Question about Dodge Ram 1500

1 Answer

My 1995 Dodge Ram 1500 4x4 auto trans wont kick in to overdrive when I am driving it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 34,193 Answers

Could be an open fuse, defective speed sensor, or defective switch

Posted on Dec 01, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 dodge ram 1500 5.9 360 overdrive kicks off and transmission overheats


when your trans hits 110 degrees C, it will do that by default. You MUST have the trans oil cooler checked for blockage, because this problem has led to seized parts on a few that I've rebuilt as a direct consequence. I have also installed auxiliary trans oil coolers on several Grand Cherokees which had this problem. high temperatures will kill your trans.

Mar 08, 2013 | Cars & Trucks

1 Answer

1997 dodge ram 3500, it shudders in OD


Hey, I also have a 98 ram with the cummins and what you are talking about is when you are pullin hard in overdrive the trans is working to hard causing the shudder, when this happens back off the throttle and get back on the throttle to allow the trans to downshift. If you dont it will break the overdrive gear. There is nothing wrong with the trans it is just that it is shifting to early and bogging down causing the shudder.

May 18, 2010 | 1997 Dodge Ram 3500 Club Cab

1 Answer

Transmission slips out of overdrive when driving on the highwayat high nspeed


you need a rebuild, your overdrive clutch is worn out. do not drive in overdrive until the trans is rebuilt.

Oct 23, 2009 | 2000 Dodge Ram 1500 Truck

1 Answer

I have a 92' dodge turbo diesel with an auto


Check your tps with a ohm meter and see if you are getting varable resistance if you do not repace it and it will shift.I hope this helps you?

Oct 03, 2009 | 1992 Dodge Ram 350

1 Answer

88 ram 4x4 auto put trans in and it wont shift


Sounds like you got a bad trans. Was it used? Does it have a warranty? Can you shift it with the linkage off? Is everything adjusted correctly?

Jul 29, 2009 | 1988 Dodge Ram Wagon

1 Answer

Overdrive Problem.


The throttle sensor on higher mileage vehicles has been know to cause this type concern. The voltage that the engine and trans controller sees starts to get erratic from the sensor and will kick out of OD.

Mar 21, 2009 | 1999 Dodge Durango

1 Answer

1991 dodge stealth with auto trans will not go into overdrive light on the dash cluster is working


i knew my 95 stealth overdrive was going bad i was driving in overdrive and the engine would rev up for a second hardly noticeable surging and it just stoped pulling i turned the button off and it will do fine in drive bottom line the piston seal in overdrive drum is bad rebuild it

Mar 06, 2009 | 1992 Dodge Stealth

1 Answer

1999 ram auto trans wont shift into park


you could need a throttle linkage adjustment. first check to see if your ram will start in "park" and "neutral" only. if it starts in any other gear=faulty neutral safety switch. replace. ok, now check linkage for proper adjustment...with engine off and in park...remove intake housing..disconnect cableend from attatchment stud on your throttle body..slide cable off the stud (carefully)..verify that the transmissionthrottle lever is fully forward (idle) position..and verify that the lever on the throttle body is at curb idle pos..insert small screwdriver under edge of the retaining clip and remove..center the cable end on attatchment stud to within 0.04", or 1mm. install retaining clip onto cable housing..check cable adjustment..be sure trans throttle lever and throttlr body lever move in sync with each other.

Jan 11, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...