Question about Mitsubishi Cars & Trucks

1 Answer

How to replace ingnition coil and s park plug mitsubishi montero v6 1994

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 1,335 Answers

Coils normally screwed down. Remove screws and pull upward. This will give you access to plugs.

Posted on Dec 02, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1078 Answers

SOURCE: Replace Spark Plugs on a Mitsubishi Montero Sport 2001

http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%090900c15280213e6e&subtitle=service
Try to copy and paste this web site. It's for Auto Zone. It will tell you all you need to know about your vehicle.
Good Luck and hope this helps.

Posted on Apr 17, 2009

  • 145 Answers

SOURCE: i have a 1990 geo prizm i parked it and the next

yes your ignition module can cause that but before you buy a new one you can take it to your local auto part store and get it test out of the car
there is a machine than can do that

but also a crankshaft position sensor or camshaft sensor can cause the same symptom.

Posted on Jun 30, 2009

mychkelbey
  • 12 Answers

SOURCE: HOw to replace spark plug wires on a 1998

Installing New Spark Plug Wires Is Simple, Especially Of One Wire Is Replaced At A Time. Compare The Length Of The Old Wire With The Length Of The New Wire. Replace Each Wire With One Of Equal Length.Make Sure The New Wire Is Fully Attached On The Plug And In The Distributor Or Coil Module.

Spark Plug Wire Replacement Is More Complicated If All The Wires Are Removed At Once.Then You Must Use The Engine Firing Order And Cylinder Numbers To Route Each Wire Correctly.

Posted on Apr 09, 2010

Beemdog
  • 2 Answers

SOURCE: A 1991 mitsubishi montero , recent dead battey and no park lights

Change or recharge the battery. Repair any exposed wires (insulation broken or worn off) on wires in affected circuit that may be shorting out and drawing current from the battery.

Posted on Apr 13, 2010

  • 4793 Answers

SOURCE: process for replacing spark plugs and wires on a

use a long socket for the plugs and only remove ONE at a time,that way you wont have to ask the most annoying question ever asked by an amatuer to a pro(which way do the wires fit,how stupid is that??)

Posted on Jun 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to wire up an ignition on a 1999 mitisubishi Montero sport


PDF]MITSUBISHI MONTERO SPORT 1997-2004 VEHICLE ...

alarmsellout.com/.../MITSUBISHI%20MONTERO%20SPORT%201997-...
WIRING INFORMATION: 1997 Mitsubishi Montero Sport. WIRE ... WHITE. IgnitionHarness. STARTER WIRE ... This must be bypassed when installing a remote start system. ... WIRING INFORMATION: 1999 Mitsubishi Montero Sport. WIRE.

Montero Sport Starting Problem - YouTube

? 2:35
https://www.youtube.com/watch?v=TZCbEmfi3JM
Nov 2, 2011 - Uploaded by aaron1969lopez
Im not sure what is causing me to have trouble starting myMontero Sport. ... 2001 Mitsubishi Montero Sport ...

1997-2004 3.0L V6 Firing Order -Ignition Coil Spark Plug ...



Dec 08, 2015 | Cars & Trucks

1 Answer

I have mitsubishi montero 2001,the problem is that its started shacking I mean the whole engine.


This usually means that there is a misfire that could be many things. Try replacing the spark plugs first. Then if the motor mounts are weak or worn out the shaking will be more noticeable. Recommend you replace the worn motor mounts.

Nov 19, 2014 | 2001 Mitsubishi Montero Sport 4WD

1 Answer

Where is the sparkplugs and how do I remove them


Follow the spark plug wires from the distributor cap, down to the block. This yahoo write up will help. If you have direct ignition (coil packs) then you will be looking for small blocks above each spark plug. Look for ignition coil packs at webites like oreillyauto.com for a visual of what you are looking for.
How do you change the plugs on 98 mitsubishi montero sport Yahoo Answers

Jan 31, 2014 | 1998 Mitsubishi Montero Sport

1 Answer

2003 mitsubishi montero 3.0 not firing number 3 coil


just had same problem and mitsubishi said replace computer which was false i replaced ignition control module and runs like dream

Dec 21, 2012 | 2003 Mitsubishi Montero Sport

1 Answer

Firing order mitsubishi 3.5


Mitsubishi Montero 3.5 V-6n24 valve

Looking from the front of engine to the rear on the passenger side 1-3-5
Looking from the front of the engine to the rear on the drivers side 2-4-6


The engine has coil over plug with coils only on the drivers side. The spark is shared via spark plug cables to the plugs on the passenger side. So If you are replacing the spark plug cables:

#2 cyl.coil drivers side shares spark with #5 passenger side-
#4 coil drivers side shares spark with #1 passenger side-
#6 coil drivers side shares spark with #3 cylinder passenger side.

Mar 17, 2012 | Mitsubishi Diamante Cars & Trucks

1 Answer

HOw to replace spark plug wires on a 1998 Mitsubishi montero sport?


Installing New Spark Plug Wires Is Simple, Especially Of One Wire Is Replaced At A Time. Compare The Length Of The Old Wire With The Length Of The New Wire. Replace Each Wire With One Of Equal Length.Make Sure The New Wire Is Fully Attached On The Plug And In The Distributor Or Coil Module.

Spark Plug Wire Replacement Is More Complicated If All The Wires Are Removed At Once.Then You Must Use The Engine Firing Order And Cylinder Numbers To Route Each Wire Correctly.

Apr 09, 2010 | 1998 Mitsubishi Montero Sport

1 Answer

On my 1991 mitsubishi montero the ingintion wire is not reciving power on the radio plz help


who ever hooked it up directly not to the ingnition switch or your fuse is burned out check it out

Jan 11, 2010 | 1991 Mitsubishi Montero

1 Answer

A 1991 mitsubishi montero , recent dead battey and no park lights


Change or recharge the battery. Repair any exposed wires (insulation broken or worn off) on wires in affected circuit that may be shorting out and drawing current from the battery.

Sep 20, 2009 | 1991 Mitsubishi Montero

3 Answers

How do I change spark plugs on a 2002 Mitsubishi Montero, and how long should they last? Thanks.


You have to remove the upper intake manifold to get at the wires and plugs. Mitsubishi recommends 60,000 miles for spark plug replacement, if you look in your owners manual they also want you to replacet the spark plug wires also. Timing belt also at 60K

Jul 13, 2009 | 2002 Mitsubishi Montero Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...