Question about Cars & Trucks

1 Answer

I got ,my bill and it saids I have a 0.00 balance

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 46,416 Answers

And you want to complain about that

Posted on Dec 04, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How long can you keep a car a mechanic shop before paying off a full balance

Every shop is different. I suggest calling them to find out. ^^

Sep 09, 2015 | Cars & Trucks

1 Answer

Why does steering wheel shimmy from 48 to 55 mph and also jumps up and down frequently?

The most common issue is tires and you said that it was speed balanced? How long ago? By whom? When tires are balanced there are weights that are clamped to the rim. If the weights are loose and fall off, the balance does no good. The speed is another issue, tires are balanced for a certain speed and until you reach that speed, it is usually not in balance. Lastly it could be brake rotors or a CV joint or bearing that is bad.

Aug 17, 2015 | 2006 Chevrolet Cobalt LT

2 Answers

How do I get the harmonic balancer off a 2007 jeep compass

According to JeepForum: Jhanna said, "Just did mine last month to replace the output shaft ". bolts are the trick. I did not have long enough 6mm bolts, so I ran a 1/4" tap through the 3 holes. A lot easier than I thought, 6mm is just a bit smaller than 1/4", so it went fast.

Then 3, 2" long 1/4" bolts. I bought each bolt up until tight, then turned each bolt a couple of turns in order, once it started moving, went pretty smooth. I guess if yours are bending, use grade 8.

May 10, 2015 | Jeep Cars & Trucks

1 Answer

Opel corsa WDO engine timing marks

Timing marks are always on the harmonic balancer,that;s what the pullys blot to that drive your belts.Once you've found said marks by turning the crankshaft pullys by hand,using the belt to do so,scribe said proper timing mark with a white paint pen.Match that mark with the tab on the engine block at the harmonic balancer.Pacience my friend.

May 11, 2014 | 1998 Mazda Pickup

1 Answer

I have a1999 Cruck 1500 series that registered codes po446 and po281. can these be dealt with without a huge "fix it" bill?

P0446: Conditions for Setting the DTC The VCM fails to detect a drop in the EVAP system vacuum over a calibrated number of seconds with the vent solenoid open.

DTC P0281 Cylinder 7 Balance System

Conditions for Setting the DTC
• Amount of fuel reduction for a specific cylinder exceeds limits (internal to PCM). • Conditions met for 2 seconds.

Iffy on this one - your repair bill could be 2.5 hours, or it could be 10...depends on what is causing them to set.

Apr 21, 2011 | 1999 Chevrolet Silverado 1500

2 Answers

I have a 2002 aztek in the shop with a leak in the intake manifold gasket. the mechanic wants to also remove the heads and check and balance them. this increases the bill by about 500 bucks. should this be...

never heard of check and balance a head. I would ask him what he's trying to fix. What were your symptoms/reasons for pulling the intake manifold?

Sep 28, 2010 | 2002 Pontiac Aztek

3 Answers

I got 2 used tires on the front. Now it vibrates like you are on a gravel road. The steering wheel also vibrates. It is a smooth ride til you reach 60 mph or more. Some people said it is bad tires and some...

Sounds like they did a lousy job at balancing them or did not balance them at all. This is where I would begin. It could be a faulty bad tire if the balance checks out.

Jan 04, 2010 | 2004 Chevrolet Impala

1 Answer

I have a Kia Sportage 4wd 2002 with under 60000 miles. I lost power steering and when I took to mechanic they said I threw a belt(which they replaced with great difficulty) due to a bent or warped harmonic...

I got stuck paying dealer for new crank pulley not harmonic balancer as mechanic said. I am driving as little as possible until part comes in and can br put on. Hopefully, I will not damage the crank shaft or throw a belt.

Nov 05, 2009 | 2002 Kia Sportage

1 Answer

Can A Noisey (noise has only been happening for a pprox. 2 weeks. and only driven acouple miles to work)Harmonic Balancer Damage A key? I had a noisey harmonic balancer, went to a local garage, they...

yes it should have been looked at,It dont sound like your garage is being very honest with you,do you have all the tools you going to need like the puller ,to do the job,if you do its not to bad to do,I hope this helps you

Oct 06, 2009 | 1992 Pontiac Bonneville

1 Answer

Harmonic Balancer and fuel pump.

435 ONLY if it came from dealer. harmonic balancer can be a costly job. ask your mechanic to see the bill that he paid for the pump. just looking at interent i see pepboys has fuel pumps for 200

Dec 28, 2008 | 2004 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides