Question about 2007 Chrysler Town & Country LX New Cars

2 Answers

Fuse of break lights pop when I turn lights on ,

Fuse of break lights pop when I turn lights on , and from the stop swuitch there are five wires purple/ yellow , purpple/whi. blk/orang,whi/tan,gray/red, all these wires get hot and burn fuse on 2002 town&country

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Chrysler Master
  • 3,433 Answers

And they are all harnessed to the turn signal control? You have a dead short in the turn, flash, brake system. Work each one seperately until you isoolate the shorted circuit. Do not use the brake. put in a new fuse and turn on the left turn, wait, If fuse didn't blow, turn on thethe right turn signal, wait, if the fuse didn't blow, turn on your 4 way flashers and wait. If fuse has not blown, get the wife and have her step on the brake while you watch the third brake light and the othe two. That you are watching for is one of the three being dimmer than the others. Here is a tip, Remove the brake light switch and operate it manuallt so you cand detect whether the swith is causing yor short or not.Ipping the fuse ampereage will create a serious fire condition, so do not exceed the original size fuse. Are you towing with this vehicle? If so, what are you towing?

Posted on Jul 20, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

  • Contributor
  • 4 Answers

Did you hook up trailer lights

Posted on Jul 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No break lights , replaced the break pedal switch , the tail light circuit boards and all bulbs , still no lights . and stop/haz fuse pops immediately when I youch the break ..... at a loss

You have a dead short and it could be any where from the front to the back of the car. It could be where a wire has a rubbed place in it or in the tail light assembly itself. According to what kind of vehicle it is it could be the multifunction switch. That is the most common cause

Nov 01, 2015 | Cars & Trucks

1 Answer

HELP!!!! Toyota paseo 93. When I got the used car the dash cluster lights/ tail lights/ lic plate light didn't work. I checked and changed the fuses in car/ under hood. I checked and changed the tail...

Those are your marker lights. They come on when you turn your lights on halfway. I would suspect your light switch was overheating and melted the harness behind it and shorted 2 wires.

Oct 15, 2013 | Cars & Trucks

1 Answer

2005 suburban , the trailer harness wiring behind the plug in has power for the break and right turn but has no power for riding lights or left turn ?

Find the LEFT INSTRUMENT PANEL FUSE BLOCK. At the TURN SIGNAL/FLASHER MODULE, a 10A fuse (A9?) protects the right trailer stop/turn circuit (DK GRN) which you say is OK. Back at the S/FM, a 10A fuse (A8?) protects the LEFT trailer stop/turn circuit (YEL). At the UNDER HOOD FUSE BLOCK, a 15A TRL PARK fuse (B6?) protects the running/parking lights (BRN).

Sep 04, 2012 | 2005 Chevrolet Suburban

1 Answer

Why does fuse # 25 keep blowing out on my Chrysler pacifica 2004

Fuses pop because it is breaking the direct line of voltage that is being selected...anotherwords...instead of when you turn on your radio and the incorrect amount of voltage that is being sent to the radio frys it, the fuse breaks/pops to stop the flow of voltage to the radio.

The problem seems to either be a bad relay or wires are touching somewhere in that system.

Nov 20, 2011 | 2004 Chrysler Pacifica

1 Answer

I have a 2004 jeep liberty my turning signal fuse keeps burning out, but my hazard lights work. Once my fuse burns out, I have no left or right turning signals.

a wire has to be shorting out the fuse, check all wires and make sure no metal is showing or frayed. If so wrap the wire that is showing with electrical tape to make sure no metal is touching any other wire, this would cause the short, and would pop the fuse. You may want to try a fuse with a higher breaking point as well, i.e. a 20 amp fuse.

May 05, 2011 | Jeep Liberty Cars & Trucks

3 Answers

Brake lights not working. Niether stop lamps or overhead brake light bar work. All other rear lights work. Fuses for both lights are OK.

The most common problem for this fix is a New Replacment Brake Light Switch. It is located and mounted to the brake pedal assembly.

Feb 22, 2011 | 2000 Chevrolet Blazer

2 Answers

Tail and dash lights went out... when I replace the fuse it immediatly breaks again...

Remove all of the rear lights and replace fuse. if ok, then replace each one and recheck after each one to see which one(s) are blowing the fuse. I suspect someone tapped the back of your car and one (or more) of your lights has pressure on the bulb fixture, causing this problem.

Oct 09, 2010 | Mazda Protege Cars & Trucks

1 Answer

No dash lights and no tail lights

Check for faulty wires at the fuse block, had one fall off from the block itself from the rear, or it could be a wire break somewhere along the way.

Stop Lights and Blinkers are independant fuse.

Tail lights are on there own fuse and could be a wire break in the rear or removing the bulb and using a metre check for signal at bulb socket where trouble is, Check for disolored connections, Green in color or simular, could be a bad connection which in turn is not letting the curent to other side, Causing a short and loss of power to all remaining lights in curcuit.

Sep 15, 2008 | 1999 Chrysler Town & Country

Not finding what you are looking for?
2007 Chrysler Town & Country LX New Cars Logo

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides