Question about 1998 Chevrolet Camaro

1 Answer

98 Camaro dipstick tube I have it out and I can't find where it goes back to

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,585 Answers

Usually goes in the third hole of the exhaust manifold..

Posted on Dec 03, 2016

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pookiebearlu
  • 15 Answers

SOURCE: dipstick tube leaking

cheek to make sure its not over full also the trans lines r right there make sure it not them spayin over after all u just did the motor and the trans was most likly hangin

Posted on Nov 27, 2009

  • 376 Answers

SOURCE: Engine oil dipstick tube has

The dipstick tube should go back in right above the oil pan flange.If its a front wheel drive it will be in the front of the motor a little left of center in the block above oil pan flange.Trucks are in the same place but vary on which side its located on.

Posted on Feb 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dipstick tube


Should just push back in have a good look and see where it goes

Oct 18, 2013 | Toyota MR2 Cars & Trucks

1 Answer

Dipstick go


make sure,to start,you didn't put the wrong dipstick (transmission or oil)in. Try,if the correct dipstick,removing the stick all the way out then twist so it faces the other way then ease it into its fullest making sure the end where you hold it from goes all the way too.

Aug 03, 2013 | Toyota Caldina Cars & Trucks

1 Answer

My eldery neighbor pulled the dipstick tube out in a 2001 ford escape where does it go back in


Actually, the dipstick fits into a metal tube and that tube can be found (usually) at the front or side of the engine. The tube diameter is approximately equal to the width of the dipstick. There aren't very many tubes under the hood that match that description

Jan 05, 2013 | 2001 Ford Escape

1 Answer

Where is the dip stick to check the transmission fluid on my 1995 Camaro?


The rear wheel drive gm's, Faceing the front,dipstick tube just behind the left side of the engine,and crouded there in front of the firewall. Check the fluid level with the engine warm, idleing in park.Pull the dipstick ,wipe it dry and insert it back,pull out and check the fluid level ,it should be on the full mark,if not add some,a cup at a time,careful not to add too much. ,

Sep 17, 2010 | 1995 Chevrolet Camaro

1 Answer

I need to check the ATF, and need to know how/where to refill if it is low. I have the '04 Kia Optima LX. Help appreciated greatly. Thanks.


Run the car long enough to fully warm up both the engine and the transmission.

Remove the transmission fluid dipstick, dry it off with a rag, paper towel or napkin. Wait a little (maybe o seconds) for the fluid that was on the tip of the stick as you removed it, and which might have been deposited on the inside walls of the tube the stick goes into to seep back down into the transmission. While you have the stick out and dry, familiarize yourself with the markings on it.

Put the dipstick into the tube, and fully seat it; make sure it is all the way in the dipstick tube.

Pull the stick out, and read the level of the fluid on it.

If transmission fluid is required, pour it into the tube the dipstick goes in.

Aug 05, 2010 | 2004 Kia Optima

1 Answer

Dipstick tube leaking


cheek to make sure its not over full also the trans lines r right there make sure it not them spayin over after all u just did the motor and the trans was most likly hangin

Nov 15, 2009 | 1998 Chevrolet Blazer

3 Answers

Cannot find the transmission fluid port to add fluid.


Hi Clark,

The Transmission Fluid goes in the tube that houses the transmission fluid level dipstick.

I know, looking at the tube, it sounds insane. A long narrow funnel made specifically for this purpose is sold at auto parts stores.

Best regards,
Mike

Sep 30, 2009 | 2001 Isuzu Trooper

1 Answer

Dipstick tube came out and i cant find the hole to put it back in


Some times the tubes rot off. Make sure you look where the tube pulled off the block there's a small hole on the side of the block the tube goes into. If it rotted off you will have to replace it just make sure you get the other piece out of the hole.

Mar 24, 2009 | 1995 Pontiac Grand Am

1 Answer

I have a 98 plymouth voyager van. I need to add automatic transmission fluid. I see the dip stick, but do not see where to add the trans. fluid. Thanks Larry


The Fluid Goes into the Dipstick Tube. You will need a Funnel for this. Please Rate my Response, I need all the Help I can get! Thanks!

Jan 26, 2009 | 1998 Plymouth Voyager

Not finding what you are looking for?
1998 Chevrolet Camaro Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...