Heater doesn't work in 1995 ford econoline van.

SOURCE: where is the fuel pump

the switch is located under passenger side foot trim panel under glove box. open passenger side door and remove the plastic cover .

SOURCE: 1995 ford econoline van speedo/trans

It is either the speed sensor, the wireing in between ot the speedometer module it self. The sensor sends pulse train signal to the speedometer module and there it drives the speedometer and is divided in frequency by about 7 and feed to the computer and the cruise control. When the signal drops the Engine management computer thinks the speed is real slow and raises the transmission pressure.

In the one I had it was a cold solder jooint on the bacjk of the speedometer module itself but this was the divided output and the speedometer itself still worked. The easyest part would be the sensor that mounts on the rear axile I believe and should cost less than 30.00 dollars. If not that thebn it's the wiring or the speedometer module electronics..

SOURCE: need to replace the heater core

Under the dash for sure, but you may need to drop the whole box and may be mounted with bolts from the engine compartment. You will need to disconnect the hoses from the core from under the hood

SOURCE: cant find fuel filter on 1988 foed econoline van

Follow the fuel line right up to the carb or throttle body. Sometimes it's a very small "metal can" looking thing that is on the carb end of the fuel line...surprisingly small...not like the bigger in-line filters found along the frame rails on other models. This small can-like filter screws into the carb and the line is attached to same. It's about the size of a quarter in diameter and an inch and a half long.

Marvin

• 85242 Answers
• Posted on Jun 19, 2009

SOURCE: where is the speed sensor on a 1995 Ford econoline van

the sensor is located on the driver side of the transmission case