Question about Jeep Wrangler

1 Answer

2000 jeep wrangle engine light came on. code was

2000 jeep wrangle engine light came on. code was the bbtp throttle position sensor. Replace with 2 of them. engine light still on will not reset and the shifter light will not work. Still missing out ever so often

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

Check throttle body gasket

Posted on Jul 22, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Whst is code PO340


bad news
those is the main /cam sensor
if fail hard, engine stalls, no spark
which engine, 4.0liters?
wrangle TJ
chapter 21 (dtc pages)
cam single dead or dropping out 1 to 10 times
it does give early warnings. (can)
check wires to it.
chapter 8d
free fsm TJ
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service




26056188-04p1hebb2pwsjx0k1ddeezuh-1-0.jpg

Jan 16, 2016 | 1999 Jeep Grand Cherokee

1 Answer

Codes 32 75 12 22 on a check engine light


first code it's P0320 Possible causes
- Faulty Ignition/Distributor engine speed sensor
- Faulty Crankshaft Position sensor
- Ignition/Distributor engine speed sensor harness is open or shorted
- Ignition/Distributor engine speed sensor circuit poor electrical connection
- Low battery charge
- Faulty Engine Control Module (ECM)


Read more: http://engine-codes.com/p0320_ford.html#ixzz3DcwddSlp
2- P0750 Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty shift solenoid 1 valve
- Shift solenoid 1 valve harness or connectors
- Shift solenoid 1 valve circuit is open or shorted


Read more: http://engine-codes.com/p0750_ford.html#ixzz3DcwoXS73
3- P0120 Possible causes
- Faulty Throttle Position Sensor
- Throttle Position Sensor circuit is open or shorted
- Throttle Position Sensor poor electrical connection


Read more: http://engine-codes.com/p0120.html#ixzz3Dcx3VCPs
4- P0220 Possible causes
- Throttle Position Sensor (TPS) harness is open or shorted
- Throttle Position Sensor (TPS) circuit poor electrical connection
- Faulty Throttle Position Sensor (TPS)
- Fault Electric Throttle Control Actuator (or Throttle Body Motor)
- Accelerator Pedal Position Sensor (APP)


Read more: http://engine-codes.com/p0220.html#ixzz3DcxGUMl4

Sep 11, 2014 | 1991 Ford F150

1 Answer

Misfire on 2 and 5


Hi Paula,

You didn't mention if you changed the plug wires.

You mentioned replacing the camshaft sensor. Have you checked the Crankshaft Position Sensor? Or the Mass Air Flow Sensor (may need cleaning)? Or the Throttle Position Sensor?

Jan 11, 2014 | 2000 Jeep Cherokee

1 Answer

I have a 2005 jeep wrangle replace all four 02 sensor cant get check engine light to go off, how do i get check engin light off


disconnect negative terminal of battery for 5 minutes then reconect terminal. that should reset the check engine lite.

Jul 28, 2012 | 2006 Jeep Wrangler

2 Answers

2004 jeep grand cherokee laredo, po162, po123


162 is the O2 sensor and 123 is Throttle/Pedal Position Sensor/Switch "A" Circuit High

Jun 18, 2017 | 2000 Jeep Cherokee

1 Answer

2004 jeep grand cherokee laredo, po162, po123


P0123 is a TPS/Pedal Position Sensor A Circuit High Input code. P0162is an 02 Sensor Circuit Malfunctoin (Bank 2 Sensor 3) problem.

Jul 01, 2012 | 2000 Jeep Cherokee

1 Answer

How do you change the tps on a 2000 jeep grand 4.7


The exact placement of the throttle position sensor generally is located on the side of the throttle body below the air intake tube on top of the engine.

To replace simply remove the air intake duct (usually one plastic screw), locate the sensor, disconnect wire plug in, remove the two sensor mounting screws (torx screw variety, size not remembered) and the sensor will come off. When replacing be sure to line up the throttle shaft with the proper groove inside the sensor...it should just slip in there pretty easily with a little bit of wiggling. Reinstall doing the reverse of the above.

Take's about 5 - 10 min to replace from start to finish and remember to clean the throttle body before starting this job to ensure no dirt will enter the engine. Good luck, Merry Xmass

Dec 24, 2009 | 2000 Jeep Cherokee

1 Answer

Throttle Position Sensor??


Sensor is attached with two torx screws on the throttle body. it is easily removed and is non adjustable. Be sure you engage the throttle plate shaft properly before tightening it up if unsure what it looks like, buy the new one first..

Jun 13, 2009 | 2000 Jeep Cherokee

1 Answer

I have problem with code 1126 (toyota 4 runner 2001


Manufacturer Specific Codes

P1100
BARO Sensor Circuit - Read Our Article on Automotive Circuit Testing For Help With This Toyota Check Engine Light Code

P1120 Accelerator Pedal Position Sensor Circuit - Read Our Article on Automotive Circuit Testing For Help With This Toyota Check Engine Light Code

P1121 Accelerator Pedal Position Sensor Range/Performance Problem

P1125 Throttle Control Motor Circuit - Read Our Article on Automotive Circuit Testing For Help With This Toyota Check Engine Light Code

P1126 Magnetic Clutch Circuit

P1127 ETCS Actuator Power Source Circuit

P1128 Throttle Control Motor Lock

P1129 Electric Throttle Control System

P1130 Air/Fuel Sensor Circuit Range/Performance (Bank 1 Sensor 1) - Read Our Article On Oxygen Sensor Codes For Help With This Toyota Check Engine Light Code - More Related Information

P1133 Air/Fuel Sensor Circuit Response (Bank 1 Sensor 1) - Read Our Article On Oxygen Sensor Codes For Help With This Toyota Check Engine Light Code

P1135 Air/Fuel Sensor Heater Circuit Response (Bank 1 Sensor 1) - Read Our Article On Oxygen Sensor Codes For Help With This Toyota Check Engine Light Code - More Related Information

P1150 Air/Fuel Sensor Circuit Range/Performance (Bank 1 Sensor 2)

P1153 Air/Fuel Sensor Circuit Response (Bank 1 Sensor 2) - Read Our Article On Oxygen Sensor Codes For Help With This Toyota Check Engine Light Code

P1155 Air/Fuel Sensor Heater Circuit. (Bank 1 Sensor 2)

P1200 Fuel Pump Relay Circuit

P1300 Igniter Circuit Malfunction - No. 1

P1305 Igniter Circuit Malfunction - No. 2

P1335 No Crankshaft Position Sensor Signal - Engine Running

P1349 VVT System

P1400 Sub-Throttle Position Sensor

P1401 Sub-Throttle Position Sensor Range/Performance Problem

P1405 Turbo Pressure Sensor Circuit

P1406 Turbo Pressure Sensor Range/Performance Problem

P1410 EGR Valve Position Sensor Circuit Malfunction - Read Our Article on EGR Valve Codes For Help With This Toyota Check Engine Light Code

P1411 EGR Valve Position Sensor Circuit Range/Performance - Read Our Article on EGR Valve Codes For Help With This Toyota Check Engine Light Code

P1500 Starter Signal Circuit

P1510 Boost Pressure Control Circuit

P1511 Boost Pressure Low

P1512 Boost Pressure High

P1520 Stop Lamp Switch Signal Malfunction

P1565 Cruise Control Main Switch Circuit

P1600 ECM BATT Malfunction

P1605 Knock Control CPU

P1630 Traction Control System

P1633 ECM

P1652 Idle Air Control Valve Control Circuit

P1656 OCV Circuit

P1658 Wastegate Valve Control Circuit

P1661 EGR Circuit

P1662 EGR Bypass Valve Control Circuit

P1700 Vehicle Speed Sensor '2' Circuit Fault

P1705 Direct Clutch Speed Circuit Fault

P1765 Linear Shift Solenoid Circuit Fault

P1780 Park/Neutral Position Switch Malfunction (Only For A/T)

Back To Top Of Toyota Check Engine Light Codes Page

Mar 21, 2009 | 2002 Toyota 4Runner

1 Answer

Throttle Pedal Position Sensor Switch A


its just a sensor. you do not have to replace the entire throttle body.

Mar 16, 2009 | 2000 Jaguar S-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

338 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...