Question about Ford Cars & Trucks

1 Answer

Replaced airbag module in 2013 ford focus wont start ....any suggestions

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

It may need to be programmed to your vehicle. That takes a Ford factory scan tool.

Posted on Dec 02, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Airbag Light 2006 ford focus

The code indicates a problem in the driver airbag module, the common cause is the coiled contact drum under the steering wheel is defective, it is refered to as the "Clock Spring" Contact

Oct 27, 2017 | Ford Cars & Trucks

1 Answer

I have a trouble code 2013 Ford Focus titanium. P0320 any help.

Find the crankshaft sensor on the front of the engine next to the crankshaft pulley. Inspect the connector and wiring. If the electrical parts look good, the sensor is probably bad. Is the engine running?


Sep 03, 2017 | Ford Cars & Trucks

1 Answer

Our 2013 ford fusion titanium won't start doors won't even opened. It worked fine last night.

Still under warranty? Call FORD service. They may know exact problem. Sounds like a severe battery drain. don-ohio

Jan 09, 2017 | 2013 Ford Fusion

1 Answer

Whymy 2013 ford focus sometimes won't start i have dash lights and radio ?

Did you take it to the dealer ? Still under warranty .. Do you know the amount of electronics that are incorporated into that vehicle , control modules , C.A.N - controller area network communication's data bus etc.... An you want someone on here tell you the reasons why ! You should read up on it .A lot of testing is the only way to find these type problems . Videos on youtube for basic electrical testing , voltage drop testing etc.... Engine Won Crank or Start

Jul 27, 2016 | 2013 Ford Focus

1 Answer

My 2010 Ford Focus SE has started expirencing a problem with the airbag light remaining on, but only when the temperatures outside are warm. basically I have no issues driving to work in the morning when...

When the light stays on that means the system is not active and needs attention, why it is doing this only in hot weather? Most likely the Airbag Control Module is to hot to turn on, maybe

Jun 21, 2013 | Cars & Trucks

1 Answer

Air bag light on in 2008 ford focus

For the airbag light situation to be resolved you need the airbag code to be deciphered from a scantool that can read airbag codes,,If the alternator has low output it would turn on also the ABS light,If the car was flooded it is posible that the control module did short out its location in in the center bottom console

Aug 11, 2012 | 2008 Ford Focus

1 Answer

How to change driver airbag on a 2003 ford escape

go to for info on the airbag but you also need to repair your airbag computer after a crash the light wont go of you can also find a link on that website for airbag module repair only $50

Apr 16, 2009 | 2006 Ford Escape

1 Answer

Can i switch of the passenger airbag in my 2003 ford focus?

The passenger airbag is what is called a smart generation airbag, there is a sensor in the passenger seat that tells the airbag control module to turn off the bag if the weight is less than 50 pounds in the paswsenger seat, i.e. a child, I work for Ford and we will not turn off or tamper with or disconnect the airbag, why? if you get in a wreck and are hurt because we disconnected or otherwise defeated the airbag we would be liable for damages and a lawsuit.

Dec 05, 2008 | 2003 Ford Focus

1 Answer

Changing steering wheel on a 2006 Focus

You need to disconnect the battery and the airbag diagnostic control module in the dash, do not remove the airbag until this is done, if it goes off you will have a really bad day.

Oct 06, 2008 | 2006 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides