Question about 2004 Jeep Grand Cherokee

1 Answer

How do i take a rear rotor off 2004 jeep cherokee

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,776 Answers

Remove the caliper slide bolts and take the caliper loose and hang caliper with a wire to something. Don't let the weight of the caliper to be supported by the brake hose.

Next, remove and discard the O-ring securing the rotor to the axle studs, and remove the rotor. Hope this helped and good luck.

Posted on Jul 19, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 52 Answers

SOURCE: Rear Axle Seal Replacement

remove rear tires, then remove brake calipers and rotors, then remove the 4 nuts (each side) that hold the axle shafts to the axle tube (located around the axle tube behind the backing plate) then using a slide hammer pull the axle shafts out, next using a die grinder and an air hammer get he retainer collar and the bearing off (without damaging the axle shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then retainer on (all new parts) and using a press push them all the way back on. then is simple reassembly.

Posted on Apr 22, 2009

michigan man
  • 3533 Answers

SOURCE: i need to change the rear brake pads on a 2004 jeep cherokee

first put the car on jack stands secure the front tires so it does not roll second take the bolts out behind the caliper and once off you will be able to remove the old pads; keep one to use to press the cylinder back in using a "C" clamp so you can put the new ones on also remove a little of the brake fluid from the master cylinder before doing this so you do not damage the check valve and once everything is back together be sure to put brake fluid back in and pump the brakes before driving and if needed for additional information try www.autozone.com to see if your vehicle is listed

Posted on May 02, 2009

  • 52 Answers

SOURCE: replace rear brake light

Open up the hatch and look for the screws that hold the tail light assembly to the body. After removing them you can gently pull the whole tail light from the truck. You will seee the sockets that the bulbs are in and they twist like a bottle cap to get to the bulb. Just pull the bulb from the socket and reverse what you did to put it back together.

Posted on Aug 09, 2009

  • 116 Answers

SOURCE: open rear window 1997 jeep grand cherokee lorado 4wd

There is a button above the license plate you have to push up on it make sure the door locks are unlocked.

Posted on Oct 05, 2009

  • 161 Answers

SOURCE: how to replace rear brake pads on 2004 Jeep

take it to a mechanic....;) I have a 2003 jeep grand cherokee 4 wheel drive V8. there probably is not much difference between year models. frist thing remove the back tire you will see the caliper and rotor. check the rotor if it has deep groves on the front or back you will need to bring it in to have it turned or replaced if it is still smooth it should be ok. remove the caliper by taking the two bolts off the back of the caliper. using a pice of wire hang the caliper so it isn't dangling from the brake line. Now is the time to replace rotor if needed .Get a pair of vice grips crimp off the brake line so any trash in the caliper doesn't get into the brake system (if you let the contaminants get into the brake system it can cause costly repairs to the abs system). open up the bleeder valve most of the time close to where the brake line goes into the caliper and usually has a rubber cap. open bleeder valve, take a c-clamp place on inner brake pad and outside of caliper tighten until caliper is all of the way open close bleeder valve. replace brake pads put caliper back on recommend using lock tight on bolts holding caliper on snug fasteners but do not over tighten, lock tight will keep bolts from backing out. do the other side the same way. pull up emergency brake to and pump brake pedal to adjust brakes. bleed brakes and you are done

Posted on Nov 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Are the rear rotors the same as the front rotors


No. the rear has accommodations for the park brake. The front does not.

Jan 26, 2013 | 2004 Jeep Grand Cherokee

1 Answer

How do I release rear parking brake to replace rotor ? I already removed the caliber but can't get old rotor off.


Rotors are held in place by the wheel and caliper If both of those are removed it should come right off. In some cases it can get seized in place by the high heat of braking. A torch or puller may be required

Aug 23, 2011 | 2004 Jeep Grand Cherokee

1 Answer

2002 jeep grand cherekee rear axle seal removel do i need to remove c clips in rear to remove axle


No.....after removing the brake caliper and rotor, Unbolt the axle retainer plate from the axle tube flange. You need a slide hammer to pull the axle out.

Mar 19, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Can not remove rear rotor do i need to remove spindle nut?


There is no spindle nut on the rear drivetrain of a grand cherokee?

If the front or rear rotor is stuck on the hub than tap it with a hammer from the backside. It is likley rusted to the hub as this is pretty common on many makes and models.

Nov 07, 2010 | 2004 Jeep Grand Cherokee

1 Answer

How do the rear rear rotars come off a 2007 jeep grand cherokee 2wd


On Rear Disc Brake Rotor Assemblies there is e-brake components inside and may be stuck to the inside of the rotor, try turning the rotor and tap on the backside of the rotor with a hammer staying away from the backing plates, if you cant get the inner shoes to come loose from the inner rotor you may have to have a brake specialist free up the assembly.

Jul 14, 2009 | 2007 Jeep Grand Cherokee Overland

2 Answers

1996 Jeep- rear rotors won't come off?


It's Hammer Time! Give it a few cracks with the hammer because it's froze on.

Jul 04, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

355 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...