Question about 2002 Pontiac Montana

Open Question

I have a 2002 pontiac montana I need to know where to connect the wire's to on the starter?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Looking To Recharge The AC in a 2002 Pontiac Montana

the low port is between the engine and the radiator support and the high pressure port is by the cruise controll module

Posted on Sep 10, 2008

  • 7 Answers

SOURCE: Pontiac Montana starting problem

All 4 power wires go together on the large center stud on the solenoid.
The purple wire goes on the small stud.
The purple wire supplys the trigger signal when the key is turned to the start position.Since your solenoid is clicking when the key is turned to start this is working properly.
I would check battery connections and then check power connections on solenoid again.Make sure all connections are clean and tight.

Posted on Dec 03, 2008

  • 2920 Answers

SOURCE: 2002 Pontiac Montana Thermostat replacement

check the coolant level fiirst...if that is low it wont give you any heat.....to change the thermostat you have to follow the top radiator hose to the engine.at the send of it you will see a clamp take it loose...then you will see the thermostat housing its held in place by 2 bolts . once you remove them you have the thermostat....make sure you clean all the old gasket material off both the housing and mount.also make sure you get a new gasket.

Posted on Jan 29, 2009

  • 104 Answers

SOURCE: need to replace starter

should be 2 bolts 15mm and then 2 nuts on the starter 13mm and 8mm. this is a very easy starter to do. make sure you remover ground battery cable before doing this starter.
good luck,
michael

Posted on Apr 29, 2009

tse22
  • 103 Answers

SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana

On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the starter relay locationed on 2002 pontiac montana


Starter Relay
Right side of engine compartment on the radiator support, inboard of the underhood accessory wiring junction block
Near the battery .

May 01, 2017 | Pontiac Cars & Trucks

1 Answer

Can't remember where wires go on starter motor on my Mercedes w203 C200 CDI 2004


Your listing shows a 2000 Pontiac Montana...your question relates to the Mercedes? On the Pontiac, there are only 2 wire connectors to the engine starter motor...They use different sizes to match the connecting wires...

Nov 01, 2013 | 2000 Pontiac Montana

1 Answer

Wondering if I can change the starter on my 2003 Montana with a starter from a 2002 Montana?


PUT A BREAKER BAR ON ENGINE CRANKSHAFT BOLT AND SEE IF YOU CAN GET THE ENGINE TO TURN OVER BY HAND,IF IT WONT TURN, SOUNDS LIKE SOMEONE SOLD YOU A EHICLE WITH A LOCKED UP ENGINE. GOOD LUCK!!!!1

Jul 21, 2013 | 2003 Pontiac Montana

1 Answer

BACK FIRING, WIRES WERE NOT PUT IN CORRECTLY. I NEED A FIRING DIAGRAM FOR THE 2002 PONTIAC MONTANA


2002 Pontiac Pontiac Montana 3.4 liter V-6 VIN "E"

50c170e.gif

Hope helps (remember rated and comment this).

Jul 15, 2010 | 2002 Pontiac Montana

1 Answer

SPARK PLUG FIRING ORDER


2002 Pontiac Pontiac Montana 3.4 liter V-6 VIN "E"

4f18795.gif


Hope helps (remember rated this).

Jul 15, 2010 | 2002 Pontiac Montana

1 Answer

2002 pontiac montana wont start battery tested good vehicle completely dead no lights, radio, etc. Ground connection good termenals clean. Would alternator be the next thing to try???


no Alternator wont stop it from starting or rolling over as long as good battery...try connections on starter..that would be what i looked for first

Mar 05, 2010 | 2002 Pontiac Montana

1 Answer

Hi i have a 2002 montana van battery is full charge cleaned battery terminal when i try to start it it nothihg the ligts go out like a bad ground also the cluster quite same time


It is a bad connection somewhere, check to make sure the wires are tight at the starter. If that doesn't work try using a jumper cable to go from the neg terminal of the battery to a bracket on the engine.

Aug 05, 2009 | 1999 Pontiac Montana

1 Answer

Replaced starter because of clicking sound which made me think it was the solenoid. Battery tested okay. Now it clicks some but eventually starts. Is it the starter relay and were is it located. The...


Check that battery connections are clean and check engine ground. Also find what's clicking and make sure it's well connected and working (likely the relay you are looking for.)

Jun 15, 2009 | 2002 Pontiac Montana

1 Answer

Changing the starter solenoid on a 2000 Pontiac Montana


On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

May 12, 2009 | 1999 Pontiac Montana

1 Answer

Pontiac Montana starting problem


All 4 power wires go together on the large center stud on the solenoid.
The purple wire goes on the small stud.
The purple wire supplys the trigger signal when the key is turned to the start position.Since your solenoid is clicking when the key is turned to start this is working properly.
I would check battery connections and then check power connections on solenoid again.Make sure all connections are clean and tight.

Nov 06, 2008 | 2000 Pontiac Montana

Not finding what you are looking for?
2002 Pontiac Montana Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...