SOURCE: 2001 ford expedition spark plug location
That's because they are hidden quite well. If you look at the engine, you'll see yellow plastic prongs (?) that look like spark plugs, but hook up to the silver tubing. That's the fuel injectors. BUT, right behind the yellow plugs, are black ones. The black one is the connector to the spark plug. The plug itself sits about 4 inches down into the block of the engine. They are a real pain, and from what I can tell, you only have decent access to the first 2-4 of them, then they get too far back and start going under the dash (you'll see what I mean when you get there).
SOURCE: cannot unlock the steering wheel on oldsmobile intrigue 2001
is it the right key for that car? cause if not then that is the problem... if it is the right key, then you might have to replace the key cylinder cause you may have something broken in it...
SOURCE: Where are the spark plugs on my 2000 Oldsmobile
2000 Oldsmobile Intrigue V6-214 3.5L VIN H SFI
Spark Plug: Service and Repair
REMOVAL PROCEDURE
TOOLS REQUIRED
J 43094 Spark Plug Boot Puller
1. Turn OFF the ignition switch.
2. Remove the ignition coil assembly.
3. Use the J 43094 in order to remove the spark plug boots from the spark plugs.
NOTE: Allow the engine to cool before removing the spark plugs. Attempting to remove the spark plugs from a hot engine may cause the plug
threads to seize causing damage to cylinder head threads.
NOTE: Clean the spark plug recess area before removing the spark plug. Failure to do so could result in engine damage because of dirt or
foreign material entering the cylinder head, or by the contamination of the cylinder head threads. The contaminated threads may prevent the
proper seating of the new plug. Use a thread chaser to clean the threads of any contamination.
4. Remove the spark plugs from the engine.
INSTALLATION PROCEDURE
NOTE: Use only the spark plugs specified for use in the vehicle. Do not install spark plugs that are either hotter or colder than those specified for the
vehicle. Installing spark plugs of another type can severely damage the engine.
NOTE: Check the gap of all new and reconditioned spark plugs before installation. The pre-set gaps may have changed during handling. Use a round
feeler gage to ensure an accurate check. Installing the spark plugs with the wrong gap can cause poor engine performance and may even damage the
engine.
1. Measure the spark plug gap on the spark plugs to be installed. Compare the measurement to the gap specifications. Refer to Spark Plug Usage.
Correct as necessary.
NOTE: Be sure that the spark plug threads smoothly into the cylinder head and the spark plug is fully seated. Use a thread chaser, if necessary,
to clean threads in the cylinder head. Cross-threading or failing to fully seat the spark plug can cause overheating of the plug, exhaust blow-by, or
thread damage.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the spark plugs to the engine.
Tighten
Tighten the spark plug to 20 N.m (15 lb ft).
3. Install the spark plug boots to the ignition coil assembly.
4. Install the ignition coil assembly.
SOURCE: Would ignition coil problem cause 2001 Intrigue to misfire?
Not hard at all. Seven bolts and one connector. No computer work. But you need to know if it is the front coil or back coil. Front coil for cylinders 2, 4, 6. Rear for 1, 3, 5.
http://99intrigue.shutterfly.com/headgasket/97
780 views
Usually answered in minutes!
×