Question about 2006 Toyota Corolla

Open Question

2006 Toyota Corolla 140i,reset central locking and alarm systems

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 65 Answers

SOURCE: need belt schematic for 2006 toyota corolla

I can get you a diagram on monday but it goes from the alternator to the power steering pump then around the tensioner pulley then around the crank pulley then to the a/c compressor then pull on the tensioner to give you some slack and slip it on the waterpump.I hope that helps.Let me know if you still need the diagram

Posted on Nov 29, 2008

  • 20 Answers

SOURCE: How do I replace the fuel filter on my 2006 Toyota Corolla?

ITS A LIFETIME FILTER AND WITH REGULAR USE, SHOULD NEVER NEED TO BE REPLACED

Posted on May 24, 2009

  • 1 Answer

SOURCE: 98 toyota corolla radio, dome light, and power locks don't work

2005 toyota corolla radio,dome light,alarm and power locks dont work.

Posted on Nov 20, 2009

  • 13 Answers

SOURCE: can not lock car by key remote . toyota rav 4 53 plate

If your car has an alarm with a separate remote, it is a separate system and it is probably self-arming. When you lock the doors with the key central lock, the alarm gets armed by the RAV4 being OFF and the door locking action. When you unlock the doors with the key, the alarm is still armed because the key is not comunicating with the alarm just the cars factory keyless system.

Posted on Apr 10, 2010

  • 4793 Answers

SOURCE: How do you reset alarm

press and hold the unlock button for 30 secs.....

Posted on Sep 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 Toyota 140i manual transmission. Whilst waiting at the stoplight with the engine at idle ,the revs suddenly race up to 4000rpm & come down on its own. What could be the problem .


Following are the reasons for unstable engine rpm:
- Vacuum leak at intake manifold or Cracked intake manifold.
- Idle speed control valve is not re-learned.
- Weak cylinder compression or intake valve clearance is too low.
- Mass Air Flow sensor dirty or faulty.
- Fuel pump pressure is too low or high.
- Accelerator pedal sensor faulty.

Sep 30, 2016 | 2007 Toyota Corolla 140i

1 Answer

Corolla 140i 2004 won't start after a faulty engine was replaced with that of 160. Sensors of 140i are fitted all the instruments come on except for the amber light on the dash board


on Fixya you wont to learn swaps, really?
why not a real forum with sections on swaps.
like (random)
toytotanation (google that or google "toyota forums" bingo?

Feb 15, 2015 | 2004 Toyota Corolla

1 Answer

Does a 2006 corolla 140i have spark plugs


Hi,
Yes it does. I found a site with pictures detailing how to access the spark plugs for replacement. (recommended every 60,000 miles) Plug gap is 1.1mm. Remember to dissconnect wiring and replace plugs one at a time to eliminate the chance of connecting wrong wire to wrong plug position. Wiring must be connected exactly as removed. Check out his page, requires minimal tools and labor.....Please rate this answer! Thanks, Mike
http://bernardsblog.blogspot.com/2009/07/2005-toyota-corolla-18l-spark-plug.html

Jun 20, 2011 | Toyota Corolla Cars & Trucks

3 Answers

Toyota corolla verso 2007 . the central locking has stopped working


Toyota Corolla Verso - Central locking has just stopped responding


So you don't waste your time, here are some assumptions: -

1. When I press the key fob there is no sound of doors trying to lock/unlock and I know the key fob is fine.


Solution:


In this situation reset the alarm/locking system

Below is the procedure I followed to get the central locking working again: -

Open the passenger door, and look at the side of the dash board. There should be a triangular panel. Pull the panel off to reveal a small set of fuses(see the back of the panel for the fuse map). To power down the central locking you need to remove the Dome Light fuse, this is located top left. Second one down 7.5 amps. (if in doubt remove the top two 7.5 amp fuses I did)

When you remove the fuse(s) you will notice the interior light go out indicating you have powered down the system.

Now leave them out for at least 30 mins so any capacitors can discharge properly. (Be aware while the fuse is removed all central locking is disabled, so the other doors are open. I left the fuse(s) out over night with all the doors open but I don't recommend it, 30 mins should be fine)

After 30 mins replace the fuse(s) close all doors, and then try your key fob, hopefully you should here that satisfying locking sound.


2. When I press the key fob I hear the locking system trying to engage.

This could be a faulty door switch on any door including the boot, or there could be a dent in the inner door panel of any of the doors, usualy the rear doors due to the seat belt not retracting properly.

Solution:

Check all door switches for damage, and check inner panel for dents, just a small dent where the switch connects can be enough to not engage the switch. This will stop the central locking.

Use some kitchen roll wrapped in tape (as a makeshift pad) and tape to the inner door as a temp measure to engage the door switch. At least you can then lock the car.


Jan 04, 2011 | 2007 Toyota Corolla

1 Answer

2003 corolla driver side central locking motor struggling to lock the rest are ok. Got handsets checked but all good. Having same problem when I lock it from switch in car.


A locking system probably damage only at the drivers side. Contact a mechnic for an evaluation and estimates about faults to make possible repairs. The process would require parts, repairs and time to reestablish on the road once more.

Dec 03, 2010 | 2006 Toyota Corolla

1 Answer

Central locking not being activated by remote


somehow the car when on valet mode, go to a alarm shop , they should be able to re arm your car without to much damage to your pocket, or read your cars manual, it might inform you on how to fix the problem.

Sep 23, 2009 | 1998 Toyota Corolla

Not finding what you are looking for?
2006 Toyota Corolla Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...