Question about 2000 Lincoln LS

1 Answer

The Grab Hold is loose on one end of passenger front door.

I need to remove the door panel on my 2005 Lincoln Town Car. Has crash bag in door so I need to be careful not to explode it..

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Put on a football helmet then disconnect the battery for about 15 minutes. remove panel tighten handle reconnect battery, start car and last but not least remove your helmet

Posted on Jul 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What problem can be caused by an air bag light being on in our 2005 Lincoln Town Car


Believe it or not, but 99% of time it is a faulty seat beat. At the dealer they run around $600.00.including labor. Even if you get your machanic to install it ford charges around $300.00 for the seat belt. Your best bet is to try a auto junk place and see if you can find a color that matches you're..Hope this has been helpful..

Jun 11, 2014 | 2005 Lincoln Town Car

1 Answer

Air bag code 33 for a 2005 lincoln town car


2005 Towncar SRS Code 33 (3 flash + 3 flash, repeat this set for twice. then Beep 5 times pause x 5 = 25 beeps every 30min).

This means you have problem with left (Driver) side pretentioner (Seat belt retract system).
It doesn't mean physical belt or retract mechanism.It is just bomb wiring which is part of airbag system.
When airbag deploy, passenger must stay tight in seat otherwise body lean to front then slam back to seat by airbag.
if belt is loose or delay to lock, passenger's body rocks back and forth.So, system use small bomb (Fire power) to lock and retract seat belt when airbag deploy.There is small bomb and igniter in part of Seat belt retractor.
Code 33 is warning for this part on 2005 Towncar.(older model is different meaning in Ford/Lincoln, it's possibly passenger side airbag system for earlier model)
Before you work for any part of Airbag system and touch any "Yellow connector", * *Disconnect battery (negative side is good enough) and wait at least 5 min to clear all power in system**.(Airbag store back up power for few minutes to be able to deploy even in case if power disconnected)
by the way, you should move your driver seat most forwarded position before you disconnect battery to make it easy to work with seat belt.
locate driver side seat belt retractor (in center pillar between front and rear door, you may have to fight with weather strip)

Locate Yellow connector on bottom of Seat belt retractor (it's called "Pretensioner")it is located on very bottom of rear side of retractor.
only one yellow connector. (make sure your battery is disconnected)
Check its physical connection or looseness.if connection looks fine, you may have to replace whole seat belt ($180-$200 in Lincoln dealer)
You can check if pretensionor is good or bad by regular tester, but unless you know how, I won't tell (because I don't wan't you to blow out pretentionor).








Jul 19, 2012 | 2005 Lincoln Town Car

1 Answer

2003 Lincoln Town Car - Power window switch removal/installation


SECTION 501-05: Interior Trim and Ornamentation 2003 Town Car Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/28/2002 Front Door Trim Panel adobe.gif Printable View (206 KB) Removal and Installation
NOTE: LH side shown, RH side similar.
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
  1. Remove the window switch plate.
    a0045307.gif
  1. Disconnect the electrical connectors.
    a0044981.gif
  1. ani_caut.gif CAUTION: Use care not to damage the trim panel covers.
    Open the screw covers.
    a0045817.gif
  1. Remove the screws and the assist handle.
    a0045818.gif
  1. Remove screws and the front door trim.
    a0045819.gif
  1. Disconnect the electrical connectors.
    a0045834.gif
  1. To install, reverse the removal procedure.

2010&c18=modelyear&c20=n306887&c35=wsm%2cfront%20door%20trim%20panel%2cs3g%2c501-05%2cremoval%20and%20installation&s=1600x900&c=32&j=1.3&v=y&k=y&bw=1171&bh=582&ct=modem&hp=n&[aqe]

Apr 02, 2010 | 2003 Lincoln Town Car

1 Answer

I have a 2000 Lincoln Town Car that the passenger window will not go down. I have power at the switch but can't figure out how to take off door panel to access motor to test.


FIRST REMOVE THE DOOR LOCK OPERATING KNOB , SLIDE OUT THE SPACER BEHIND THE REGULATOR HANDEL AND REMOVE THE HANDEL FROM THE SPLINES , UNCLIP THE TRIM COVER FROM THE DOOR AND REMOVE IT FROM DOOR , UNSCREW DOOR HANDEL SCREWS, LEVER BETWEEN THE DOOR TRIM PANEL AND THE DOOR TO RELEASE THE TRIM PANEL STUDS.

Nov 01, 2009 | 2000 Lincoln Town Car

2 Answers

AC needs a charge and how do I take the inside door panels off?


the a/c fitting are under the hood. they should be along the passenger side of the motor near the fire wall. don't put any r134a with sealant in it. only pure R134A.

Aug 06, 2009 | 1996 Lincoln Town Car

1 Answer

How do i remove the front drivers interior door trim. I need to resecure the door lock to the door frame on the 2001 town car


remove any screws you see, including the plate and screws by mirror, and remove lock and window controls, then take a big flathead screwdriver or pry bar and pry around the panel exactly next to the plastic screws pins that hold panel on door. After door is completely loose, then lift up and pull off.

Jul 20, 2009 | 2001 Lincoln Town Car

1 Answer

How to remove the inside left side front door


Snap out two door pull strap retaining screw covers. Remove screws.
Remove screws on front, rear and center of front door trim panel.
Using the Trim Pad Removing Tool or equivalent, pry the trim panel retaining clips from the door inner panel.
These are plastic so be careful you can use a pair of needle nose pliers if you don't have a trim tool.Just start at bottom of door panel and work your way around and up.

Mar 06, 2009 | 1997 Lincoln Town Car

Not finding what you are looking for?
2000 Lincoln LS Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...