Question about 2002 Pontiac Grand Am

Open Question

Where is the VSS located on 02 grand am se 2.2 ecotec

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 91 Answers

SOURCE: GRAND AM 97 VSS LOCATION

The vss is mounted on the rt axle shaft housing at the top of the housing on an automatic and man trans.

Posted on Feb 24, 2010

Ad
parkerjohn
  • 132 Answers

SOURCE: can't find the vss on

You have one at each wheel. If you jack up the car look behind the dust shield and you will see it. usually held in with a single bolt.

Posted on Sep 15, 2011

  • 35 Answers

SOURCE: 02 Pontiac Grand Am 2.2L Ecotec hesitation

Unfortunately, I have the same problem with my 2003 Pontiac Grand Am. Regarding the emissions, it is just a matter of elimination. So far, I've replaced the sensors related to the fuel system but my car's hesistation stills exists. Midas did a smoke test and revealed no leaks. Checked the cylinder heads. Had the tranny replaced. New fuel pump & filter.I suspect that it could either be my computer or a loose wire somewhere. Anyways, I share your frustration. Good luck

Posted on Feb 28, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 Grand Am VSS location


Vehicle Speed Sensor (VSS)
At the rear of the engine/transaxle
Connector Part Information
?€¢
12162195


?€¢
2-Way F Metri-Pack 150.2 Series Pull to Seat Sealed (BLK)

Pin
Wire Color
Circuit No.
Function
A
PPL
401
Vehicle Speed Sensor (VSS) Return
B
YEL
400
Vehicle Speed Sensor (VSS) Signal
Two wire connector !

Aug 09, 2016 | Cars & Trucks

1 Answer

02 chevy cavalier 2.2 ecotec engine won't start


how old is your battery? that might be it also.

Mar 16, 2013 | 2002 Chevrolet Cavalier Coupe

1 Answer

2.2 ecotec po300


If there is severe misfire then gaz go into exhaust Stream then burn Inside the converter that's why it glows red
need to fix the misfire , plugs, wire , or coil
hope it help

Jan 06, 2013 | Pontiac Vibe Cars & Trucks

3 Answers

02 Pontiac Grand Am 2.2L Ecotec hesitation


vacuum leak...bad air inlet hose at throttle body...underside...may also have bad motor mount

Sep 03, 2012 | 2002 Pontiac Grand Am

1 Answer

My speedometer doesn't work, where is the wire located? it's a 2003 grand caravan se.


Your speedometer is controlled from your transaxle which is controlled by the computer. Usually a bad VSS sensor causes the speedometer malfunction. Are you getting any codes?

Jun 22, 2011 | 2003 Dodge Caravan

1 Answer

1997 honda accord se need to change vss,where


For 1997 Honda Accord 2.2L MFI 4cyl the Vehicle Speed Sensor - Location is located mounted on transmission.

OPERATION
The Vehicle Speed Sensor (VSS) is a magnetic pick-up sensor that sends a signal to the Powertrain Control Module (PCM) and the speedometer. The sensor measures the rotation of the output shaft on the transaxle and sends an AC voltage signal to the PCM that determines the corresponding vehicle speed.



TESTING
  1. Disconnect the negative battery cable.
  2. Disengage the wiring harness connector from the VSS.
  3. Using a Digital Volt-Ohmmeter (DVOM), measure the resistance (ohmmeter function) between the sensor terminals. If the resistance is 190-250 ohms, the sensor is okay.
REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable.
  2. Disconnect the three terminal connector from the vehicle speed sensor (VSS).
  3. Remove the fasteners that secure the VSS to the transaxle housing assembly.
  4. Remove the VSS.
To install:
  1. Install the VSS.
  2. Install the mounting bolts.
  3. Connect the three terminal connector to the sensor.
  4. Connect the negative battery cable.
Hope helps (remember rated this).

Jul 16, 2010 | 1997 Honda Accord

2 Answers

GRAND AM 97 VSS LOCATION


The vss is mounted on the rt axle shaft housing at the top of the housing on an automatic and man trans.

Feb 24, 2010 | 1997 Pontiac Grand Am

1 Answer

Lifters are chattering real bad


teh engine probably ruined the bearings id look for a used motor

Aug 26, 2009 | 2002 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...