Question about Cars & Trucks

2 Answers

2005 Silverado brake lights on tail not working, cruise out , bulbs and fuses ok

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 11,458 Answers

The STOP LP 25-amp fuse in the underhood fuse block supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the STOP 15-amp fuse and the center high mounted stop lamp (CHMSL) 10-amp fuse in the instrument panel (I/P) fuse block, and to the turn signal/hazard module. The turn signal/hazard module then supplies voltage to both of the trailer rear turn/stop lamp supply voltage circuits. The voltage from the CHMSL 10-amp fuse is to the CHMSL and the trailer jumper harness. The voltage from the STOP 15-amp fuse is to the stop lamps, throttle actuator control (TAC) module, and the cruise control.

Posted on Dec 03, 2016

  • Jeff Armer Dec 03, 2016

    Do the center high mount stop lamps work when you step on the brake pedal ? If so it's not the brake light switch !

×

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 21 Answers

Brake light switch? The cruise and brake lights problems are likely related. The cruise control cuts out when you press on the brakes. I had a van where the cruse wouldn't engage. Then someone pointed out my brake lights were always on. It was the switch.

Posted on Dec 03, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 05 Audi a4 the headlights, tail lights, brake lights and windshield wipers want work what could be the problem?


have you checked your fuses headlights ,tail lights and brake lights are all on one fuse .then if the fuse is ok check to see if the bulbs are all ok.better still replace them.and then do the same as for the fuse for your wipers

Jun 10, 2015 | 2005 Audi A4

2 Answers

Why wont the cruise control work on a 2005 ford taurus but the cruise light comes on


The first thing to check is the tail lights. The cruise control will not work if any lights are out. Changing to LED tail lights also causes the cruise to not work.

Apr 06, 2014 | 2005 Ford Taurus

1 Answer

Brake lights are out, the cab brake works but not the tail ones. Bulbs are good cause turn signal works, fuses don't appear bad and need to ck brake switch and replace to see if fixes. Please help!!!


THE FUSE FOR THE BRAKE LIGHTS MAY BE LABELED " STOP ". GM USES BRAKE FUSE FOR THE " ABS " HOWEVER, THE FUSES NEED TO BE TESTED WITH A FUSE / CIRCUIT TESTER, IN THE FUSES BOX UNDER THE HOOD & THE FUSE BOX INSIDE THE VEHICLE.

Jan 09, 2011 | 2005 Chevrolet Silverado

1 Answer

MY BRAKE LIGHTS DONT WORK, THIRD BRAKE LIGHT WORKS, FUSE IS GOOD BULBS ARE GOOD AND NEW BRSKE SWITCH, TAIL LIGHTS WORK???


you have a broken wire some were if you cant find it you can run a seperate power wire from the third brake light to the brake lights but i would check for power at the brake lights first to make sure its not a ground problem

Jan 11, 2010 | 2005 Chevrolet Silverado 2500HD 2WD

1 Answer

Cruise control just quit. Fuse is OK


check your tail light and brake light. i had a brake light to go out and when i replace the bulb the cruise worked

Jul 02, 2009 | 2002 Chevrolet Impala

1 Answer

Rear brake lights don't work


you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok

May 23, 2009 | 2005 Chevrolet Silverado 2500HD 2WD

4 Answers

Cruise control will not 'set' on '05 kia sportage


Check the brake lighf bulbs. If even one is burnt out, it throws the sensors.
Had the same problem replaced both bulbs and now the esp light stays off and the cruise control sets.

Mar 15, 2009 | 2005 Kia Sportage

1 Answer

2002 YUKON XL Denali no brake lights or cruise


FROM LUSTY KID:

Check your bulbs first, I have lost both headlights on my ford at once on account of the bulbs burning out at the same time. Same thing probably happen, you have one filament out. The lights can work, but if the filament for brake is burnt, you don't see brake lights.

As for the cruise control. Check fuse box first. If OK check vacuum hose to actuator in engine compartment for starters.
Advise:

Oct 12, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...