Question about Cars & Trucks

1 Answer

Hoe do you remove packaging - Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 8,375 Answers

On what?

Posted on Dec 04, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1997 Chrysler town & country van. It want shift out of 1st gear. I don't have the codes on hand that I was given.. But I remember the guy explaining that it was a shifter switch problem In the...

The solenoid package is mounted at the front of the transmission. You have to remove the transmission cooler lines and a sensor. Three bolts remove the package. Before removing it, clean all around it. Air works the best. A lot of dirt gets behind it, between the package and transmission. You absolutely can not get any dirt in the holes after you move the package. This will cause a jam in the pistons inside the transmission. Then it has to be pulled and cleaned. The package can run up to $300 at parts stores, shop around. Seen them new on ebay for half. DON"T buy a used one. The package has one plug on it, with a bolt in the center of it.

Jan 17, 2015 | 1997 Chrysler Town & Country

1 Answer

Hoe to replace dash pad on 64 Impala

I had a 1965 El Camino and it had either 3/8 or 7/16 nuts holding it on from under the dash. You may have to remove the glove box and the instrument cluster to get to the nuts.

Oct 21, 2014 | Chevrolet Impala Cars & Trucks

1 Answer

Ignition cylinder removeal

Put key in turn key to on position pull cylinder out turn key back and remove key. Thats how I did it on my 94.

Apr 28, 2013 | 1995 Dodge Ram

1 Answer

Hoe to remove gage

You have to pull the cluster out. Gauges are usually affixed to the back of the cluster.

Feb 20, 2013 | 1997 Ford Mustang Cobra

1 Answer

Hoe do you replace horn?

the horn is located under the battery, to make it easier, you should remove battery and then remove the battery tray and the horn is there with a two wire connector. thats the problem with this truck you have to do almost a complete tear down to do any kind of work on this truck.

Jan 16, 2011 | 1998 Ford Explorer

1 Answer

Are nissan pathfinder discs held on the hub by the six road wheel studs or by the castalated nut and split pin.

It is a flowing brake rotor, remove wheel, then remove caliper and caliper mounting braket, rotor will slide right of. Hoe this helped good luck.

Nov 27, 2009 | 2005 Nissan Pathfinder

1 Answer

Hoe do you change spark plugs in a 2001 intrugie

Remove the ignition coil assembly
than remove the spark plugs, the rear ones will be tighter spot but still doable. Measuge the gap to 0.06in and torque them ti 15 lb/ft

Oct 11, 2009 | 2001 Oldsmobile Intrigue

1 Answer

Change the running light on a 2008 Tahoe

remove the clips that hold the head lights then you can remove the lenses for the DRL and remove the bulbs.

Aug 02, 2009 | 2000 Chevrolet Tahoe

1 Answer

Hoe do you remove the harmmce balancer

you need a balancer puller or a pully puller.most any parts store should have what you need. hope i helped..

Jul 06, 2009 | 1983 Ford Ranger

1 Answer


you may need a puller to remove it if there are no bolts parent on the back side of the hub, there might be a a bigger nut on the backside, may have to remove steering components

May 19, 2009 | 2007 Hyundai Sonata Limited Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15273 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides