Question about Cars & Trucks

Open Question

Where is the feul pump relay in a 1985 240volvo sadan

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: feul pump won't run (new

My 88 ramvan did the same thing and it was the pickup sensor in the distributor. I replaced it and everything was fine. If the sensor is bad it won't let the fuel pump run or the ignition funtion.

Posted on Aug 06, 2008

  • 22306 Answers

SOURCE: 2000 ford focus

factory immobiliser cut in ,,dealer only sorry about being the harbringer of bad news,hope your preparing to lay the golden egg minium charge in spain is 180€ but iam hearing reports for renaults of 220 upwards and one of nearly 400 today

Posted on Nov 22, 2008

  • 8 Answers

SOURCE: 2000 ford focus new feul

Try the crankshaft position sensor. Sometimes they get covered in clutch dust and the sensor cannot determine No1 cyl. and then it will refuse to start. Sometimes they go faulty as well.

Posted on Nov 23, 2008

  • 437 Answers

SOURCE: Is not getting any fire

check the ground wires to main relay also check main fuses

Posted on Feb 10, 2011

  • 39 Answers

SOURCE: Where is the feu. Pump relay in a 1985 240 4 dr volvo sadan

Posted on Dec 07, 2016

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ingnitionfuse and relay checked its ok.fuelis not coming to injectors during crank .pls give a proper solution

the feul filter get a book and look were its located but it wouldnt be the ignition fuse it would be feul pump fuse when u turn the key in on position not starting the car youll hear the feul pump at the back of car kick on if u dont hear it replace the feul pump if it dose then its ur coils

May 17, 2013 | Cars & Trucks

2 Answers

Feul pump

Sounds like vapor lock. Leave the cap from the gas lid undone for a little while.

May 05, 2013 | Cars & Trucks

1 Answer

Where is the feul pump relay located on 1992 s10?

Here's where it's at. here's what it look's like.

Feb 17, 2013 | Cars & Trucks

1 Answer

Cranks but wont start

Someone will need to check the circuit at the pump to see if it is getting power from the relay. If it is the pump should be running when you first turn the key on.
You can also check for power at the pump relay.

Dec 13, 2012 | 2000 Ford Windstar

1 Answer

I have a 1993 Chevy 1500 Silverado 5.7 worked. I changed the feul pump and feul filter. When you turn the ignition to the on position you do not hear the feul pump engage and there is no feul pressure at...

Yes, it can be the relay. What I do is unplug the relay and swap it gor yhe horn relay. If this doesn't work, I use a volt/ohmmeter to probe the relay socket. Doing this, I can usually find the problem. With the key on , there should be two terminals in the socket that have battery voltage and one that is grounded. The last terminal goes to the pump and should show low ohms to ground. In your truck, the relay coil is connected to ground and turned on by the ecm with a positive signal. It also seems to depend on the oil pressure switch, so you might want to temporarily bypass the switch with a paper clip in the connector to see if that is keeeping the pump from running.


Aug 10, 2017 | 1993 Chevrolet K1500

1 Answer

Is not getting any fire to the feul pump,I have an new feul pump and main relay.

check the ground wires to main relay also check main fuses

Feb 10, 2011 | 1993 Honda Accord

1 Answer

The gas pump burn,replace with a new pump,and not getting any electricity coming to the feul pump.all feul pump is ok.

Check this 3 items in this order efi fuse, efi, relay, circuit open relay.all of them in the engine compartment's fuse box.

Dec 23, 2010 | Toyota Corolla Cars & Trucks

1 Answer

No power in fuse box for fuel pump

If there is no power to the fuse block then there has to be a main relay check that to see if it is blown. it is usualy located in the fuse block undr the hood.

Jul 28, 2009 | 1997 Cadillac Catera

1 Answer

Feul pump won't run (new feul relay and feul pump)

My 88 ramvan did the same thing and it was the pickup sensor in the distributor. I replaced it and everything was fine. If the sensor is bad it won't let the fuel pump run or the ignition funtion.

Jul 23, 2008 | 1988 Dodge B Series Cargo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides