Question about 1988 Mazda B2200

1 Answer

1989 mazda b2200 electrical problem

I was driving down the road when my truck lost all power and the engine shut off. The ignition won't turn over the car. the radio and heater will not come on, but the headlights and blinkers will. I checked the battery, the terminals, the battery wires and the fuses and they are all fine.

Posted by on

  • nicholasscar Jul 19, 2009

    would a wire cause the truck to stop dead in the middle of driving?

  • bill
    bill May 11, 2010

    Sounds like a wire. When the headlights and blinkers on hit the horn or turn on some other things and see if the voltage drops.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 103 Answers

Hi,I would check the fusible links at the battery positive terminal.They look like normal wires but can burn out and leave the insulation intact.Try to stretch them,you will find the dead one.

Posted on Jul 25, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i remove the steering wheel on a 1989 mazda b2200

Remove drivers knee panel then electrical plugs to steering column. Nest inside the engine bay remove the bolts from the universal joint. Last remove the two bolts holding the steering column to the dash frame.

Feb 14, 2015 | 1988 Mazda B2200

1 Answer

My 1990 b2200 mazda doesnt turn over after replacing ignition switch and fixing wiring to the entire engine

Before you pull the starter and have it bench tested put a 12v tester light on the starter leads, I am betting on the starter solenoid

Jun 07, 2014 | Mazda B2200 Cars & Trucks

1 Answer

Engine occasionally stalls while driving down the highway in my Mazda b2600i p/u like I turned the key off

problem can be electrical or fuel system,
first of all check the ignition key switch and its relative wire harness for loose connection.
it can be happen because of fuel injection failure ,then go to the mechanic and you can rectify the problem.

Jan 10, 2014 | 1989 Mazda B-Series

2 Answers

How do i reset check engine light on a 1989 mazda b2200

Disconnected the battery for 30mins and then connected again.

Mar 11, 2010 | 1988 Mazda B2200

2 Answers

1989 mazda b2200 can not set timing

i have a 1988 mazda b2200 and i was sittin still runnin and it was a lil low in water and i was just ab to take off when it cut off. it made steam *** out the hood. the thing is its gettin eletric to the plugs and its gettin gas and i even tried a lil eather and its turnin over it just want crank. do u have a idea wat it could b? im thinkin it jump timeing.

Feb 17, 2010 | 1988 Mazda B2200

1 Answer

While driving down the road 1994 protege just


Nov 04, 2009 | 1994 Mazda MX-3

1 Answer

Mazda Tribute 2002 engine cuts out randomly

I had a Mazda 626 with a similar problem, the car seemed to 'shut down' with no warning, even at highway speeds, as if I just turned the ignition key to 'Off'; After trying to fix it unsuccessfully by replacing several electrical parts, the problem was found to be a defective ignition switch, it was replaced and the problem went away.

Apr 29, 2009 | 2005 Mazda Tribute

1 Answer

1989 Mazda b2200 starts but won't stay running

My mazda b2200 starts and will stay running as long as the key is in the start position, but stops as soon as the key is turned from the start position

Feb 07, 2009 | 1989 Mazda 323

2 Answers

1990 mazda b2200 drive train

Is it standard shift??? if so, look under the truck and see if the drive shaft is turning. It could be the clutch, U-joint, or the rearend gone out.

Jan 31, 2009 | 1988 Mazda B2200

2 Answers

Vacuum hose routing diagram for 1989 mazda truck B2200

vacume hose routing is under the hood on a white lable.

Jan 01, 2009 | 1989 Mazda B-Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

570 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides