmy and have done quite a bit of 4 wheel drive repair on it.
The first thing i would check is the 4x4 selector switch. I know for a fact that these will throw a service 4x4 code if they are unplugged or shorted. They sell for 50-60$ or you may find one at a local salvage yard for cheaper. Taking this out and checking it only takes a few seconds, just simply pop the switch out of the dash with the edge of your pocket knife. After you get it out theres a few more tabs surrounding the back plate, and this is where the circuit board is located. I would inspect it visually to make sure nothing looks corroded and also take a sniff of it to insure there isn't a burnt smell. If it were the 4x4 actuator the lights would still illuminate on the selector switch, it just wouldn't engage the 4x4. You'r problem is all electrical trust me .

Posted on Jan 05, 2010

  • 7 Answers

SOURCE: 2004 chevy silverado 1500 4 wheel drive wont work..

try selecting from nutreul or less then 3km

Posted on Feb 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevrolet suburban LT 1500 LT won't disengage from four-wheel-drive


Chevrolet Suburban Questions - 4 wheel drive does not ...

www.cargurus.com > Questions > Chevrolet > Suburban

CarGurus4 wheel drive does not work - When I put the Sub in 4 wheel drive, low of high, ...Asked by Robert_Holland_073 Dec 17, 2009 at 04:06 AM about the 1994 Chevrolet Suburban K1500 4WD ... it can seize up and then the trans case may ingage but the hubs won't be locked in so it ... 1999 Chevrolet Suburban K2500 LT 4WD.

Chevrolet Tahoe Suburban 4 Wheel Drive Indicator Lights - Car ...

forums.edmunds.com > Chevrolet > Chevrolet Suburban

Oct 2, 2007 - 31 posts - ‎19 authors
My 1999 Tahoe (odo reading 137,400 miles) won't go into 4 wheel drive. .... I have a 98 suburban 1500 4x4 LT 5.7 L with 165,000 miles ... I recall once forgetting todisengage 4WD and I could feel a terrific binding when I ...
Step by Step Troubleshooting 4wd 4x4 88-98 Chevy GMC ...? 21:32https://www.youtube.com/watch?v=Su9Dkrfd_ZgJan 20, 2014 - Uploaded by rwdellingStep by Step Troubleshooting 4wd 4x4 88-98 Chevy GMC Truck. rwdelling .... Mine is acting like it is NOT pulling with the fronts,won't engage. ... Have you ever adjusted or the shift cable on your 1500 Chevy ... GM 246 transfer case, 2000 Chev Suburban- Duration: 20:09. by spelunkerd 286,045 views.GM Troubleshooting Part 13 - 4WD vacuum actuator & cable ...? 5:11https://www.youtube.com/watch?v=CbEF6PyJdU0Feb 3, 2011 - Uploaded by mr diyguy123I tacked on this video about the 4wd sys. ... I have a 1994 ChevyS10 ... My S10 won't let you go to 4 LO when your in gear. ... the front end to keep them disengaged. when you put it in 4wd, the vacuum actuator pushes a gear ...

Dec 25, 2015 | Chevrolet Cars & Trucks

2 Answers

Replace carrier bearing differential


4x4 mean 4 wheel drive, it could be all time 4 wheel drive or u can engage into 4 wheel drive, the vehicle have to be equipped with that.

Nov 02, 2013 | 1998 Chevrolet Tahoe

1 Answer

Four-wheel drive not working. No light on swtich. New transfer case motor. Checked the fuses and the four-wheel drive switch. What can it be?


Was the transfer case fluid changed every 50K miles? This very important on these trucks. The Transfer Case Control Module (TCCM) could be at fault, especially since you have no lights on the selector switch. Is the Service 4x4 light on? When you switch from 2H to any of the 4 wheel drive selections, do you hear any actuator noises coming from under the truck?

Dec 07, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

Went on trip and van want go in second just die down but drove in frist the next morning still did not change after about 20 miles it change gears for almost 30 miles then just die out and wold not go out...


If you have a lot of miles on your van , 100,000 or more , have the transmission serviced. But before you do that , check the vacuum line to the modulator valve for leaks or breaks In the vacuum line .

May 12, 2010 | 1994 Plymouth Voyager

2 Answers

2005 Titan le 4x4. while driving down the road the check engine light flashes and the 4LO flashes the the truck dies. I pull over turn the truck off let it set for a few seconds and then it starts up and...


Sounds like your 4x4 is engaged in 4 low. If your Tach shows High RPM then your still in 4 wheel drive

Start the truck, place in Neutral and try shifting Out of 4 Low,into 2 wheel drive then reverse for about 10-20 feet to try and help it disengage from 4 Low.

Feb 25, 2010 | 2005 Nissan Titan

1 Answer

4 wheel drive lock up


hey charlie, 1st problem is 4 wheel drive being engaged on dry pavement. You should only have it in 4x4 in snow, or off road on sand, dirt,etc. Newer all wheel drive vehicles compensate for the tires rotating at different speeds, like going around a sharp corner. The wheels on the outside of the turn have a longer distance to travel than the wheels on the inside of the turn. This results in the vehicle feeling like it's jumping, hopping or jerking as you cut a tight turn. You can damage your 4x4 system, as the wheels are fighting each other, trying to turn the same # of rotations, and something can and will give (like blowing the transfer case). If your light is staying on after changing to 2 wd, it is possibly stuck in 4x4. To shift from 4wheel to 2 or 2wheel to 4, you should be traveling in a straight line, let off the gas, change in or out of 4x4, resume driving. 4x4 low range requires a complete stop to engage.

Oct 15, 2009 | 1992 Dodge Dakota

2 Answers

Oil light goes on...had a dry stick 4 1/2 qts put in. no oil on ground. after oil change light went on at 70 miles.. on 15 secs then off for 5 miles then on again 15 secs--- off 4 miles--off 3 miles- off 2...


if it's not going onto the ground, and it's not being burned, check the positive crankcase ventilation and the exhaust gas recirculation valves for oil seepage...also check your air filter, if its got oil on it replace the pcv valve.

Jun 19, 2009 | 2003 Volkswagen Jetta TDI

3 Answers

'93 Jeep Gr. Cherokee 4x4 switch warning


this switch does not switch the vehicle from 2 wheel to 4 wheel drive. Grand cherokee have a manual shifter for that. The 4x4 switch is on top of the transfer case and tells the driver information display what 4 wheel drive mode the Jeep is in. ex..if you have selectrac, in 2 wheel the rear wheels on the display will light up, in 4 wheel all 4 wheels will light up, in 4 wheel low it will have the word low lit up in yellow. This is the only purpose for this switch and a bad one will not affect the functioning of the 4 wheel drive. Check out Rockauto.com and a new one can be purchased for about 35 dollars. If you call the dealership and ask for a 4 wheel drive switch, they will have no clue what you are talking about. The actual name is " 4WD indicator light switch"

Feb 22, 2009 | 1999 Jeep Grand Cherokee

1 Answer

1995 gmc jimmy 4x4 4.3vortec lifter noise


it sounds like your losing oil pressure you might want to get it checked dont believe the pressure guage on the dash they arent right all the time

Jun 14, 2008 | 1995 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...