Question about 1996 Toyota T100

1 Answer

Rear axle leaking on left rearside , it's been a problem since 1999 ,toyota shop has changed seals every year ! Tim

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 43 Answers

On most toyotas and most vehicles in general there is usually a revised bearing and seal that sits differently on the axle to seal. You are only to do one switch, and after that you are to replace the axle. I would make sure that the next time you get it done you have the shop show you the axle and then housing to see if there is any pitting or roughness on either surface. Hope that helps fix the problem.

Posted on Jul 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just had axle oil leak, left front, had axle replaced, could this have been prevented or is it natural wear and tear?


Hi Dolores ! by replacing the axle shaft have you changed also the oil seal on the gear box or not? If not surely is the old oil seal and is leaking.

Feb 11, 2014 | 1999 Toyota Camry

1 Answer

Driver side axle leak


front or rear? axle.
movement where
in, out, left right , up or down,. or all?
its a 3D world post directions.

btw, most seals that leak are due to bad bearings allowing the shaft
to beat the seal to bloody death, fact. (Timken.com)
only 1 exception, but is not where you are.

Jan 21, 2014 | 2003 Toyota Celica

1 Answer

Fluid leak from left rear axle housing


This is caused by a leaking rear axle seal you will need to pull the left rear axle out and change the seal and check for a worn axle bearing, this requires the removal of the differential cover, pin and center block or posi spring and clutch pack (if so equipped) and spider gears and then the "C" clip that retains the axle into the gear carrier, u will need a tube of silicone to reseal the cover and a axle seal installer tool and about 2 hours of your time

Oct 28, 2010 | 2000 Ford Mustang

1 Answer

Left rear axle leaking - Dealer states $820 to fix due to many parts within the axle. Does this sound right?


fix same problem myself...these's' only 1 inner seal (differential output seal only-about 10$ each) that needs to be replace and new brake shoes (20$ part)..assumed u have rear drums and it leaked diff fluid on the brake shoes..but, i also replaced the brake cylinder (15$ part)-u have to disconnect brake cylinder to remove axle..look on internet for procedures..http://www.yotatech.com/f128/replacing-rear-axle-seals-3rd-gen-4runner-76339/..hope this helps..all dealers are ripoffs-worked at toyota for a year

Jul 31, 2010 | 1999 Toyota 4Runner

1 Answer

How do you remove an axle on the right rear of a 1999 explorer? it has a leaking wheel seal.


1. Drain diff if it has a plug.
2. Remove rear cover
3. Undo cross pin bolt and slide the cross pin out of the carrier
4. Push axle shaft in so you can remove the C clip
axle retainers
5. Slide axle out of housing.
6. Remove axle seal and then replace axle seal
7. Reverse steps

May 25, 2010 | 1999 Ford Explorer

1 Answer

Leaking seal left side rear; does bearing come off with axle or stay in housing and do you have to pull the differential cover and pull the pin to release axle?


Bearing stays in the housing but check it for wear...often the seal leaks because the bearing has too much play. Yes pin in diff needs to come out.

Mar 13, 2010 | 1999 Jeep Grand Cherokee

1 Answer

I have a leak from my rear axle seal. How do you


JACK up the truck and block other rear wheel both back and take hand brake off ,,remove rear wheel/brake drum/handbrake cable from rear brake/remove metal brake hose/remove rearbacking plate with all parts fitted to it ie brakeshous 4or5 bolts holding the rear axle in to housing and when all parts off then put on a IMPACK PULLER and remove complete backing plate with axle assy and take to the engineering shop to get it pressed off and a new bearing and seal assy pressed back on .
Then refit in reverse of removal and bleed the brakes and top up the rear axle of oil (EP90) apply h/brake take out blocks and lower jack and test drive .. BUT MAKE SURE THE BRAKES ARE 100%

Oct 14, 2009 | 2005 Ford F 350 Super Duty

2 Answers

I cant remove a rear axle seal to a 1999 honda passport


Axle bearing and seal are made together. It is pressed on axle.

Aug 18, 2009 | 1999 Honda Passport

1 Answer

Rear Axel Seal Leaking, How do I pull the axel to repair?


You will need to remove the differential rear cover,drain fluid, remove wheel, brake drum, (rotor) . Unbolt center diff. pin, carefully remove (don't loose shims) push axle in remove lock keeper, then slide out axle, replace seal, put some grease on it, slide axle in reverse all to install.

May 22, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Grease leak toyota 4runner 1996


You need to disconnect the rear wheel cylinder brake line and pull off the rear backing plate, via the 4 bolts that are visible after you remove the brake shoes. One the backing plate is loose, take it down, out of the way, and pull the axle shaft straight out. You will need several parts from a Toyota Dealer, and a machine shop to press off the old bearings and seals, and to press on the new bearings and seals. Go to the dealer & tell them your problem, we do this job once-twice a week; a common issue. The only seal that you can change yourself is the axle tube "outer" seal, you will see it when you pull out the shaft. But, this seal is not the cause of your leak. The inner seal on the shaft is worn. You will also need to replace the oily brake shoes, too. Hope this helps. A FIxYa rating would be appreciated.

Feb 26, 2009 | 1998 Toyota 4Runner

Not finding what you are looking for?
1996 Toyota T100 Logo

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...