Question about Cars & Trucks

1 Answer

When changing gear on my 2007 Focus You can hear a clunk sometimes it will clunk when just cruising and when pulling away

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 374 Answers

Your engine and gearbox is has 3 mountings bolted to it.
With the bonnet open the 2 mountings to your left and right carries the suspended weight of the engine and gearbox.
Third mounting thats bolted to the bottom rear of the gearbox and bolted to the subframe is the one that takes care of the back and forward movement when accelerating and changing gear that one needs to be replaced

Posted on Dec 02, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 93 chevy van recently installed motor three months ago now when I start it up I get a vibe n humming sound coming from the front of tranny n when in gear n cruising the hum n vibe still there but...

recheck bolts on bell starter and converter. check universal joints. loose flywheel bolts could cause cracks in flywheel. remove dust cover when shaking see if flywheel is moving back and forward

Sep 14, 2017 | Cars & Trucks

1 Answer

96 Silverado that clunks when I accelerate, think it might be electrical 1day I had both feet on the brake& gas it did the same clunk1day it didn't &the clunk went away but so did cruise control

its a big truck
lots of things can go clunk when taking off
needs inspection up on a workshop hoist

cruze problem could be cruise control pedal cut off switch


Nov 25, 2016 | Cars & Trucks

1 Answer

Clunk under car on acceleration, but goes away after first initial clunk.

I would check the spark plugs and wires or coil packs. Sounds like the ignition system is arcing.

Sep 01, 2015 | 2007 BMW X3 3.0si

1 Answer

Focus 2011 1.6 engine - sings in low gears at about 2000 rpm

Only as guess, not being able to ride in your car & listen

Sounds like a drive train/transaxle whine

Maybe a problem,maybe not.

Most likely not the trans part, but the differential in there
& part of the transaxle

Sep 29, 2012 | 2011 Ford Focus

1 Answer

I have a 2002 ford focus and changed the drive axle on the drivers side and it wont drive now

if you mean wont pull off in gear . it's probaly the axle is not in the tranny far enough - you hear or feel a locking sound when it goes in . sometimes you have to push or hit them where they will lock

Nov 05, 2010 | 2002 Ford SVT Focus

1 Answer

Just started to pull away from a stop in 1st and

sounds as though your input shaft broke, this would cause a loud clunk, cause it to feel as though in gear, and cause no pull.

Oct 26, 2009 | 1988 Nissan Maxima

1 Answer

Ford focus slow at take off

clutch slipping change the clutch

Jun 10, 2009 | 2002 Ford SVT Focus

1 Answer

My automatic focus sometimes will not go into gear properly

This may be caused by fluid starvation from a plugged trans filter, also a shift solenoid inside the trans may be sticking, I would recommend u change the trans fluid and filter (required at 60,000 miles), also go to a Kragen auto or any chain parts store like it and ask to have a code test run on the powertrain control module , it is free.

Nov 12, 2008 | 2004 Ford Focus

2 Answers

2006 Ford Focus 1.6

Check throttle position sensor.

Jul 03, 2008 | 2000 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides