SOURCE: I have 4.9L6 need torque specs for cylinder head
for cylinder head the torque is : step 1 55 ft-lb, step 2 65 ft-lb, step 3 85 ft-lb. Rocker arm stud nut or bolt is 17 to 23 ft-lb. and valve cover bolt 72 to 108 in-lb.
SOURCE: i need torque specs on 93 dodge 360 ..heads,
Cylinder Head Bolt 5.9L
Step 1 - 50 ftlb
Step 2 - 105 ftlb
Step 3 - Recheck At 105 ftlb
Tightening sequence
Rocker Arm Bolt
5.9L - 17 ftlb
SOURCE: TORQUE SPECS /HEAD GASKET/2001 CAVALIER...
for the 2.2L OHV:
(pully 8 4 1 5 9 <-- long bolts @ 63Nm (46ft/lb)
side ) 7 3 2 6 10 <-- short bolts / 10 is the stud @ 58Nm (43ft/lb)
for the 2.4l
dohc are as follows:
(pully 9 3 1 5 7
side) 10 6 2
4 8
bolts 1-8 torqued to 65Nm (40ft/lb)
bolts 9-10 torqued to
40Nm (30ft/lb)
then (either engine) give each an additional 90° (¼)
turn
it's best to do
the tightening in stages, you don't want to go completely tight on the
first pass or there will problems and you'll get to do it all over again
SOURCE: i need the engine torque specs for 99 chevy malibu
99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.
86 views
Usually answered in minutes!
×